0
votes
1answer
29 views

How should I wire a ceiling fan remote where two switches are used to control the fixture?

I have 2 wall switches. 4 wires coming out of ceiling (black-hot, red-hot, white-common, bare- ground), a ceiling fan and a remote. How do I wire them and still be able to use wall switches? I can ...
1
vote
1answer
45 views

14-2 Tap Branched From 12-2 Feed on 20amp Circuit…What To Do?

I have a switch by my front door that supplied power to a receptacle. I want to wire that switch to an existing ceiling fan/light combo in the same room. I've already made the outlet constantly hot. ...
0
votes
0answers
54 views

Ceiling fan wall switch issue

I installed a ceiling fan without a light in a location that previously only had a light. The fan has been working well for almost a year, but the wall switch has always had the speeds reversed (0 is ...
6
votes
1answer
465 views

Is it OK to run 12-3 cable to a ceiling fan from a switch that's wired with 12-2?

I'm installing a ceiling fan into a room that has no existing ceiling mount (no light or ceiling fan previously existed). I've got a ceiling fan mount in place with a supporting brace that can support ...
0
votes
1answer
142 views

Can I use a switch loop to power a ceiling fan?

Need your help, please. I have a single pole switch that controls the wall’s receptacles. It has one 14/2 cable, white/black/ground, where the white is hot. I would like to install a ceiling fan. I ...
1
vote
4answers
4k views

How do I re-wire a ceiling-fan to reverse its direction?

One of the ceiling fans at home was spinning in the opposite direction (clock-wise) and so was sucking up the air rather than blowing it. I live in a hot climate so we always have the fans spinning in ...
5
votes
1answer
1k views

What type of wire should I run when updating a ceiling fan?

I started to change out my ceiling fan and noticed the support brace is actually laying on the drywall and not firmly attached to a beam. I also noticed the new fan has a blue wire where the wiring in ...
1
vote
1answer
2k views

How do I know if a ceiling fan with light and the switch are wired correctly?

There was a old ceiling fan with light and remote in a bedroom of my house that didn't work. It also had a switch with 2 knobs that pushed in and turned labeled motor control and 300 w perm instld ...
2
votes
2answers
2k views

How do I wire this ceiling fan?

I'm trying to wire a new ceiling fan. The outlet box wires are White, Red, and Black. The ceiling fan wires are Black, Blue, White, and Green. The installation manual states to connect both ...
4
votes
2answers
11k views

What do I do with the unused wire for ceiling fan installation?

I recently replaced my bedroom ceiling fan with a newer ceiling fan and with the old fan I could: Use one switch on the wall to turn on/off the light Use the other switch on the wall to turn on/off ...
1
vote
1answer
114 views

How can I have a ceiling light and separate fan on the same switch?

I have two ceiling lights in the bedroom on the same switch. I replaced one with a fan with no light. Now I can not turn the fan on without the light coming on. How can I remedy this?
1
vote
2answers
440 views

Is it possible to replace a ceiling fan speed controller with a switch?

Is it possible to replace a ceiling fan speed controller with a switch? I just bought a house that had a ceiling fan with no light, which used a fan speed controller on the wall with different speeds. ...
2
votes
2answers
6k views

How can I separate a light switch to power two different devices?

My house had an addition after it was built - a covered porch which includes a lit ceiling fan. I very recently screened in said porch and love it out there. When the initial addition was put on, ...
4
votes
2answers
581 views

Installing a ceiling fan into a socket with 3 wires jammed into the socket

I recently purchased a ceiling fan thinking it would be a fun DIY project but when I went to install it, I came across many problems. I have attached a photo of my ceiling fan socket on the ceiling ...