0
votes
1answer
155 views

How do I correct free-standing deck moving away from home?

I have what is primarily a free-standing deck (18x22) in the back of my house. I say "primarily" because I did nail into the ledger board underneath my glass sliding door, but only there. The rest ...
0
votes
1answer
302 views

Should I use silicone caulk on the side of a deck ledger?

I have a deck ledger attached to the rim joist (the vinyl siding was cut away), and some flashing above the ledger. On the side of the ledger there is a gap between the end of the 2x10, and the ...
3
votes
1answer
137 views

How can I improve this deck ledger and the flashing around my ledger?

I'm planning to replace the current warped ledger board with a new one new using galvanized lag bolts. How can I protect the exposed black paper and OSB between the two vents? Is more flashing ...
0
votes
2answers
667 views

How do I remedy a ledger board that is pulling away from the house?

The ledger board of our deck is attached with nails only. One side is beginning to pull away. I put in more support posts so it is not separating further. What would be best to remedy the ledger ...
2
votes
1answer
672 views

What should I do on the sides of a deck ledger?

I plan on hanging my ledger board similar to the picture described here. I am going to be bending coil stock for the drip cap and the Z flashing. The diagram though doesn't depict what should be ...