Movable barriers at the entrance of buildings, rooms, cupboards, etc. which can be used to allow or deny access to the space beyond. Typically attached to surrounding structure using hinges, sliders, swivels, etc.

learn more… | top users | synonyms (1)

17
votes
4answers
10k views

How do I rehang a wooden door with worn screw holes?

I have a wood door in one of my rooms where the top screws no longer hold the hinge to the wall because the screw holes have worn loose. I have tried slightly larger screws and filling with wood ...
23
votes
10answers
29k views

Doors are sticky and noisy when opened?

For some reason, the doors in our house make a very loud "unsticking" sound when you open them. It's almost as if the paint isn't cured, since the sound seems to come from the contact area around the ...
26
votes
5answers
27k views

How do I drill a 2⅛ inch door knob hole over an existing 1½ inch hole?

I need to replace the door knob for this interior door: The door knobs I've found at the stores require a 2⅛ inch hole. Mine is only 1½: Did door knobs used to be smaller? Is there some place ...
11
votes
3answers
33k views

How do I fix a door frame that my dog chewed?

My dog chewed the bottom part of the doorframe to my bedroom. I live in a rented apartment, so this is not OK. Is there any way to fix it and make it look somewhat presentable (doesn't have to be ...
4
votes
3answers
8k views

How do I install a pre-hung door in a rough opening that's too wide?

I'm replacing an interior door -- including the original jamb -- in my house with a new 30" pre-hung door. With the jambs, the new door is 31 3/8" wide. However, the original rough opening is ...
8
votes
3answers
16k views

How can I fix a door that doesn't close because it doesn't fit the frame?

Two closet doors in my house won't close all the way. When they are about 85% closed, it stops because the top of the door is rubbing up against the frames. It looks like I need to move the door down ...
18
votes
7answers
120k views

How do you determine if a door is Right Handed (RH) or Left Handed (LH)?

I am replacing a few interior doors and I need to know if the existing door is Right Handed or Left Handed so I have them drilled correctly. Sounds like the acronyms for this are RH and LH. This ...
2
votes
1answer
373 views

What is causing discoloration on my bronze-finished lockset?

We bought a bronze finished lockset about five years ago, and now a lot of it is ashy looking and green in some places. It looks a little worse every year. It's on an exterior door facing west. ...
0
votes
2answers
76 views

How can I reduce outside noise inside my apartment?

I would like to reduce the outside noise from inside my apartment. Outside, of my apartment is the hallway, and it can get noisy. I was thinking about placing felt pads on my door to reduce the ...
12
votes
5answers
10k views

How do I adjust a door so it doesn't swing on its own?

I have a normal door, and left to its own devices it will simply rest about 20-30 degrees. It won't swing shut on its own, nor stay open on its own. It hangs a bit in the middle. Convenient enough to ...
14
votes
7answers
4k views

Lubricant for squeaky doors

I'm looking for a long term solution to my squeaky doors. Our home is fitted with brass hinges on all doors and lately they have all been starting to squeak. I've tried several silicone based ...
8
votes
3answers
717 views

How do I remove hard soap scum on my shower door?

I have a problem with regards to my frameless glass shower door because I don't usually clean it regularly. What happens is that the lower edge of the glass door is already very cloudy and is very ...
9
votes
1answer
6k views

How can I fix a hairline crack in a thin wood panel of an exterior door?

My 100-year-old house has a wooden front door made of thick wood ribs interspersed with 8 wood panels, each about 10" high, 8" wide, but only 1/8" or 3/16" thick. Perhaps the door originally had ...
8
votes
3answers
6k views

How do I shift a door's latch hole and strike plate up or down half an inch?

I have a few interior doors that do not latch closed because the bolting mechanism and latch hole are vertically misaligned. If I remove the strike plate I can extend the size of the latch hole, but ...
3
votes
2answers
3k views

What primer and paint should I used for a solid-core wooden front door?

