All about ceiling fans -- i.e. fans that are mounted to a ceiling, visible within the room, and circulate air within that room. Vent/exhaust fans should use [tag:vent] and friends instead.

learn more… | top users | synonyms (1)

0
votes
2answers
50 views

Add LEDs to ceiling fan

My baby seems to love watching the ceiling fan spin. Not sure if he is retarded, bored or just super fascinated. Anyway; I was thing, perhaps I could add a few LEDs to the fan blades. My question to ...
0
votes
1answer
32 views

Fan switch compatibility

How do I determine if I need to use a manufacturer's fan switch or if I can use an off-the-shelf fan switch? E.g. I would like to buy an Emerson Loft fan and Emerson Curva fan and control them with ...
2
votes
1answer
56 views

wireless ceiling fans with low voltage

I am troubleshooting some electrical issues on three different ceiling fans in my upstairs bedrooms. All three are wireless Harbor Breeze ceiling fans. They all have the same issues but at varying ...
2
votes
3answers
1k views

Ceiling Fan Junction Box Converter/Bracket 1/2 inch width difference

First time poster. I feel like I have researched everywhere and not found the answer I am looking for. I've called a few manufactures of ceiling fans who didn't have any answers either. I began ...
1
vote
2answers
44 views

Ceiling fan low speed (only) once on slows to a stop

Ceiling fan low speed (only) within a minute or two slows to a stop, however, you can barely hear a hum until you turn it off or go to high speed or medium speed, which operate great.
1
vote
1answer
41 views

Ceiling Fan is hot 6' down, but lights nor fan comes on

I've hooked up my hunter ceiling fan with black/blue wire connected to the black(hot) wire and my white to white(neutral) and green to ground wire. My sniffer says that I'm hot not only at the ceiling ...
5
votes
2answers
819 views

Wobbly Ceiling Fan

I've installed a 52" Hampton Fan with light, (w/out remote) in my bedroom. When it is set on low the fan appears very stable. At high speed the ceiling fan shakes and does so to a lessor extent on ...
0
votes
0answers
73 views

Replacing Old Ceiling Fan With New One and No Visible Ground Wire From Junction Box

I am replacing the ceiling fan in my bedroom. Coming out of the junction box are two sets of wires. Each set has one wire coming out of opposite ends of the junction box. I connected the blue and ...
4
votes
1answer
1k views

Do I have to wrap electrical connections with electrical tape?

I installed my first ceiling fan with remote today. I believe I did everything correctly as the fan turns and the light lights, both via the remote control. My question has to do with the need for ...
1
vote
1answer
550 views

What size bulb replaces these in a Harbor Beeze ceiling fan?

My house has several Harbor Breeze ceiling fans. Two bulbs have burned out but I can't seem to find what size bulbs should replace them. Here's a picture of one of the burned bulbs (right) and a ...
1
vote
1answer
113 views

Leads from wall fan control switch are aluminum wire?

My new house in the US has a Harbor Breeze combination fan/light switch with a remote control as seen here (different brand is shown, but it's basically identical). While checking some wiring (...
1
vote
0answers
40 views

Ceiling Fan w/Remote Wiriing

Can I wire a ceiling fan remote receiver's white neutral (to control the fan speed with the remote) AND the white neutral for the light to the same white (neutral) from the house? House wiring: Black ...
1
vote
0answers
28 views

How to connect 4 fan coils with one wall control thermostat?

I have 4 fan coils (Sabiana sk-22)and I want to connect them with one wall control thermostat. How can I do?
0
votes
0answers
51 views

Ceiling Fan turning off and not turning back on

I have a ceiling fan with lights and no pull chain. Recently when I would turn the lights on/off with the remote (two switches on the wall i think should control the fan/lights do nothing) the fan and ...
0
votes
1answer
99 views

Ceiling Fan Wires

I'm trying to install a ceiling fan in my new construction home. The fan's instructions call for 3 grounding wires (green, green/yellow stripe, or bare copper) to connect to the hanging bracket, 1 ...
1
vote
1answer
189 views

Ceiling Fan Universal Remote Wall Switch Install… Which wires?

Let me first state that I am very green to anything electrical. I know enough to hopefully not kill myself, such as to turn off power at circuit breaker AND to still test wires and switches with a ...
0
votes
0answers
15 views

Anyone have experience tweaking ceiling fan controller?

