4
votes
2answers
123 views

Dimmer switch not turning on light until at 50%?

I recently had a professional electrician install a ceiling fan with a light fixture. The fan and light are controlled from a combo switch with two knobs - one is a dimmer switch for the light, and ...
0
votes
0answers
137 views

how to wire two three way switch to a ceiling fan & add one switch for the fan and one for the light

I have two three way switch when I'm closing one of them switch , the fan is automaticly close with the light & I hate that because it's a big place & I'm short so it's hard for me to grab the ...
0
votes
0answers
54 views

How do I wire new recessed lighting and a fan?

My home office has two wall switches (double gang switch box w/incoming power), one controls a half switched outlet on opposite wall, the other controls a ceiling fan (w/light kit; not independently ...
1
vote
1answer
87 views

What would happen if I used a 3 speed fan control with a 4 speed fan?

I have a 4-speed Hampton Bay ceiling fan. I want to use a wireless remote control. I can only find wireless remote control kits that offer 3-speed settings. If I use a 3-speed wireless remote ...
1
vote
3answers
605 views

Newly installed ceiling fan, lights turn on and off on it's own - dimmer switch, breaker or light bulbs causing issue?

Help, I have a newly installed ceiling fan that is controlled by a remote control and the wall has a dimmer switch. (We had a smaller ceiling fan in place and replaced it with a larger fan to fit the ...
6
votes
1answer
244 views

Is it OK to run 12-3 cable to a ceiling fan from a switch that's wired with 12-2?

I'm installing a ceiling fan into a room that has no existing ceiling mount (no light or ceiling fan previously existed). I've got a ceiling fan mount in place with a supporting brace that can support ...
0
votes
1answer
99 views

Can I use a switch loop to power a ceiling fan?

Need your help, please. I have a single pole switch that controls the wall’s receptacles. It has one 14/2 cable, white/black/ground, where the white is hot. I would like to install a ceiling fan. I ...
1
vote
3answers
1k views

How do I re-wire a ceiling-fan to reverse its direction?

One of the ceiling fans at home was spinning in the opposite direction (clock-wise) and so was sucking up the air rather than blowing it. I live in a hot climate so we always have the fans spinning in ...
2
votes
1answer
96 views

What are the code requirements for installing a ceiling fan alongside a fire sprinkler?

I have a fire sprinkler in my bedroom ceiling which is right in the middle. I want to install a ceiling fan. What are code requirements to follow?
2
votes
1answer
3k views

What should I do with the extra grounding wire in my ceiling fan box?

I am installing a Hampton Bay Ceiling Fan that has a transmitter install for the remote. I have a green ground and a bare copper ground coming from my ceiling box. I have a green ground coming from ...
5
votes
1answer
788 views

What type of wire should I run when updating a ceiling fan?

I started to change out my ceiling fan and noticed the support brace is actually laying on the drywall and not firmly attached to a beam. I also noticed the new fan has a blue wire where the wiring in ...
1
vote
1answer
880 views

How do I know if a ceiling fan with light and the switch are wired correctly?

There was a old ceiling fan with light and remote in a bedroom of my house that didn't work. It also had a switch with 2 knobs that pushed in and turned labeled motor control and 300 w perm instld ...
2
votes
2answers
1k views

How do I wire this ceiling fan?

I'm trying to wire a new ceiling fan. The outlet box wires are White, Red, and Black. The ceiling fan wires are Black, Blue, White, and Green. The installation manual states to connect both ...
3
votes
2answers
5k views

What do I do with the unused wire for ceiling fan installation?

I recently replaced my bedroom ceiling fan with a newer ceiling fan and with the old fan I could: Use one switch on the wall to turn on/off the light Use the other switch on the wall to turn on/off ...
1
vote
1answer
161 views

How can I hang a ceiling fan with a 3/4 inch difference between the junction box and bracket?

I've taken down an old ceiling fan for replacement and found the octagonal junction box to be approx 3/4in above the ceiling, it isn't flush with the drywall which the new ceiling fan bracket mount ...
2
votes
1answer
233 views

Ceiling Fan - Single Switch, but Dual Switch installation

I have a two switch plate & installed a ceiling fan using dual switch instruction (white/white, black/ungrounded, blue/ungrounded). Fan & light work fine from one switch, but I learned second ...
9
votes
2answers
10k views

What do I do if there are only two wires coming from my ceiling electrical box?

