0
votes
2answers
130 views

Should I drill through the concrete garage wall to install a generator inlet switch inside?

I recently purchased a generator in the aftermath of the ice storms in the Northeast. I'm quit handy with the electrical wiring in my house and have no issue installing the proper circuit for the ...
1
vote
1answer
296 views

How can I drill through concrete blocks to allow drainage from my backyard?

My back yard has a brick floor and is surrounded by a concrete block wall. In heavy rains, the yard pools with rain water. How do I go about cutting drain holes in the wall or floor?
1
vote
2answers
328 views

How deep should I drill a pilot hole in concrete for a 2 inch screw?

For fixing a 2 inch screw on concrete wall, how should I drill for good strength and no damage to the wall. I tried a 2 inch screw and drilled for 1 1/2 inch and later tried to screw it into the hole. ...
2
votes
1answer
368 views

How can I mount a projector to a concrete ceiling?

I am in a dorm room and I am attempting to mount my projector and screen in my ceiling... As far as I can tell from just tapping the ceiling it is made of cinderblocks if that sounds right or ...
1
vote
3answers
644 views

Will this drill bit work on concrete?

I'm very new at drilling stuff and I have never drilled a hole in my life before. I need to drill through concrete (I don't know what kind of concrete it is), and I'm wondering if the following drill ...
1
vote
5answers
1k views

How can I use toggle bolts with limited depth behind them?

I have a predicament, I am putting up a shelf into the wall. The wall is plaster, and then hollow and then concrete. I have screws with toggle bolts on them. The 2 inch screw with the toggle bolt ...
6
votes
1answer
1k views

Drilling holes in concrete

I'm not what you'd call a handy guy, and now wife wants me to put up curtains. This task is reduced primarily to getting a bit of metal stuck to the ceiling. I bought screws and anchors. The anchors ...