The tag has no usage guidance.

learn more… | top users | synonyms

2
votes
1answer
123 views

Why would two regular outlets stop working after I replaced GFCI outlets?

I replaced to gfci outlets and they are working fine, but two outlets on the same wall that are regular stopped working and are not receiving electricity. I checked and checked to see if I did the ...
1
vote
3answers
1k views

What should I look for when diagnosing electrical circuit gremlins where load is much less than capacity?

We have an electrical circuit with these loads (all on different outlets): 15W aquarium pump, 250W LCD television, 35W cable box, 13W GoogleTV box, and a 100W ceiling fan (plus an integrated 50W ...
6
votes
5answers
12k views

Can a mix of receptacles and light fixtures be installed on a single circuit?

A while ago we had some renovations done in our house. After the electrician was done, we realized we now had one light switch in our kitchen that was no longer connected to anything. It is in a ...
3
votes
3answers
739 views

How does an illuminated switch light up without a neutral

There are some illuminated switches that operate without a neutral. For a lamp that is lit when the switch is ON, I can envision a circuit diagram that has the switch lamp in series with the switched ...
3
votes
5answers
805 views

Is this too many items on a 20 AMP Breaker?

I live in a 2 bedroom 2 bath duplex, where we have issue's with the light's flickering, often causing mini power surges, and at times kicking a breaker. One 20 ampere circuit supplies 3 ...
2
votes
1answer
568 views

15 amp load trips 20 amp breaker instantanously

New construction wired by professional electrician, Montana USA. Dedicated circuit for a 14" chop saw with 10 ga. wire and a 20 amp breaker. Saw was used previously on a 15 amp circuit with no ...
1
vote
3answers
63 views

Circuit Breaker change

I am changing a Federal Pacific Electric Co. Circuit Breaker double 40amps but I can't find one. Can I use a double 50? It's for a wall oven?
0
votes
1answer
78 views

How can I find out why my washing machine trips the outlet?

I was washing a large down comforter in my washing machine and I noticed that the machine was shaking during the spin cycle. I let it go for about 10 minutes and decided to just turn it off, but when ...
-1
votes
2answers
121 views

Light switch setup using only white wire. Will it work? [closed]

I'm working on a small cabin. All black wires are run directly to lights. The white wires are run to the switches then lights... so each switch has only white wires. Would the circuit still work? ...