For questions generally relating to outdoor, semi-elevated, non-enclosed structures such as decks, gazebos, pergolas, etc.

learn more… | top users | synonyms

2
votes
4answers
528 views

How can I hold a nut underneath a deck with no clearance while screwing a bolt into it?

I have an existing deck with composite wood planks. My kids bought me a gazebo for my grill that I would like to bolt to the deck. Is there a tool I can use to hold the nut and washer in place under ...
0
votes
2answers
949 views

How do I support a deck that spans a driveway? [closed]

I am planning to reinforce my deck, as it is has a lot of sway, and was built with 12' 4x4s, and not 6x6s. The deck spans my driveway, which is the width of a two car garage, so a fairly decent span. ...
1
vote
2answers
13k views

What are the drawbacks of not attaching deck to house?

I am planning on building a small deck on the side of my house where there is no door or window. The level of the deck is below the top of the basement, so I need to drill through the concrete for the ...
4
votes
2answers
4k views

Does a deck band board go over or replace wall sheathing?

I can't find an existing question that completely addresses my question, so here goes. My outside deck was recently rebuilt by contractors selected by my HOA. The deck is effectively on the second ...
4
votes
2answers
27k views

How should I build the concrete footings for my deck?

I plan on making a small deck and I live in Howard County Maryland. The deck code here says that the concrete footing must be 30 in below ground level and have a thickness of at least 8 inches (i.e. ...
5
votes
3answers
55k views

Should I finish staining my half-stained deck with rain coming?

We were supposed to have two weeks of perfect weather conditions so I started the process of staining my deck, I cleaned it, sanded it and yesterday applied the first coat to half of it. Now the ...
6
votes
3answers
68k views

What is the process for power washing and staining a deck?

I am planning to power wash my deck and stain it afterwards. But I am not quite sure the correct procedure for this process. After power washing the deck, can I stain the deck immediately or should I ...
5
votes
4answers
36k views

Do deck coatings work as claimed?

Home improvement stores have been stocking products in the paint section that appear to put a thick coating on the deck boards, giving them the appearance of synthetic decking. They claim to offer ...
6
votes
1answer
20k views

How can I attach a ledger board to my house?

Spring is here so I finally started to take measurements for materials I will need to build a new deck on my recently constructed home. I just realized that this isn't going to be quite so simple as I ...
7
votes
1answer
758 views

What is a good strategy to support this deck?

I am planning a potential DIY job for a new deck that I want to put on my house. This is roughly what I think we want The house is roughly 36' long and the garage roughly 22'. The door from the ...
7
votes
3answers
2k views

How can I frame this multi-level deck?

I'm designing an addition onto my existing deck (the existing deck is not pictured below). The addition will be roughly 20' by 15', and I'm planning on making a portion of it a single step lower. ...
2
votes
1answer
583 views

Is flashing required to attach a landing to the exterior of a house

I will have a landing running from the back door, then four or five steps to ground. Do I need to place metal flashing where the landing attaches to the house, or some other means of protecting the ...
4
votes
3answers
787 views

Will my wood platform support my generator?

I built a wood platform out of pressure treated lumber 6ft X 4ft 2x6 with beams every 16 inches and 2x6 deck. It is bolted into the house 2x10 on the 6 ft rear wall and carriage bolted to an existing ...
1
vote
2answers
10k views

What is the best way to seal my deck?

I Have an outside deck, it currently has a layer of varnish on it, I Think the wood type is Meranti. The deck is exposed to lots of rain and also harsh sun, and the varnish has started to peel. I ...
0
votes
1answer
4k views

What is the proper deck footing depth in Connecticut?

I'm moving a deck footing for an existing deck, the current one is in the wrong location and it's too small. What is the proper depth in Connecticut in order to ensure that it doesn't suffer from ...
2
votes
2answers
2k views

Where can I store outdoor patio or deck furniture over the winter?

I have a variety of plastic / wood / metal patio furniture that I am looking to store over the winter. Unfortunately, I don't have space inside to store it. We usually see temperatures of about 10 ...
4
votes
2answers
635 views

How can I join vinyl decking to metal door frame?

