1
vote
4answers
94 views

Driving screws back into weathered deck

I have a 20+ year old deck behind my home. It's in great shape, but I want to refinish it this summer. Problem is, a number of the Phillips screws have popped up over the years. I have a basic Hitachi ...
3
votes
2answers
124 views

Should I be concerned about wearing out the clutch when driving screws with my drill/driver?

The clutch on a drill/driver is used to limit the amount of torque applied when driving screws. However, as the clutch is a mechanical part subject to wear especially when it slips, I'm concerned ...
1
vote
1answer
54 views

Problem Using Wall Anchors for Curtain Rod

I'm trying to hang curtains for a floor-to-ceiling window by using drywall anchors to hold up the curtain rod. However, the plastic screw gets stuck about halfway anywhere I attempt to drill. When I ...
1
vote
1answer
80 views

With self drilling screw should I use a drill or a driver?

I need to affix some sheet metal using self drilling screws like the ones below. I have drill/driver with variable torque. What should I use for drilling/driving that? At first I'm drilling, but later ...
2
votes
1answer
976 views

Can I use shorter screws to mount my blinds?

I've bought a pair of blinds that came with 1 1/4 inch screws; I'm unable to drill deep enough into the frame to fit the screws, the screws are sticking about 1/8 of a inch out . I end up hitting ...
9
votes
3answers
686 views

How can I drive a screw with an impact drill?

I bought a Bosch PSB 650 RE Impact Drill and I have some question about how to use it for driving screws. I know it's not its primary function but for a few screws here and there it should work. I ...
3
votes
4answers
2k views

How do I choose more durable screwdriver bits?

I recently bought a $35 cordless screwdriver that came in a suitcase with screwdriver bits. I was in shock when the Pozidriv bit splintered after screwing only 3 1-inch screws in the leg of an ...
3
votes
2answers
179 views

Possible to screw machine screw in wall?

Background I would like to build picture frames, where there on the back is a hole with 18mm in diameter and 7mm in depth. In the hole will I glue a 2mm metal plate. On the wall would I like to ...
1
vote
5answers
1k views

How can I use toggle bolts with limited depth behind them?

I have a predicament, I am putting up a shelf into the wall. The wall is plaster, and then hollow and then concrete. I have screws with toggle bolts on them. The 2 inch screw with the toggle bolt ...
2
votes
1answer
332 views

Will a drill bit that came with a dremel be good enought to drill out a screw?

I have a dremel, and I want to know if the drill bits that came with it are good enough to drill out a screw in my shower faucet. The shower faucet handel is broken and the screw is stuck in the ...
2
votes
1answer
168 views

Should I Buy Cordless Drill/Driver From USA And Use It In My Country?

I want to purchase DeWalt 18V Cordless Drill/Driver from USA where electricity standard is 120V - 60Hz and use it in my country with transformer where standard is 220V-230V - 50Hz but there will be ...
13
votes
11answers
22k views

What is the best technique for using a drill to insert screws?

It looks so easy on the DIY programs, but I battle to insert screws using my drill. The screwdriver bit keeps slipping out, and it damages the screw head. Is there a neat trick for this? Should I ...