Tagged Questions

2
votes
3answers
547 views

How do I remove a drill bit that is stuck due to an overtightened chuck?

I recently bought a Bosch PSB 500 RE power drill and already I kinda screwed up the machine. The chuck is keyless, consisting of two parts which I'll refer to as the head and the base. You would ...
4
votes
1answer
135 views

What units are the clutch settings on a drill?

I have tried looking around the internet for an answer - but I can only find articles that explain what the clutch on a drill does. I am very familiar not only with what they do but also with how ...
4
votes
3answers
207 views

Will neodymium magnets harm my power drill battery?

I glued some magnets onto my power drill battery to use for storing drill bits on - but will the magnets affect the battery life?
10
votes
3answers
182 views

Should I get a keyed chuck for cordless drill?

I am thinking of getting a Milwaukee M18 fuel drill/ driver combo. The drill is insane with 750in-lbf of torque. It comes with a hand tighten chuck though. My other Milwaukee corded screwdriver has ...
10
votes
5answers
544 views

When would one use an impact driver versus a regular drill?

Or vice-versa. As best as I can tell, the impact driver is very good for most any type of screw going through wood. When would you use a drill (with screw bit) instead?
10
votes
5answers
2k views

How to drill a hole in a space too small to fit a standard manual or electric drill?

I have a very narrow kitchen cupboard I'd like to make some changes to (add shelves maybe). Almost any change will require drilling holes though, and there's not enough room for a standard electric or ...
7
votes
1answer
958 views

What do the numbers on a cordless drill mean?

I have a Hitachi cordless drill: You can turn the gray numbered part to switch between, hammer drill, drill and screwdriver mode. The screwdriver mode is numbered up to 22. Can someone explain ...
5
votes
1answer
225 views

Should I lubricate the motor in my power drill?

I have a power drill that looks like the picture below. I've had it for years, but recently I noticed that it squeaks when I use it (I only really hear the squeaking while it's winding down, when it's ...
11
votes
2answers
625 views

What type of cordless tool battery chemistry should I purchase?

I'm about to buy a cordless tool set in which the tools all operate off the same form-factor battery. The batteries come in several different chemistries and I'm wondering which type is better for ...
11
votes
5answers
2k views

Is there a technique or tool for consistently placing drywall screws correctly?

Is there a special technique or tool for consistently placing drywall screws correctly? I'm using a standard Dewalt DWD115K (with no auto-stop mechanism) so I'm usually paranoid of going too deep ...