Shoddy workmanship by a lousy contractor has left me with a vinyl deck that allows water to leak into the garage below. I identified the location of the leak - where the vinyl meets the metal frame ...
5
votes
1answer
3k views

Is there a correct orientation for hurricane clips?

When installing hurricane clips to joists where it crosses a beam, is there a preference to mounting the clips on the inside or the outside of the beam? And should the ears on the clips point inward ...
0
votes
1answer
2k views

How can I build my own deck canopy?

I'd like to build my own deck canopy, and not purchase those retractable awnings that don't seem to last so well out here in Colorado (can be very windy). I have the 'basic' idea in my head but are ...
3
votes
2answers
376 views

What can I do to prevent injuries from the corners of a wooden deck?

We recently had the floor of our wooden deck replaced and in the process, the contractor changed it from having cut-off corners to having real corners. I am concerned with how the new corner sticks ...
1
vote
1answer
3k views

Can I build a deck close to the ground? [duplicate]

Possible Duplicate: Can I build a deck this low to the ground? Every set of instructions I've seen for building a deck requires me to put joists on top of beams attached to posts. But I only ...
1
vote
1answer
2k views

Can I turn a 4 X 4 deck post, eight feet high, into a 6 x 6 post by laminating a 2 X 6 and 2 X 4 to it?

My mother-in-law has a deck 8 feet off the ground that is is built with 4 X 4's for support, with only one notched 2 X 6 rim joist on the outerside of the deck which also supports the 2 X 6 joists ...
3
votes
4answers
6k views

Can I build a deck from reclaimed 2x4's?

As we've remodeled the house, I've replaced some of the structure with more modern woods (ie: 2nd floor ceiling joists that were 2x4's are now 2x6's) Because of this, I have an excessive amount of ...
6
votes
3answers
12k views

How to install a proper deck ledger AFTER the fact?

We just purchased a house that has a roughly 10X20 deck on the back. It's relatively low to the ground (maybe 1-3 feet high). The house is cedar lap siding. The problem is that the deck was built ...
3
votes
1answer
15k views

Can I build a pergola on an existing deck, without digging more footers?

A couple of years ago I built a deck onto my house. It is 32' x 14' I used a cantilever design at 12' with 2x8" floor joists, with 2x6" decking boards. The Cantilever beam was set on 6x6" posts that ...
3
votes
1answer
2k views

How much structural support does a Gazebo require?

We are having a gazebo built on the end of a new deck. The deck is about 4 feet off the ground at the point where the gazebo will go and the contractor wants to use 4x4 posts dug into the ground all ...
2
votes
2answers
229 views

Can salt be used to create a slip resistance surface in concrete?

Is it true that salt can be used to put a slip resistant surface in fresh concrete?
6
votes
4answers
25k views

How do I vertically connect two 4x4s on a deck to build a roof?

I have a deck I am going to put a roof over. It has 4x4s for vertical supports that I need to extend upward to attach my trusses to. What is the best way to connect two vertical 4x4s?
4
votes
4answers
1k views

Easiest way to cut, shave, or chisel bottom 8" of posts to fit footings

I got some 6x6's and deck post brackets that are similar to the picture below, except they're 8" high: Come to find out, the 6x6 is slightly too large to fit inside this bracket. Now I see how ...
3
votes
1answer
911 views

How can I stop PVC decking from squeaking?

We recently installed a TimberTech deck using all-PVC flooring. They use a clip fastening system (non-nail and non-screw)that recommends the floor joists be spaced for 12 inches on center, if diagonal....
12
votes
5answers
27k views

How do I improve Pergola Stability?

The deck is nearly finished but I have a small structural problem with the pergola. A left or right force near the top of the pergola (such a a tall person leaning on the post) leads to a bit of ...
4
votes
1answer
2k views

Does anything need to be done to prep the ground before building a low height deck?

Previously I asked about How to add on to a concrete patio? I am still considering my options and am now considering making a wood deck instead of a concrete patio. The deck would be about 14 feet by ...
12
votes
2answers
43k views

How should I clean and repaint a painted wooden deck?

My deck appears to have been painted with just a single layer of paint, which is now peeling off. I like the look of the paint (when it's in better condition, of course), and am uninterested in ...
4
votes
4answers
14k views

How can I remove paint from a deck?

