Movable barriers at the entrance of buildings, rooms, cupboards, etc. which can be used to allow or deny access to the space beyond. Typically attached to surrounding structure using hinges, sliders, swivels, etc.

learn more… | top users | synonyms (1)

3
votes
1answer
257 views

Tips for measuring a front door opening?

I'm getting ready to replace my front door with a brand new pre-hung door and have some questions regarding collecting measurements. Where exactly should I measure? I've heard people use the phrase ...
3
votes
4answers
2k views

How to repaint a metal door and keep the paint from scratching off?

I need to paint an exterior door that not only is metal, but has a small amount of rust on the outer edges. The door is used quite often and takes a lot of wear and tear. The past paint jobs have not ...
3
votes
2answers
1k views

How do I move a door hinge out 1/8“ (door is too tight to the stop molding, makes ”paint popping" noise)?

In an older home, due to layers of paint, I have several doors that close too tight to the stop molding. If left closed the paint binds up and "pops" (it must be left closed for two or three hours ...
3
votes
2answers
2k views

How should I mount a sliding closet door track?

I'm looking for input on my intended plan of action. I'm drywalling a room, closet included. The closet track is to be mounted on a crossbeam running the width of the closet. The crossbeam is ...
3
votes
1answer
2k views

How do I install a pre-hung door in a thick exterior wall?

I live in an old DC rowhouse; it was built in 1908. I'd like to replace the house's two slab-hung exterior doors with newer pre-hung models with full-length lites to increase the natural light and to ...
3
votes
1answer
7k views

How do I replace mortise locks with bored cylindrical locks?

I purchased an older home that has mortise locks in all of the doors. They're all very difficult to use and some of them don't work at all, making the doors difficult to impossible to close. Since I'm ...
3
votes
1answer
101 views

Fill groove in MDF door

I'm painting some MDF doors, and noticed that someone appears to have run a stanley knife over one of them, perhaps whilst removing them from their packing. I've sanded the area back as much as I ...
3
votes
5answers
64 views

Garage Door stops and returns to original position

Lately my garage door has been stopping when it gets about 2ft from the closed position and then returns to the original position. Nothing is blocking the sensors and the tracks don't seem to have ...
3
votes
1answer
236 views

What type of header is needed for a door opening in load bearing concrete wall?

I have a walkout basement with a covered front porch 4'x 9', so the space under the porch is surrounded with concrete 9" walls. I want to cut a door in the basement in the concrete wall, empty the ...
3
votes
1answer
3k views

At what height should a door knob be?

I'm installing a few new doors, and bought slab doors to save some money. I have a jig for boring the door knob holes, but I'm not sure where on the door to put the hole. Is there a standard height ...
3
votes
1answer
3k views

How can I install these pre-hung doors?

OK so I got about 20 interior prehung 6-panel doors with trim from Lowe's for $50 a piece. I was buying a lot of stuff they wanted to get rid of. Now putting up 8 news doors in a house. All of the ...
3
votes
1answer
3k views

Is there a mechanism to prevent a door from closing violently?

The door is heavy and people usually put a lot of force to close it, resulting in a violent shock, and the noise that comes with it. Is there a way to prevent the shock, without having a door that is ...
3
votes
5answers
7k views

How can I block or fill out a letterbox hole in my door?

I have a letterbox in my front door that is never used, so I would like to remove it and fill the hole, preferably so it doesn't look like there was ever one there. Or insert something that fills the ...
3
votes
5answers
12k views

Remove plastic film from the outside of a metal door?

I forgot to remove the plastic protective film from the outside of a metal door. The door is white prime/painted. I was able to remove the film from the inside of the door, but the outside is baked on ...
3
votes
2answers
388 views

Rip old door in half?

I've got a 26.5"x79" rough opening for a storage space under my staircase. I'd like to install a double door where each door is about a foot wide an hinges out. A ball latch in the top casing could ...
3
votes
2answers
118 views

Adding sidelights to a front entrance that does not have them

I am trying to determine the cost, effort and complexity of adding sidelights to an entrance way that currently does not have them. Would the entire front door way need to be re-framed, header, ...
3
votes
2answers
288 views

How do I hang a new wooden gate so that it automatically stays closed when it is shut but also stays open at its maximum open span?

