Movable barriers at the entrance of buildings, rooms, cupboards, etc. which can be used to allow or deny access to the space beyond. Typically attached to surrounding structure using hinges, sliders, swivels, etc.

learn more… | top users | synonyms (1)

5
votes
2answers
489 views

Why doesn't my door close properly after an earthquake?

After the earthquake I noticed our back door has gotten really hard to close. You have to slam it and give it a booty bump in order to get it shut. To open it, I have to use all my weight to yank it ...
3
votes
5answers
4k views

How can I block or fill out a letterbox hole in my door?

I have a letterbox in my front door that is never used, so I would like to remove it and fill the hole, preferably so it doesn't look like there was ever one there. Or insert something that fills the ...
2
votes
1answer
389 views

What is causing discoloration on my bronze-finished lockset?

We bought a bronze finished lockset about five years ago, and now a lot of it is ashy looking and green in some places. It looks a little worse every year. It's on an exterior door facing west. ...
4
votes
1answer
918 views

How can I repair a door that a dog chewed on?

My dog is an escape artist and managed to get out of her crate today. She then tried to chew her way through my bedroom door to escape confinement. Though unsuccessful, she did damage a significant ...
2
votes
2answers
1k views

Where can I get a new key for an old lock?

There are two locks on my apartment door. The key to the bottom lock was lost long ago - before I moved in - and we now just use the top lock. The bottom lock is probably 50-60 years old and ...
4
votes
1answer
945 views

What do I need to do to restore a wooden entry door?

I'm going to give it a try rather then buying a new door. I have a wooden door (veneer on both sides) with some decorative mouldings. My plan is to use a heat gun to get as much paint off as possible ...
2
votes
1answer
412 views

Which side of door should I install a threshold draft excluder?

I purchased this door bottom, MD Building Products 3 ft. x 1-3/4 in. x 1-5/8 in. Vinyl Door-Bottom Moulding, and the directions are straight forward except they don't indicate which side of the door ...
30
votes
14answers
9k views

How do I ensure the bathroom door stays open unless someone is inside?

When my windows are open, the wind can slam the bathroom door shut. I don't want this to happen when my cat is in the doorway (dead cat), or inside the bathroom with no one home (locked in with ...
4
votes
1answer
309 views

Installing a new exterior door into a taller existing opening

We are remodeling our 1948 home, and the previous owner was quite tall. We are trying to replace our exterior door, and have come across a wonderful deal on a door. Here is the issue: How can I make ...
2
votes
5answers
5k views

Remove plastic film from the outside of a metal door?

I forgot to remove the plastic protective film from the outside of a metal door. The door is white prime/painted. I was able to remove the film from the inside of the door, but the outside is baked on ...
5
votes
1answer
2k views

What to know before installing cabinet and drawer dampers?

I want to install dampers on my new cabinet doors in my kitchen. When the contractor gave me the price to add these, the cost was over $30 per door. So I decided not to install them. But since then, I ...
3
votes
1answer
672 views

When will drilling through wall members affect structural integrity?

When can you freely drill medium to large sized holes in studs or door jambs, and when do you need to be concerned about damaging the structural integrity of the structure?
4
votes
3answers
14k views

How to stop a door from banging while closing

Besides closing it very slowly, any good tricks / gadgets that will slow down the door so it doesn't close with a thud?
2
votes
4answers
14k views

How to remove a stuck key?

A hypothetical question - if I get a key in the door lock from one side of the door, could I somehow use another key to open the door from the other side? And what if you could "engineer" the stuck ...
2
votes
1answer
6k views

Wood knots showing through gloss paint on knotty pine doors despite applying knotting solution prior to painting

I painted some knotty pine doors about 3 years ago but (despite applying knotting solution) knots are showing through on nearly all of them! I followed the instructions on the bottle of the knotting ...
5
votes
5answers
2k views

Home wireless lock

How can I improve my home with a kind of front door lock that would act like those car that can unlock when it receive signal of the key in your pant? My goal would be to keep my keys in my pant ...
4
votes
2answers
802 views

How can I locate the doorbell transformer?

my doorbell stopped working and I tested it with a multimeter and found no current to the box. How do I locate the transformer to replace it?
4
votes
1answer
181 views

Refastening a cabinet door

A cabinet door in my kitchen detached from the cabinet- the screws are about 1/2" long and weren't enough to hold the door in place. The screws are short to keep them from poking out the back side of ...
5
votes
2answers
4k views

How can I fit a door in a frame that is too small?