I bought my house 3 years ago. The deck surface and decorative fence around the edge are painted with a latex-based paint. After shoveling snow each winter, the deck surface is chipped with raw wood ...
5
votes
1answer
586 views

How can I restore ridged decking?

My in-laws have a deck out the back of the house. They're old and the deck hasn't been maintained in 10 years or more. Many of the boards have blackened and are lethally slippery if the weather is ...
9
votes
1answer
6k views

Should I powerwash and waterseal a pressure treated deck?

Is there any maintenance that I should be doing such as yearly power-washing and water-sealing for a pressure treated deck?
3
votes
1answer
4k views

How can I extend a deck post on an existing deck?

I have an existing deck (built in 1991) that I am making repairs to. As part of the work I want to extend the deck cover that's already there. Existing deck Desired outcome So I know I need to ...
2
votes
1answer
5k views

How do I seal a painted deck?

The builders of my home painted my front and back porch. The railings are white, and the decking itself is the same color as the house. It looks great, but the paint has all peeled up. I'm in the ...
2
votes
2answers
224 views

Would it be safe to leave charred wood on a deck until repairs can be made?

Had a small fire incident outside on our wood deck. There didn't appear to be any structural damage to any of the supporting material, just a few surface boards which need to be replaced. Can the ...
6
votes
2answers
4k views

In a cool damp climate, should I use hardwood or synthetic decking material for a deck that will be near a large tree?

We're building a 12x24 deck in our south-facing backyard in Seattle (aka rainy Pacific NW). There's a very large willow tree in our backyard that doesn't directly hang over the deck, but certainly ...
1
vote
1answer
362 views

Is clorox outdoor + jomax safe on vinyl decking?

I used the recipe suggested in this question to successfully clean my vinyl siding. Its a combination of Jomax, Clorox outdoor, and water. I'm wondering if this solution will work fine on my vinyl ...
7
votes
3answers
21k views

Can I use 4x4 posts as the primary support for a deck?

I have an old cedar deck, and most of the decking and vertical support posts are rotted out. I'd like to rebuild the deck as-is, just replacing the rotting pieces. The current design is as follows: ...
6
votes
1answer
1k views

Is it OK to build a deck with OSB?

I have left over 2x4s and OSB from a project a few months back (lean-to shed). It is just enough to make a 12'x8' deck, and I was wondering if this would be "OK" to use for decking? The main purpose ...
5
votes
3answers
1k views

How to plan for the future when installing a new roof?

We're hiring a contractor to take off the existing roof, repair/replace any rotted sheathing and rafters, and install a new roof. We've also asked that they add a new plumbing vent stack for a new ...
0
votes
1answer
296 views

Preparing a deck & playset for re-staining

The question asked here is pretty much similar to mine except that there are few splinters and chipped wood on the deck. How to smooth those out? Also there is a kid's play structure (with steps and a ...
4
votes
1answer
407 views

How do I fix a vinyl covering that is coming away from the outside deck support beam?

I live in a townhouse with a deck over the garage. I noticed that under the deck, along the board that is on the outer edge, some of the vinyl covering is popping out of place and hanging down a ...
5
votes
3answers
2k views

How do I properly paint a wood floor made of plywood?

I have built a yurt platform, which is basically a deck with 1 1/8" tongue-and-groove plywood as the decking. Usually that stuff is used as a subfloor, but in this case it's the floor itself. Call it ...
4
votes
1answer
8k views

Attaching a pergola (or deck) to vinyl siding

Building a structure which is attached to a house usually involves a plate which is bolted to the existing building, typically a 2x8, or 2x10. I understand how to structurally attach this, my concern ...
5
votes
5answers
29k views

Applied stain to deck and still not dry after a week, what can I do?

I decided to restain my deck last week since it was looking pretty worn after a New England winter. The deck is only 1 year old since we bought new construction. I contacted the builder and purchased ...
5
votes
5answers
32k views

How do I make a deck glossy?

I went to Home Depot and Sherwin Williams and I was unable to find a deck stain that looked like the shiny blondish color of the following image: At Sherwin Williams they said that their stains ...