I am building and hanging a new wooden double gate. How do I construct and/or balance the gate so that when I open it completely, which is at 90 degrees, it will stay open but also when I close it, ...
3
votes
2answers
571 views

Best way to cover bedroom doorway that has no door?

I have recently moved to a new 'two room' apartment which I guess was formerly a one room apartment that was that was split in two by a wall whose stability I cannot really vouch for. The main ...
3
votes
2answers
7k views

Quiet door latch

I have a bathroom door that is quite loud when operated. And when someone goes to the bathroom at night, it innevatibly wakes someone up (and baby room is just across from the bathroom!) there are 3 ...
3
votes
2answers
4k views

How to frame a door in a passageway?

I'd like to add a door into the entrance of a passageway which leads into the bedrooms. The entrance dimensions are 87 1/4 X 39 3/4 and is drywall. it seems the standard door widths are 36 X 80, so it ...
3
votes
1answer
538 views

Preventing a door from slowly opening itself [duplicate]

This is pretty simple but I don't know how to describe it. There's a door that if left open half way it opens all the way by itself. I'm not sure if it's on an angle and gravity is doing it. How do I ...
3
votes
1answer
184 views

What causes seasonal doors and how do you prevent it?

I understand that wood expands and contracts based on temperature, humidity, and other factors... However in our house the doors are really subject to seasonal changes. For instance my bedroom door ...
3
votes
2answers
238 views

How can I have a light turn on when a pocket door is opened?

I'm building a new home with quite a few pocket doors and would like to know if there is a way for the pantry and utility room lights to come on when the pocket door slides open.
3
votes
3answers
963 views

What can we do about previously filled holes so I can varnish wood?

We have bought a house that has nice wooden doors, but holes in them have been filled ready for painting. We would prefer to varnish the wood - what can we do about the white filling in the holes?
3
votes
1answer
5k views

What are the pros/cons of installing floors before doors?

I've heard contractors say to install doors first then flooring, and others suggest the opposite. I'm installing new 3/4" prefinished flooring and new doors/closets (prehung wood/ primed white). What ...
3
votes
1answer
5k views

How can I fix an exterior door that is hard to close?

when I try to close the laundry door it ovelaps the jamb on the handle side. I can only close it by banging it hard against the jamb. The gap at the top of the door increases as it gets closer to the ...
3
votes
1answer
105 views

Changing the window in an exterior door

We were given a new fibreglass door but it is RH instead of LH. How do we change the window so it will be facing the right direction?
3
votes
3answers
178 views

Door jamb wider than wall

I wanted to run electric into my mudroom for a ceiling light and a exterior light. Unfortunately the walls were all painted wood paneling so while doing that I figured I would switch to drywall ...
3
votes
3answers
121 views

Enlarging a deadbolt door knob hole on a steel door

I have a steel door in which I'd like to replace the deadbolt lock with a newer keypad type lock. The door is a bit older and the hole is 1 1/2 inches. The keypad deadbolt requires a 2 1/8 inch ...
3
votes
1answer
208 views

How do I vent metal doors?

I need to vent our metal utility closet doors. 1 3/4 inch thick metal doors. Need to supply ventilation so the heat exchange water heaters will work more efficiently. Now the closets become freezing ...
3
votes
1answer
557 views

How to Replace Exterior Door & Casing in Old House

My house is about 100 years old. The door jamb is about 10" wide. I've replaced a few doors before, but all of them had standard jams. I'm not sure how to go about replacing this. I'm assuming I need ...
3
votes
2answers
15k views

How do I fix interior and exterior doors that do not close properly?

I have a couple doors in my house that are having problems. I know that I likely have foundation problems, but I can't afford the $6000 - $10000 to have that fixed at the moment. I need an interim ...
3
votes
1answer
355 views

Should door jamb be lifted off subfloor or touching?