I bought some used French doors to replace a sliding door. The sliding door measured 96" X 60". The French doors measure 96" X 60¼". I made the mistake of not measuring both doors. I just ...
4
votes
3answers
1k views

Door jamb on a 2.5" thick wall

What approach can be used to fabricate and install a door jamb on a 2.5" thick wall? The wall is composed of 2x4 on side (1.5") and two sheets of 1/2" drywall. Edit: I have an old 5 panel door that ...
1
vote
3answers
6k views

How can I keep my doors from expanding in the heat?

During the summer months, some of the doors in my house become difficult to open and close. I can get them to shut by either slamming the door or by pulling upwards on the doorknob before opening or ...
6
votes
5answers
4k views

Do I need a wood hardener for worn door hinge screw holes?

My house had a door removed by previous owners. The recesses in the jambs for hinges and catch were filled in with pieces of board (I don't know exactly what, but not solid timber), and painted over. ...
6
votes
1answer
179 views

Selecting a sliding patio door

I live in the Boulder Colorado area where we have hot intense sunny summer days, and below zero freezing winter nights. We are planning to install a sliding patio door in a south facing full sun area. ...
3
votes
1answer
387 views

How do I take door hinges that have a pivot ending with two flat cylinders apart?

I found a door with a pair of hinges that look like most ordinary door hinges but don't let the door to be taken off the doorpost. They seem to have a pivot that passes through the whole height of a ...
3
votes
6answers
12k views

Why does my latch not retract when I push or swing the door shut, but will retract when the knob/lever is used?

This just started today. I have to turn the knob in order for the latch to retract. Before, I could just push to door shut and the latch would retract when it hit the plate on the door frame. But now ...
1
vote
2answers
2k views

How should I prepare a steel door for painting?

I have two typical steel entry doors that were factory primed. They were installed 8 years ago in a new addition on my home. I am finally (!?) getting ready to paint them. The interior finish paint ...
4
votes
3answers
452 views

Repairing a hole in a door

I now have a wonderful hole in a bathroom door, as a result of door-stop not being installed in the proper place, and the door being shoved up against a towel rail (picture attached). As can be seen, ...
7
votes
1answer
496 views

Can I replace / recreate a tri-fold garage door with three fiberglass flush doors?

My garage has three wooden doors that cover the opening. The middle one's hinges are attached to the right door. The left and the right doors' hinges are attached to the walls. This way you could ...
17
votes
4answers
12k views

How do I rehang a wooden door with worn screw holes?

I have a wood door in one of my rooms where the top screws no longer hold the hinge to the wall because the screw holes have worn loose. I have tried slightly larger screws and filling with wood ...
1
vote
1answer
625 views

Exterior entry door repair

I have a 20 year old flat wood entry door (without mouldings or embellishment). I was going to sand and paint it, but when I sanded, I realized that the wood must have been just a veneer (plywood, ...
0
votes
1answer
1k views

Protecting a finished wood exterior door

I have a solid wood exterior door, that I had stained and finished by the maker. I was looking for a way to prolong and protect the finish. I thought about waxing the door (especially the exterior ...
2
votes
1answer
392 views

what parameters should I look for when choosing an electric deadbolt?

I am looking for electric deadbolts for external steel doors - to place several of them on a door - one on each side (top, bottom, left, right) for extra security. I want to buy just the deadbolt ...
1
vote
1answer
67 views

Shopping for French Doors

I currently have a sliding door that is 60X96. I want to replace it with french doors. I'm looking at DIY and am wondering whether to go used or new. I was hoping to stay at 500 or less, which ...
1
vote
2answers
583 views

Tips for removing drywall from bottom of closet header

So about two years ago, I added a header to make my closets standard height, instead of being full 8' doors (which, even without doors, made the rooms look much more modern). Unfortunately, I made a ...
3
votes
4answers
912 views

What are Automatic Garage Door Options for a Garage with a Low Ceiling Clearance?