I have bought a new ceiling fan controller and the medium speed is weak. The ceiling fan control kit is similar to this, I suspect there is something I can tweak to spin it faster at medium speed. ...
0
votes
0answers
81 views

Ceiling Fan Remote Control Replacement

A (rental) house I just moved into has ceiling fans in the living, and bed rooms, all controlled (only) by remote controls. It's great that they're set up, and I've mounted the controls on the wall so ...
1
vote
1answer
106 views

Rewiring a switch controlled receptacle to a ceiling fan

I am trying to rewire our bedroom so that a switch that currently turns on/off a receptacle will instead control a ceiling fan and leave the receptacle always hot. Receptacle: Has 3 cables coming ...
2
votes
1answer
317 views

Wiring multispeed PSC motor from ceiling fan

I disassembled a ceiling fan to replace seized bearings. Unfortunately the pics I took to aid re-assembly are no longer accessible and the fan is an '80s era no-brand which I can't find any info for ...
1
vote
1answer
51 views

Surface mount ceiling fan

I have a Tri-State home with a center beam extending from one gable end of the house to the other at the peak. The beam is completely exposed in the living room. I installed a ceiling fan with light ...
0
votes
0answers
32 views

Lubricating ceiling fan bearings

I have a no-name ceiling fan that recently started making a faint but annoying grinding noise, like two dry pieces of metal rubbing together. The sound is continuous, not rhythmic. I'm assuming that ...
0
votes
1answer
70 views

Hunter Ceiling Fan No Longer Works

I hope you can give me a few suggestions with this one. We have a hunter ceiling fan that is wall switch connected for master power. This spring it started having a few issues. This fan is remote ...
0
votes
1answer
64 views

Corrosion of ceiling fan bodies & fan blades

How can I prevent corrosion of fan bodies & fan blades in Mumbai weather? Someone suggested we can apply coat of varnish but I fear heat generated due high speed rotation of fans can melt the ...
0
votes
1answer
107 views

Did I do a shoddy wiring job on a ceiling fan?

I just installed a ceiling fan at my mother's house, and in hindsight, I think I might need to go back and re-do the wiring. The ceiling fan came with a bracket that screws into the outlet box in the ...
0
votes
1answer
68 views

Installing a ceiling fan with remote

I have a white, black, red and bare cooper wires coming from ceiling. The fan I bought has a remote and the remote sensor is already installed/attached to the mounting hardware. The remote sensor ...
0
votes
2answers
65 views

Ceiling Fan issue

I had a ceiling fan in my kitchen (large vaulted ceilings with attic access) that I replaced with a new ceiling fan. Before the switch the fan and lights for the fan worked perfect. The new fan does ...
1
vote
1answer
283 views

How do change the wall switch for my ceiling fan from a variable fan/light combination to a single on/off switch?

I used to have a ceiling fan/light combination that was controlled by a wall switch the controlled both the fan speed and dimmed the light. I bought a new fan/light that is controlled by a remote ...
0
votes
0answers
53 views

New ceiling fan installed, lights are blinking when I turn the fan off

I just made settlment on my house on Friday and I just had a Hunter ceiling fan installed with a new controller plate as well. All of the wiring was intact to install the fan, the original owners took ...
1
vote
2answers
146 views

Is it safe or normal to close/cover junction boxes but use existing line to power new boxes just a few (6-12) inches away from the old ones?

We have 2 pendant lights hanging over a breakfast bar in the kitchen. The boxes are easily accessible in the attic. We'd like to move them back a few inches and then add additional wiring for a 3rd ...
1
vote
0answers
68 views

need help reconnecting wires inside my ceiling fan housing

So i tried scavenging the capacitor from an old ceiling fan and in so doing made a mess of all the wires inside the housing. The capacitor didn't work in my other fan so now i'm trying to wire the ...
2
votes
1answer
87 views

How do I separate these wires?

My ceiling fan stopped working and I want to remove the light box from the fan so that I can replace an in-line fuse holder. In order to separate the light box from the fan rotation device, I need to ...
2
votes
2answers
157 views

Accessing bulbs on ceiling fan

We just bought a house and it has this ceiling fan: The upper portion has bulbs in it, but for the life of me I cannot figure out how you'd get to them. The top of the unit has a metal plate secured ...
2
votes
1answer
1k views

Can I put dimmable LED bulbs in a ceiling fan fixture and wire it to a dimmer switch marked LED compatible?