Simple question: when installing a custom made door jamb, should it be sitting directly on top of the subfloor or be lifted up a little (like drywall is lifted 1/2", for example)?
3
votes
1answer
273 views

Can I convert a basement window to a door?

We have a poured concrete basement, serving as the foundation of our home, which was built in 2008 in central Minnesota. The basement has 3 vinyl windows, the sills of which are around 1' above ...
3
votes
1answer
37k views

Troubleshooting a leaking exterior door

I have an exterior door that leaks water into the house when rain is blown against it. The floor on the inside of the house is unfinished, meaning it is just the raw subfloor. I don't want to put the ...
3
votes
1answer
1k views

My door doesn't close without having to push it upwards first [duplicate]

Possible Duplicate: How do I rehang a wooden door with worn screw holes? I just moved into this room and the door wasn't closing properly, so I took the door off, screwed the hinges in ...
3
votes
2answers
2k views

Can't remove Schlage knob

I live in a 60 year old house with several old Schlage door knobs as in this photo: There is a small hole in the collar and two smaller holes on each knob. Pushing small sharp objects in the hole ...
3
votes
1answer
1k views

How to fit a new door in a narrower frame?

I would like to replace a door which has non standard dimensions. The door itself is old, 8 cm wider and 5 cm taller than current doors. It is also very expensive to order a new door for these ...
3
votes
1answer
1k views

How do I seal around a door to make the opening more sound-proof?

I live in an apartment condo. The noise from the very loud neighbour comes through the door spaces. I wish to seal off all of her noise. My walls are brick and are good. But the door going out to ...
3
votes
2answers
1k views

How can I replace the roller mechanism on this door?

I have a cupboard in my kitchen that has a roller front door. A few months ago the roller mechanism broke. I need an inexpensive solution for replacing it. I have looked around but can't find a ...
3
votes
2answers
17k views

How to fix stuck pocket doors?

I moved into a house with a number of sliding doors. NOT external, sliding glass doors like the sort that lead onto a porch. These are the wooden kind that separate rooms and slide into the interior ...
3
votes
2answers
1k views

How do I protect paint on a steel outer door from scratching?

I need to attach a plastic guard onto an outer steel door, to protect the paint from scratching by my dog (and visiting dogs...this is a rural setting). Is there a glue that is clear that I can use? ...
3
votes
1answer
236 views

Pocket door variation

Remodeling the bathroom. I want to put in a pocket door, centered, in a 60" opening. Is there a split door product available, that will work similar in principle to draw drapes? To put the door in ...
3
votes
1answer
732 views

How can I fit patio French doors in a frame that is too small?

My question is very similar to "How can I fit a door in a frame that is too small?" except my house is made of concrete block. I bought a used patio French door to replace my sliding door. The ...
3
votes
1answer
588 views

How do I take door hinges that have a pivot ending with two flat cylinders apart?

I found a door with a pair of hinges that look like most ordinary door hinges but don't let the door to be taken off the doorpost. They seem to have a pivot that passes through the whole height of a ...
3
votes
1answer
4k views

Do I need a stud on each side to install a swinging shower door?

I recently started looking into installing a glass shower door for my stall shower. The shower is a one-piece fiberglass pre-fab shower. I assume I need a stud on at least one side of the door to ...
3
votes
1answer
237 views

What are these called?

Can someone help me out and let me know what these are called? I'm looking on a DIY site to order one but can't work out what these are called to be able to find them. As you can see in the ...
2
votes
3answers
5k views

How can I make an exterior door?

I have a solid wood entry door installed by the previous owner of the house. However, it doesn't match the mid-century style of the house and it doesn't have any windows; making the front entryway ...
2
votes
4answers
6k views

Door replacement - will door still be solid after cutting?

I need to replace/repair a door in my rented apartment. During a rather rowdy party one of my guests managed to put a hole in my bathroom door. I don't think that there is probably anyway to ...
2
votes
4answers
792 views

How to fix a damaged door frame?

We have damaged the interior side of our master bedroom door. The door got jammed and when we forced it open, it got damaged; the molding of the door is damaged. I have attached the photo. Need some ...