I'm about to install several Hunter ceiling fans. This will be the first time I've done anything electrical past changing a bulb. The instructions that came with the fan show three wires coming from ...
2
votes
0answers
290 views

How do I troubleshoot an intermittent problem with a ceiling light/fan?

We have a ceiling fan that includes a light fixture. One day the light went off several minutes after turning it on. I checked the panel, and found that the breakers were ok. Room receptacles from ...
2
votes
1answer
383 views

Rewiring A Ceiling Fan - Add Wall Switch

I have ceiling fans in four rooms all with lights. The fans are hardwired to the breaker box, but the lights are on switches. I'd like to add another switch to control the fan, either on/off, or a ...
1
vote
1answer
105 views

How can I have a ceiling light and separate fan on the same switch?

I have two ceiling lights in the bedroom on the same switch. I replaced one with a fan with no light. Now I can not turn the fan on without the light coming on. How can I remedy this?
1
vote
2answers
3k views

What is causing a replacement ceiling fan light to flicker?

I had a Hunter ceiling fan with a light kit attached. It started making a humming sound and then a loud pop. This caused the circuit breaker to trip. After resetting the circuit breaker, the fan ...
3
votes
4answers
7k views

How do I troubleshoot a ceiling fan that suddenly stopped working?

I've got a ceiling fan in my kitchen that all of a sudden stopped working one day. No lights, no fan. Power is still up in the rest of the kitchen, and no breakers tripped. Is it common for a ...
8
votes
2answers
433 views

How can I install a ceiling fan that needs a 4“ box where I only have a 3” box?

As part of a home renovation project I discarded my old ceiling fan and have bought a new one. When installing the new one the electrician tells me that I have a 3" junction box and that I'll need a ...
4
votes
2answers
2k views

Can I screw a ceiling fan electrical box directly to the joist?

I am putting in a ceiling fan in a bedroom. It is a smaller one approx. 18 lbs. The remodeling-type expander brace failed, so can I just screw one side of the box to the joist? (I cannot access the ...
0
votes
1answer
306 views

Why does my ceiling fan pop and sizzle at one speed setting but works fine at another?

My ceiling fan that has been installed for 11 years will pop 1 time when I turn it on. Yesterday it popped when I turned it on then a few minutes later it started to make a sizzling noise followed by ...
2
votes
3answers
461 views

How do I remove a bolt that's stuck in a ceiling junction box?

I cannot get the bolt off the screw in a ceiling junction box. The junction box is damaged and I need to replace it to be able to put in a new one so I can rehang the ceiling fan. It's time for summer ...
0
votes
2answers
2k views

Why do the lights on my newly installed ceiling fan flick on and then off immediately?

We just installed our new ceiling fan with lights. The fan works fine but the light will flick on and then off again immediately. We took it back down and reinstalled it, ensuring that all wires were ...
4
votes
3answers
6k views

Why do light bulbs all over the house burn out disconcertingly fast?

I've found a couple answers to this question. This generally revolve around the scenario where it's bulbs in a general area such as a fan. My issue is that light bulbs all over the house burn out ...
7
votes
4answers
7k views

Should I put a dimmer switch on a ceiling fan?

I have a ceiling fan on our bedroom's vaulted ceiling. Since we don't want 7' pull-cords, the speed is stuck at full-tilt, which is no good. The fan has separate switches on the wall for lights and ...
0
votes
1answer
1k views

What could cause a ceiling fan to lose rotation speed?

I have two identical ceiling fans in my house that were installed around 4 years ago. One no longer rotates as fast as it used to at top speed. At a guess I would say it has lost 30 or 40% of its ...
1
vote
3answers
5k views

Is it possible to install a ceiling fan without an electrical box?

A while ago I had some electricians install a ceiling fan mount. Now that I've finally gotten around to installing a fan I've discovered that they didn't install any sort of electrical box to house ...
3
votes
1answer
4k views

How to tell if a ceiling junction box is braced to hold the weight of a ceiling fan?

My new home is almost done being built, and one of the extras I asked for was for two of the rooms to have junction boxes in the ceiling suitable for hanging a ceiling fan in the future. The light ...
0
votes
1answer
345 views

How can I get my ceiling fan lights working again?