I have a tuck under single car garage in my bungalow that currently has carriage doors that have seen better days. I would like to replace the carriage doors with an automatic (and insulated) door, ...
1
vote
1answer
212 views

Using screws to install a set of french doors?

I am installing a set of french doors. I have installed many doors before, but I was curious as to whether or not anyone has tried using countersunk screws to install the door? If I needed to adjust ...
1
vote
1answer
115 views

Indoor sliding doors now stick at the top after replacing rollers

I have sliding doors for a wardrobe, and i replaced the roller-wheels. Now they stick at the top, its as if they are too close together. I replaced the wheels in the same spot on the door, but they ...
3
votes
1answer
3k views

How can I fix an exterior door that is hard to close?

when I try to close the laundry door it ovelaps the jamb on the handle side. I can only close it by banging it hard against the jamb. The gap at the top of the door increases as it gets closer to the ...
0
votes
1answer
287 views

Can I replace a shower door that has one edge joining with another glass pane?

I had a shower door that wouldn't close anymore and the hinges were generally rotting and it was falling apart. The original construction was shoddy. The shower consists of a door with one edge of ...
4
votes
1answer
4k views

What are some tips for fixing gaps between door and jamb in an exterior door?

I have an exterior door that was apparently installed by unskilled monkeys. The gap between the jamb and door when it is closed goes from close to normal (1/4") at the top to large enough to see ...
11
votes
7answers
893 views

How do I clean stainless steel?

We have just finished building a house and we have some small stains on a stainless steel door handle. I was wondering what was the best way to remove them? Unfortunately I'm not sure what's caused ...
6
votes
3answers
8k views

How do I lubricate plastic rollers for sliding closet doors?

I just installed some new sliding closet doors, but unfortunately they're a bit squeaky/noisy when operating. They are "Reliabilt" doors from Lowes, the actual company that makes these is SGA. There's ...
2
votes
1answer
2k views

Where can I find a replacement for this 3.5" door knob spindle?

I broke the spindle on my ~100 year old door, and I'd like to just replace the spindle instead of the entire door knob assembly as this seems to be the original piece. Unfortunately I've been unable ...
3
votes
2answers
4k views

What primer and paint should I used for a solid-core wooden front door?

I recently purchased a new pre-hung exterior door for my house. We opted for a solid-core Douglas Fir instead of the fiberglass models as the wooden door was substantially cheaper. We want to paint ...
3
votes
2answers
599 views

Doorbell became very soft, battery replacement only necessary?

My doorbell ("speaker" portion pictured above) got very soft today. It still chimes, but just barely. I'm guessing it's battery-operated and the batteries are weak, but how can I tell for ...
4
votes
2answers
1k views

How do I prepare the trim and casing around a new door for paint?

I just installed a new exterior door. I put the original, painted interior-side casing back on, but to make it line up properly I put some new, unpainted 1/4" trim strips (not sure what they're ...
3
votes
2answers
256 views

Rip old door in half?

I've got a 26.5"x79" rough opening for a storage space under my staircase. I'd like to install a double door where each door is about a foot wide an hinges out. A ball latch in the top casing could ...
1
vote
2answers
664 views

How do you remove a dummy knob with a screw that seems to spin and spin?

I recently purchased my first home and wanted to replace all of the door knobs to make it feel more like my place, rather than just some place I was renting again. Anyway, all of the privacy locking ...
3
votes
1answer
216 views

Tips for measuring a front door opening?

I'm getting ready to replace my front door with a brand new pre-hung door and have some questions regarding collecting measurements. Where exactly should I measure? I've heard people use the phrase ...
12
votes
4answers
36k views

How do I fix a door frame that my dog chewed?

My dog chewed the bottom part of the doorframe to my bedroom. I live in a rented apartment, so this is not OK. Is there any way to fix it and make it look somewhat presentable (doesn't have to be ...