3
votes
2answers
58 views

Can I add an occupancy sensor to a 3-way circuit?

If I replace one switch in a 3-way circuit with an occupancy switch, would this cause the occupancy switch to work in reverse (or not at all) if the regular switch was toggled? If so, would the best ...
1
vote
3answers
119 views

What should I look for when diagnosing electrical circuit gremlins where load is much less than capacity?

We have an electrical circuit with these loads (all on different outlets): 15W aquarium pump, 250W LCD television, 35W cable box, 13W GoogleTV box, and a 100W ceiling fan (plus an integrated 50W ...
4
votes
2answers
259 views

How can I remove a receptacle and abandon the electrical outlet?

We are trying to remove an electrical outlet. We turned the power off and disconnected the wires from the outlet. Then we twisted the + wires and tapped them and did the same with the - wires. Then we ...
2
votes
2answers
172 views

What does the latch position of a circuit breaker mean?

I bought a new home in December 2011. After some time the kitchen lights and the lights in the living room started to switch off randomly. Some days it would happen 3-4 times in a row. Other days it ...
1
vote
1answer
194 views

Why am I measuring low voltage when I connect this fluorescent fixture to an existing circuit?

My bathroom has two switches: one [was] connected to two overhead can lights (with CFLs), and one [was] connected to a fluorescent wall sconce (one of those ugly circular plastic things that I can't ...
2
votes
2answers
583 views

Jury-Rigged Modification of 110v Circuit to 220v Circuit Using Steel-Armor of BX Cable as Neutral/Ground… [closed]

My house was constructed in 1980 in the City of New York. About twenty-five years ago, I installed a new 29,200 BTU Carrier A/C through the wall of the house. The unit was rated at 208v, drawing ...
2
votes
3answers
4k views

Why does the main circuit breaker trip but not the smaller branch circuit breakers?

We have one circuit breaker (40 ampere) in entry point of electricity line in our house, than we divided it into two separate line in two levels and put one circuit breaker( 32 ampere) in level one ...
6
votes
1answer
943 views

GFCI outlet won't come on

I have a couple recently installed (By a professional licensed electrician) GFCI outlets outside a barn, both on their own circuit. Both have water trough heaters plugged into them - 1500 watts each. ...
2
votes
2answers
566 views

What should I consider when replacing an outlet serving two kitchen circuits?

I have an outlet underneath my kitchen sink that serves my dishwasher and my garbage disposal. The latter's circuit is toggled by a switch above the countertop. I need to replace the outlet, and was ...
5
votes
1answer
833 views

Is it within code to branch an exterior outlet off an interior outlet in the middle of a circuit?

My city adheres to the 2008 NEC. I've got a run of outlets around a basement room on one circuit. On an exterior wall I've got a weatherproof outlet that's on a different circuit and somewhere in ...
3
votes
3answers
3k views

Can a mix of receptacles and light fixtures be installed on a single circuit?

A while ago we had some renovations done in our house. After the electrician was done, we realized we now had one light switch in our kitchen that was no longer connected to anything. It is in a ...
8
votes
7answers
2k views

Home light switch circuit with 5 switches

I'm new to the amazing wold of electronics and starting out small. I think... Early 2010 me and the wife bought a house that was build in 1979. Now I started replacing light switches and encountered ...
5
votes
3answers
450 views

What is a UFCL brand circuit?

I'm shopping for a combination vent fan/light for a bathroom, and some of the ones I've found state this: UL Listed for use over bathtubs and showers when connected to a GFCI protected branch ...