The tag has no wiki summary.

learn more… | top users | synonyms (2)

3
votes
1answer
637 views

When replacing non-grounding type receptacles is a GFCI receptacle required, or can any GFCI device be used?

Under the NEC (it was 210(7)(d)(3), but appears to have moved around some), it is permissible to replace an ungrounded receptacle with a GFCI receptacle, then wire further ungrounded or non-grounded ...
9
votes
1answer
47k views

Why is my air conditioner tripping the circuit breaker?

Our air conditioner recently stopped blowing out cold air. When I went to check on it, I noticed that the outside unit wasn't coming on. We had had problems with ants in the contacter in the past, ...
8
votes
1answer
9k views

How can I determine circuit breaker requirements for an electric range?

I recently had a new range installed and when an electrician was visiting, he pointed out that the circuit was over capacity because the range was rated at 12.2KW at 240V. He said 12,200 W / 240 V = ...
7
votes
7answers
7k views

How is it that two breaker switches control the same things?

Forewarning: I don't know that much about electrical terms, so please excuse any mistakes I've possibly made. I recently moved the TV in my living room and ran a new line for the electricity to the ...
4
votes
3answers
6k views

Why does my circuit breaker trip with any small load, even after replacing the breaker?

I have a 20A 240V GFCI breaker in my main breaker box going to a conduit to another breaker box outside. All worked well last summer. Now, when I put any load (weed-eater, light, etc.) on an outlet ...
2
votes
3answers
233 views

Do receptacles require a 20 ampere breaker?

I thought wall recepticles required a 20 amp breaker. Am I wrong?
2
votes
2answers
323 views

What's the amperage on a circuit breaker that's “linked” together?

On our circuit breaker, we have several circuits that are linked together by a metal handle. For instance, there are several cases of three 20A circuits all linked together, meaning you can only flip ...
2
votes
1answer
873 views

How do I test circuit breakers?

Suppose I need new circuit breakers and buy some at a local shop. How do I test them to be sure they haven't been damaged on their way from factory and will do their job when time comes?
20
votes
4answers
2k views

Why would two circuit breakers be connected inside the service panel?

I was trying to locate the circuit breaker for an outlet in my garage and found a truly baffling setup. Two breakers control the same outlet (both plugs). After some head scratching, I opened the ...
7
votes
4answers
6k views

Can I replace an outlet that uses knob and tube wiring with a grounded outlet?

Can I replace an outlet that uses knob and tube wiring with a grounded outlet? Obviously the best choice would be to replace the old wiring. Is there a standard way to ground these outlets? Do I need ...
9
votes
5answers
59k views

How do I add more circuit breakers once the breaker box is full?

My house was completely rewired by the previous owner. They tore out all the old knob-and-tube and replaced it with modern wiring. I definitely appreciate this, but unfortunately they left ...
7
votes
2answers
1k views

Are there any “easy” ways to trace a home electrical system?

We bought a home a few months ago, and the electrical panel (and subpanel) are completely unlabelled. We have no way, short of flipping breakers, to know what breaker powers which fixtures. Is there a ...
14
votes
5answers
3k views

Is there a lifetime failure count for a breaker?

I have an external cutoff for my air conditioner that has two physical fuses (TR-50's, time delay 50 amps) outside. This is between the condenser unit and the main power panel, where it is protected ...
10
votes
3answers
10k views

What is electrical code for number of wires in a breaker?

US, Georgia I am adding some new ciruits to add some additional outlets. The closest place is to run a wire to the main panel box. My question is, can I connect more than one wire to a breaker and ...
8
votes
1answer
1k views

Is there an average number of outlets that are wired off of one circuit breaker?

I recently demolished my basement to start a reconstruction/improvement project. My first horror was the electrical layout. I've got hidden junctions, mismatched wire sizes, improper junctions and ...
7
votes
2answers
2k views

How can two different breakers both turn off the same circuit?

I have a 40 yr old home with circuit breakers. While looking for the breaker to turn off a circuit (I was replacing a light switch), I found that two breakers, on the same side of the bus, but ...
7
votes
3answers
2k views

Is it ever safe to have 14 gauge wire anywhere on a circuit protected by a 30 amp breaker?

I was doing some work in an old house I recently moved into, and found that my dishwasher and garbage disposal (and some outlets near them) are on a 30 amp breaker. However, some of the electrical ...
7
votes
2answers
6k views

How much should it cost to add a circuit breaker?

In this question, I asked about problems between my circuit breaker for a circuit shared by my microwave and sump pump. The conclusion was that another circuit should be added to support the microwave ...
5
votes
4answers
1k views

Can re-closing a circuit-breaker be dangerous?

I have a circuit breaker that keeps tripping. When i try to reset (close) it, it immediately jumps back to the open position with a noise that sounds a little scary. I have now stopped trying to do ...
3
votes
3answers
110 views

Lighting circuit trips breaker every time

I have a lighting circuit in my home like so: Every time I turn on the switch, the breaker trips. This circuit has existed for over four years and only now has the problem begun. I've checked all ...
3
votes
5answers
530 views

Is this too many items on a 20 AMP Breaker?

I live in a 2 bedroom 2 bath duplex, where we have issue's with the light's flickering, often causing mini power surges, and at times kicking a breaker. One 20 ampere circuit supplies 3 ...
3
votes
3answers
1k views

Why would a circuit breaker not trip if I accidentally shorted hot to neutral?

I am installing a set of recessed lights in a closet, replacing the existing fixtures one at a time. I removed power to the lights while installing each one by using the light switch, not the circuit ...
3
votes
2answers
23k views

What are the differences between SDS, SDS Plus, and SDS Max drills?

Basically I had to use a breaker last weekend, it was clear I did not need the “heavy duty” as I did not have 6” of solid concrete, but the descriptions of the other options confused me.
3
votes
2answers
4k views

What information do I need to select a circuit breaker?

I am having 2 new lines run in my basement to power a workbench's tools and an unrelated computer station. I have room in my panel for additional breakers, and rather than tie into existing wiring, I ...
2
votes
1answer
383 views

15 amp load trips 20 amp breaker instantanously

New construction wired by professional electrician, Montana USA. Dedicated circuit for a 14" chop saw with 10 ga. wire and a 20 amp breaker. Saw was used previously on a 15 amp circuit with no ...
1
vote
1answer
100 views

Can you wire a 30A 2P standard circuit breaker “downstream” from a 60A GFCI 2p circuit breaker?

Will this still provide GFCI protection? Is this against code? Does this represent a hazard? I have a subpanel with a 60A GFCI circuit breaker, that I want to use that to feed to 2 30a 240v ...
1
vote
1answer
132 views

GE Load Center Q's

I have an old GE meter socket load center (see picture). I have no idea what the model number is because the paper label on the inside of the lid is unreadable, and I have been unable to find any ...
1
vote
1answer
145 views

Is it safe to replace a GFCI breaker with an arc fault breaker?

We recently had our electrical panel replaced/upgraded and I noticed that our GFCI breaker was replaced with an Arc Fault breaker. Is that safe? Are GFCI breakers obsolete now?
1
vote
2answers
3k views

Why is my fuse board buzzing when I'm using the shower?

I have used an electric shower for years no problems, but all of a sudden my fuse board started buzzing when I use the shower. I replaced the shower with the same size unit and it still makes a ...