4
votes
4answers
258 views

How do I get all these wires up from the basement to the attic?

I'd like to run new cabling for data, voice and tv but I'm having a hard time figuring out how to get some of the wires up to the attic for the 2nd floor and would like some advice. I've run cables, ...
6
votes
7answers
8k views

How can I run Cat5e cable through a completely finished house?

My family and I are interested in buying a house that was built in 2002. This house is two floors on a concrete slab with a finished bonus room upstairs so there is no attic other than above the ...
1
vote
2answers
292 views

How can one properly and tidily install this hardware for internet access?

This picture shows what my new home has for the wiring necessary for internet access. Some of the wiring here isn't necessary---in fact, most of it isn't, just the telephone wiring. With an idea of ...
1
vote
1answer
413 views

How can I electrically test an RJ45 plug?

I live in a dorm and there's a RJ45 connector on the wall, which is connected to a router somewhere in the building (which I do not have access to). Supposing I do not know the exact hardware ...
-1
votes
1answer
720 views

What wires do I need to run to my wall mounted tv?

I'm in the planning stages of a home theater setup. What do I need to run to the tv so I can hook up various components? I planned on running power, HDMI cables, RCA cables, coax, and an ethernet ...
4
votes
2answers
325 views

Is there any NEC code requirement for how far off the floor Category 5 wiring must be run?

I am currently running conduit for Cat5e cable in the home office I am finishing off. Are there any rules in the code for how far off the floor Category 5 wires in conduit must be run?
3
votes
1answer
5k views

How can I split my rg6 cable runs without losing my signal?

So I've been working on this for months as I finish my basement. We don't have cable tv or satellite. We just get broadcast tv using a digital roofmount antenna and then in the house a digital ...
2
votes
2answers
917 views

Should I be able to run some 1.5" PVC chase conduits from attic to basement next to a cold air return?

I have a new home I just moved in to and rather than having them put this stuff in ahead of time (silly me) I'm now trying to do it now. Here is my situation... I live in a 2 story home with a ...
1
vote
1answer
464 views

How can I wire an HD antenna into my attic?

I have a 2 year old house 2 floors and then an attic that you have to use a pulldown to get into. The house has an ethernet cable (90% sure it is an ethernet cable) that is in the attic, I have a HD ...
0
votes
1answer
218 views

Does the listed gauge on a crimp cap take into account that two wires would go in the same end?

What size of crimp cap be used for 16 AWG wire? I could use butt splice of size 22-18 AWG but prefer crimp cap connector where both wires go in the same end (so double the diameter). Should I buy ...
8
votes
4answers
3k views

Is “don't mix data and power cables” and “don't loop power cables” still valid nowadays?

There are two sayings I keep hearing when talking about wiring e.g. home cinema or computer hardware; Don't wrap data/network cables and power cables up in the same loop because the power cables ...
4
votes
2answers
3k views

How can I convert Cat5e wired sockets to Ethernet?

I recently moved to a new home and I noticed that the phone jacks (RJ-11) were connected using Cat5e cable. I'm thinking I can replace the RJ-11 plugs with RJ-45 and use Ethernet over the existing ...
4
votes
1answer
745 views

How do I choose a recessed alarm contact switch?

With so many window and door recessed contact switches, how does one decide the best one for the application? I was leaning towards Ademco 3/8" Diameter Miniature Press Fit Magnetic Contact, for ...
7
votes
2answers
424 views

Will security system wiring cause interference in data cables?

Is it acceptable to run 22/4 security wire along side Cat6 and Coax cables, or is there any possibility for interference?
6
votes
4answers
2k views

How Do I Plan for an Intrusion Detection System?

I would like to plan for an intrusion detection system in a home that is currently under construction. The home has a walkout basement that is sloping, shown in the rear elevation picture shown ...
4
votes
2answers
2k views

Do open-back low voltage boxes have advantages over standard outlet boxes?

I will be running LV wiring in new construction. I've seen the open backed Carlon boxes, but have read that they are difficult to insulate, and therefore should not be used on exterior walls. I ...
13
votes
4answers
3k views

What should I use to secure/organize data cable runs?

I am running Cat-6 and Coax in new construction. I am looking for advice/best practices on how to organize and secure the cables during the runs. I will be running 2 Cat-6 and 1 Coax to a ...
5
votes
1answer
3k views

Running cat 6 networking cable in the attic: what is up to code?

I plan on adding a Cat 6 network in my single-story detached home. It would consist of home runs from each of the 3 bedrooms + TV room to a central patch panel in the garage, which is close to the ...
2
votes
3answers
3k views

What are some tools for diagnosing powerline networking problems?

We've had problems with a number of devices that communicate over power lines -- both the TED 5000 electricity monitor and most recently a pair of Netgear powerline networking adapters. I've tried a ...
3
votes
2answers
313 views

Alternatives to signal on power for home automation systems (such as UBP) - low-voltage circuits, wireless…?

I am kind of averse to using signal on power for home automation systems such as UBP as this seems to be shared with the outside world (I read somewhere that the signal can travel as far as the ...