For questions relating to compliance with laws and ordinances of federal, state/province and local jurisdictions. Questions should also be tagged with the specific area of construction involved.

learn more… | top users | synonyms

0
votes
2answers
262 views

Understanding deck spans for beams.

I've been looking at various span charts for decks and I'm still not quite sure how to calculate it all when you take into account not just the joists, but the beams and posts as well. What we ...
0
votes
1answer
55 views

Loft bed next to a red water pipe

I had a loft bed built into my condo. The bed is up near the ceiling and there is a large red water pipe just above it. It carries the water to the sprinklers but its not a sprinkler itself. My bed ...
0
votes
1answer
119 views

Why are 3-1/2 (16d) nails so hard to find?

So I'm a little confused. It seems like 21 degree fullhead framing nailers are fairly standard. According to the http://codes.iccsafe.org/app/book/content/2015-I-Codes/2015%20IRC%20HTML/Chapter%...
0
votes
1answer
68 views

Can I run my hydronic circulator off an appliance cord in order to use it to purge air?

I have a hydronic heating system with a relatively powerful B & G circulator pump. This pump has a relay that is controlled by the furnace electronics; if there is no power to the furnace, there'...
0
votes
1answer
84 views

Can a cord and plug attached to a wallbox be used as a transfer means for fixed wiring downstream of the box?

So, we have a circuit that runs from the panel to junction box A, then to junction box B, and then onwards to a load. Can the fixed Chapter 3 wiring between junction box A and B be replaced by a ...
1
vote
0answers
49 views

Post to beam connections

Here's the issue. I was told that I could find some angle brackets to finish this project (and secure the post to the beam). However, I'm finding nothing that doesn't require we remove the set beam ...
1
vote
0answers
48 views

Are drain-clearing bladders safe?

I advised a friend to use a drain bladder to clear a sink clog. Turns out there was a vent that didn't connect to the main vent stack--it just terminated inside the wall. So she put a bunch of water ...
1
vote
0answers
54 views

North Carolina Code question for splicing 6x6 posts

I have a 48 X 10 second floor deck with 6X6 posts. I want to add a roof above about half of it. It is not feasible to replace the 6X6's with longer ones as I would basically end up replacing the ...
1
vote
0answers
49 views

Can I move well pipe from under front steps and still satisfy Connecticut code?

I have a problem with my well pipe - it leaks in the spring (when snow melts). As you can see from image below - multiple hack repairs were attempted by previous owners. I was going to excavate the ...
1
vote
0answers
149 views

Is it OK that my circuit breaker panel does not latch closed

I plan on doing some work and having it inspected. As part of the work I will be switching some normal breakers to AFCI. Before I get started I notice my panel does not fully latch closed. The latch ...
1
vote
0answers
86 views

basement bathtub straddling a crater

we got this house recently. i was working on paint and finishing our basement bathroom.. trying to remove the baseboard trim surrounding the the bathroom shower, i noticed that it came out ...
1
vote
0answers
45 views

Does the junction between two horizontal spaces need to be fireblocked?

This question is in regard to interpretation of IRC:2012 R302.11 for a single family dwelling. It is clear that junctions between vertical and horizontal framing need to be fireblocked (e.g. between ...
1
vote
0answers
235 views

When does a sleeve become a conduit, and how much can I fit in a sleeve?

According to National Electrical Code, the conduit percentage fill table does not apply to sections of conduit used to provide protection from physical damage (sleeve). National Electrical Code ...
1
vote
0answers
87 views

Independent circuits on a common trip CB

Is it permissible under the 2014 NEC to feed two independent 120VAC branch circuits from a common trip (aka double pole) circuit breaker? The circuits do not share a neutral wire, and are ordinary ...
1
vote
0answers
100 views

Does this count as a material alteration or repair for code purposes

Ontario Building Code, 2012 Except as provided in Section 3.17. of Division B, Section 9.40. of Division B and Part 11 of Division B, if an existing building is extended or is subject to ...
1
vote
0answers
222 views

Can a water heater be installed overhead?

Sorry for the long preamble: I'm doing a remodel which involves building a new attached garage. At the same time, I'm replacing the water heater because it is ancient. I have considered a ...
1
vote
0answers
122 views

Can I attach a metal box for a vanity light to a wood cross?

I am redoing a new bathroom. I have a metal electrical box that I want to replace (because it is an odd size from the 50s). The current one is simply screwed to a wood cross (2x4) running ...
1
vote
0answers
145 views

Where can we recycle washing machine and kitchen sink drain water?

I would like to know the best place or method to recycle drain water from the kitchen and washing machine. Can we use it for gardening (as it contains soap and oil)? Or it can be added to a Biogas ...
1
vote
0answers
190 views

How do you plug an unused hole as per the NEC for a liquid tight enclosure?

I have been looking for a way to seal a liquid tight product using Listed blanking plugs / Cap-offs or similar to comply with the NEC (US National Electrical Code). We wanted to use Conduit Entry ...
0
votes
0answers
24 views

Can I run a 110V extension cord through a wall-mounted cable hider/channel?

I have a ceiling mounted 110V outlet and I want to run an extension cord down to the floor. Is it up to US electrical code to mount those PVC cable hider channels on the outside of the wall and run ...
0
votes
0answers
47 views

Stairs codes for length between last step and door opening?

Hi I want to add a door to the bottom end of my stairs but I want to check the building codes first so that I will not be caught in a house inspection if I am going to sell my house. I could find ...
0
votes
0answers
185 views

Can I add an air gap to an existing drain pipe?

I am installing a water softener in my garage. There is already a place to connect into the water line (after the existing sediment filter), and there is an existing drain pipe (2 inch PVC that runs ...
0
votes
0answers
500 views

Can I make my bulkhead stairs steeper and still be up to code?

The bottom few steps of my bulkhead stairs go beyond the wall of the basement. The problem is I would like to put a door in my basement at the bottom of the stairs. To do this I would either have to ...
0
votes
0answers
79 views

Super-Insulating a Crawlspace

I am getting ready to have a contractor insulate my crawlspace. The exterior facing walls of my crawlspace are about 2" above grade, with the remaining 2 ft 6 in - 2 ft 10 in below grade. One of the ...
0
votes
0answers
569 views

Deck diagonal bracing alternatives

The IRC prescriptive deck guide calls for decks taller than 6' to have diagonal bracing placed parallel (planar) to the beam from post to beam. My deck, which is built with a beam on one side and a ...
0
votes
0answers
264 views

What codes are invovled in running an overhead subpanel feeder to a detached garage?

This subfeeder will be going to a detached garage about 30ft away, and powering a 100amp subpanel. I'm not sure what codes are involved in this feat. I'd like to know the codes involved for compliance....
0
votes
0answers
119 views

Replacing drywall above boiler… to Code? Inspection?

I own a mid-1800's house in New England, with a fieldstone foundation and dirt floor basement. I now have a mold problem in the basement. There is lone sheet of drywall above the boiler & water ...