Would there be any problems with putting dimmable LED bulbs into a ceiling fan fixture that holds three bulbs and wiring it to a dimmer switch marked LED compatible? The fan itself will be on just the ...
1
vote
1answer
60 views

Why do the lights turn off when I turn off the fan portion of my newly installed ceiling fan?

I installed a ceiling fan a while ago, Hunter brand. My room has two switches; one for light, one for fan. When I turn both of them on, but I just want to have the lights on, the lights go off when I ...
0
votes
0answers
313 views

Why won't my ceiling fan lights stay on?

So my ceiling fan light was working before I went on vacation, and now every time I flip the switch, the light comes on and then turns off. I've tried replacing the bulbs. I've tried only using two ...
1
vote
1answer
279 views

Help wiring Bathroom fan

I am not 100% sure how to wire my new bathroom fan, and I am looking for a little guidance. (This is for a NuTone QTN130LE1) Here are the existing wires in the attic. I have a white wire, a black ...
0
votes
1answer
458 views

Why does my ceiling fan turn off when I turn on the lights?

I just installed a new ceiling fan in my kids room earlier today. There are two switches on the wall. I started the day with a dimmer switch and a regular switch. Once everything was installed I ...
0
votes
1answer
50 views

How do I wire a ceiling fan with a light kit?

Ceiling has three wires: one white, one black, and one bare. Fan has four wires: one white, one black, one blue, and one green. How do I connect wires?
0
votes
1answer
101 views

Ceiling fan with two wall switches

I'm putting up a new ceiling fan. There are four cables in the ceiling and two wall switches. Black and white for one cable goes to each wall switch. The other two cables use only the black wire and ...
2
votes
2answers
321 views

Can you install a ceiling fan with a hickey and crossbar?

I have a concrete ceiling with an old-style electrical box that has a stud for a hickey, but does not have the traditional mounting holes for fixture screws, like the box in this diagram: Can I ...
0
votes
1answer
637 views

Ceiling fan works, lights do not

I will try to give as much information as I can. I have no experience with wiring so I imagine some of the things I did were incorrect and probably stupid. I purchased a Hampton Bay ceiling fan, and ...
2
votes
2answers
85 views

Can I connect the grounding conductor to the neutral when installing a remote for a ceiling fan in an ungrounded box?

I would like to install an in-wall remote control for a ceiling fan. The remote is wired up with two black wires (in and out) and a ground wire. It controls the fan's functions via wireless signal. ...
1
vote
0answers
38 views

ceiling fan not mentioned usage of watts

I bought new Havells ceiling fan. ceiling fan not mentioned usage of watts. I can see on box. 220-240v 50Hz. AC I am trying to find usage of watts. To calculate the current usage we need Amps ...
0
votes
1answer
512 views

Wiring a switch to (2) pendant lights, a ceiling fan (all new)

My existing is I have no ceiling lights or fan. I mounted two pendants and a ceiling fan that has a light. The only switch is one that controls the upper outlets so lamps can be used (which I hate)....
0
votes
1answer
106 views

Ceiling Fan Replacement - Wiring Issue

I am replacing a ceiling fan in one room and when I took the old one down I found 2 black wires tied together(one of which is hot), one white ground wire, one hot white wire, and one red wire, and a ...
2
votes
2answers
1k views

Why are there four electrical lines (12 wires) in this ceiling fan box?

My ceiling fan stopped working many months ago. I had somebody looked at it and they couldn't figure out what was wrong so I bough a new one today. When I dismounted the old one I found this strange ...
1
vote
2answers
1k views

Ceiling fan & light installation - can't get wiring right

I recently purchased and installed a Quorum 70443-14 fan with light. This model has no pull chains, and is operated by an in-wall "remote" that is hard-wired and not removable. The wall switch (that ...
0
votes
1answer
23 views

replaced recessed light w/ceiling fan, it seems I have to turn on at least one light to complete circuit

I replaced recessed can light w/ceiling fan, works great, if I want a recessed light on while ceiling fan is on. I do not. I need at least one working bulb in a socket it appears to complete circuit. ...
1
vote
0answers
132 views

Can I eliminate a switch controlled receptacle, and use the switch to control a ceiling fan instead?

I'm planning on installing a new ceiling fan and was hoping to have a few questions answered before I dive into things. First some context: The existing wall switch controls half of the outlet on the ...