After my light kit on my hunter type 2 fan stopped working I determined there is power entering this device (white wire) but none exiting it (pink wire). The pink wire runs to the pull chain for the ...
1
vote
1answer
5k views

Why does my ceiling fan light turn off by itself?

I have a remote-controlled ceiling fan and light. I don't run the fan, but when I turn the light on sometimes it will stay on for a long time then just go off by itself. I have tried both kinds of ...
2
votes
1answer
741 views

3-way switch for light with fan controlled by switch built into fan. Odd wiring layout. Wiring assistance required

My electrician and I have parted ways. This has resulted in my having to finish off various projects. I have managed to get 2/3 lights operating the way they were intended. However, I am having ...
0
votes
1answer
1k views

Why isn't the switch working to turn off my ceiling lamp after I replaced a fan w/light?

I have properly connected the new ceiling lamp. Once I turn the breaker on again, the lamp turns on immediately. There is a double switch on the wall. One used to turn on a standing lamp on the corner ...
3
votes
4answers
6k views

What could cause ceiling fan lights to flicker on with power and then go out immediately?

I have ceiling light fan. The fan works fine. The light used to work fine. All of a sudden one day the light started acting up. When I turn on the switch, the light flickers on for about a second ...
2
votes
2answers
6k views

How can I separate a light switch to power two different devices?

My house had an addition after it was built - a covered porch which includes a lit ceiling fan. I very recently screened in said porch and love it out there. When the initial addition was put on, ...
4
votes
2answers
524 views

Installing a ceiling fan into a socket with 3 wires jammed into the socket

I recently purchased a ceiling fan thinking it would be a fun DIY project but when I went to install it, I came across many problems. I have attached a photo of my ceiling fan socket on the ceiling ...
3
votes
3answers
4k views

How can I troubleshoot a ceiling fan light kit Issue?

I have an issue with my ceiling fan light; the light is on, then eventually over time it starts flickering off and on, eventually over time shutting off. I'll switch the light off, and then switch it ...
3
votes
2answers
2k views

How do I install a ceiling fan without creating holes in the ceiling?

I wanted to install ceiling fans in my house but there there were no existing outlets in the ceiling so I got an electrician to do it. He created 2 holes in the ceiling and 2 in the wall to run the ...
4
votes
2answers
1k views

Why does my fan switch sometimes turn the lights off?

I recently undertook a small project replacing a single toggle light switch with a Z-wave enabled dimmer switch, which is also wired to a fan toggle (a knob with 3 speed settings) in a 2-gang case. ...
5
votes
2answers
2k views

Why does using a dimmer with this ceiling fan and lights cause energy saving bulbs to flicker?

At a hotel I manage we purchased 34 ceiling fans with two integrated light sockets that operate on a dimmer all controlled by a remote control. Obviously using a dimmer with fluorescent bulbs won't ...
2
votes
1answer
4k views

How do I install a wireless remote for a ceiling light without a fan?

I have a fan with lights in my ceiling. There is no wall switch, only a wireless remote. I'd like to avoid installing a wall switch if possible. I purchased a chandelier assuming that I could just ...
3
votes
2answers
377 views

Is there enough here to get a ceiling fan?

I want need a ceiling fan in my living room. I looked at a few wiki-how type articles on installing them, and it looks like they need more than 2 wires, but when I opened up the light fixture on my ...
1
vote
2answers
801 views

My ceiling fan isn't getting the right voltage

My ceiling fan + light has stopped working. It turns out that the voltage reading at the ceiling is only 30V. I think that means that the motor on my fan isn't the problem, but that there's some ...
7
votes
1answer
2k views

What's wrong with my wiring?

I purchased a Hampton Bay remote for our bedroom fan this weekend. I have it installed and mostly working correctly, but there is one nuisance that still remains. We have two switches on the wall, ...
7
votes
1answer
532 views

Ceiling fan switch replacements

I have 2 ceiling fans that were in my house when I moved in. Both fans have recently had the pull strings torn out of the switch. I took the fans apart, and wrote down the information on the switch, ...
8
votes
2answers
1k views

What should I do about this fixture brace?

I'm preparing to hang a ceiling fan fixture in a bedroom. I need to remove an old ceiling light's electrical box and brace first, however I don't see how I can remove them. The brace has limbs which ...