I recently purchased a new pre-hung exterior door for my house. We opted for a solid-core Douglas Fir instead of the fiberglass models as the wooden door was substantially cheaper. We want to paint ...
2
votes
2answers
595 views

Fixing vintage glass doorknobs with loose glass to brass connection

I have a number of 1930's glass doorknobs which are loose, not at the set screw, but between the glass knob and the brass holder. Nearly every knob in the entire house has the same problem. They all ...
6
votes
3answers
7k views

How do I lubricate plastic rollers for sliding closet doors?

I just installed some new sliding closet doors, but unfortunately they're a bit squeaky/noisy when operating. They are "Reliabilt" doors from Lowes, the actual company that makes these is SGA. There's ...
5
votes
5answers
316 views

What can I do about pocket doors that are blocked by floor tiles?

I have double pocket doors in my den that I never close. I was going to clean them today, and when I tried to close them they would not close because of the tile being to high. I had the tile put in ...
5
votes
2answers
4k views

How can I fit a door in a frame that is too small?

I bought some used French doors to replace a sliding door. The sliding door measured 96" X 60". The French doors measure 96" X 60¼". I made the mistake of not measuring both doors. I just ...
4
votes
2answers
4k views

How can double swinging closet doors be installed?

I have a coat closet that long ago had double sliding doors and now has no doors at all. I would like it to have double swinging doors, like french doors but without glass. I found a couple of ...
4
votes
3answers
1k views

Door jamb on a 2.5" thick wall

What approach can be used to fabricate and install a door jamb on a 2.5" thick wall? The wall is composed of 2x4 on side (1.5") and two sheets of 1/2" drywall. Edit: I have an old 5 panel door that ...
4
votes
1answer
2k views

What are some inexpensive options for replacing a single-stall garage door?

The house we recently purchased has a detached 3 1/2 car garage that has seen better days. The entrances to the garage door consist of a 2-stall garage door, and a 1-stall garage door. Luckily, the ...
3
votes
1answer
119 views

What causes seasonal doors and how do you prevent it?

I understand that wood expands and contracts based on temperature, humidity, and other factors... However in our house the doors are really subject to seasonal changes. For instance my bedroom door ...
3
votes
1answer
1k views

How do I install a pre-hung door in a thick exterior wall?

I live in an old DC rowhouse; it was built in 1908. I'd like to replace the house's two slab-hung exterior doors with newer pre-hung models with full-length lites to increase the natural light and to ...
3
votes
4answers
878 views

What are Automatic Garage Door Options for a Garage with a Low Ceiling Clearance?

I have a tuck under single car garage in my bungalow that currently has carriage doors that have seen better days. I would like to replace the carriage doors with an automatic (and insulated) door, ...
2
votes
2answers
95 views

Quiet door latch

I have a bathroom door that is quite loud when operated. And when someone goes to the bathroom at night, it innevatibly wakes someone up (and baby room is just across from the bathroom!) there are 3 ...
2
votes
4answers
2k views

How to drill a hole in the wood without an electric drill?

During a travel in Laos, I need to drill some holes into a double-door's wood to install a locker. The wood is rather hard, and I don't have an electric drill (and can't find it). I only have 2 small ...
1
vote
3answers
5k views

How can I keep my doors from expanding in the heat?

During the summer months, some of the doors in my house become difficult to open and close. I can get them to shut by either slamming the door or by pulling upwards on the doorknob before opening or ...
1
vote
1answer
368 views

Consistent way to sand and repaint doors?

I have several closet and bedroom doors that are currently varnished/stained, which I want to sand down and paint a semi-gloss white. Should I do something other than sanding to remove the varnish, ...
0
votes
2answers
37 views

What do I do with a 1 11/16" gap when installing a new pre-hung door?

I am replacing a door with a pre-hung door including the jamb. The old door was 29 11/16" wide. The new pre-hung door is 28". Is this too big of a gap? Should I make it plumb on one side and make up ...