0
votes
2answers
77 views

New residential toilets all so tall?

Are all new toilets high off the ground? Our existing toilets (one 20-year-old Toto and one ancient 5 GPF monster that I am shopping to replace) are around 14.5" from the floor to the rim of the ...
3
votes
3answers
159 views

Can I use old style individual faucets on a bathroom vanity?

We have an old home and would like to keep with the period where possible. I have a marble vanity top with individual faucets for hot and cold rather than a single spigot for both. I can buy brand new ...
1
vote
2answers
158 views

Can I drill a 3 1/2" hole through 5 joists?

I need to move a toilet to the other side of room approx. 6 ft I will have to drill a 3.5 in hole for the waste line in 5 floor joist on the second floor. Can I double them and still drill the 3.5 in ...
1
vote
0answers
84 views

Can a water heater be installed overhead?

Sorry for the long preamble: I'm doing a remodel which involves building a new attached garage. At the same time, I'm replacing the water heater because it is ancient. I have considered a ...
2
votes
1answer
143 views

What are the code requirements for installing a ceiling fan alongside a fire sprinkler?

I have a fire sprinkler in my bedroom ceiling which is right in the middle. I want to install a ceiling fan. What are code requirements to follow?
2
votes
1answer
243 views

What is the maximum number of connections to pipes?

Does anyone have a table of the maximum number of connections that drain/vent pipes can have for a given size?
2
votes
2answers
734 views

What is the difference between MSS SP-80 Type 1 and Type 2?

I have a bronze gate valve whose spec sheet says it conforms to MSS SP-80 Type 2. However, the project standards specify that the gate valve must be MSS SP-80 Type 1. What is the difference between ...
1
vote
4answers
3k views

Should galvanized steel pipe be used as a tub spout?

I have a 90 degree fitting coming down from my shower valve. Also have a screw on tub spout trim. Right now there is a 6" galvanized pipe that connects the 90 to the tub spout trim. Is the ...
1
vote
1answer
996 views

How do I find out if Air Admittance Valves (AAVs) are allowed in my municipality? [closed]

I saw Richard Trethewey of Ask This Old House install an AAV as part of a kitchen island sink system. I thought I might be able to use one for the water line for my washing machine. I'd like to ...
2
votes
1answer
490 views

What does the Plumbing Code say about securing a bathtub faucet to the studs?

My son is renting an apartment. It looks as if the bathtub faucet (spout and valvehandle) are only secured by the grout of the tile and haven't been properly secured at all to the studs. I know that ...
2
votes
2answers
199 views

Can PEX be used for the trunk

Currently I have a length of galvanized steel pipe (3/4") from the water meter, which is feeding the main trunk (3/4" copper). The water pressure in the house is very low, and I suspect it is due to ...