The tag has no usage guidance.

learn more… | top users | synonyms

0
votes
1answer
13 views

Replacing an sink cabinet (48“) with a double sink (36”)

This is a very old kitchen. The cabinet I removed was there for most like ~30 years (minimum 20). I removed it but not sure of the next steps. The walls from what I can tell are plasterboard. The ...
2
votes
1answer
126 views

Kitchen cabinets - what thickness and type of backer board should be used?

When using a backer board for installation of cabinets, usually, at 34", 54"and 84", what thickness and type of backer board should be used? The walls in this old building remodel is plaster and ...
0
votes
0answers
22 views

Repair damaged kitchen cupboard door laminate

I have white gloss laminate on my kitchen doors. The cupboard next to oven has cracked and peeled on the corner quite badly. Is it possible to repair the covering or can I buy a sheet of the ...
0
votes
1answer
45 views

How feasible is kitchen cabinet refacing?

How feasible is it? I live in a 1500 sq. ft. house with a 10x12 ft. kitchen, no island. It looks like the material won't cost a lot. If I were to hire someone, I think it will take them 2~3 days ...
3
votes
1answer
73 views

Will 1x4's and 1x6's be enough for an aquarium stand?

I'm building an aquarium stand, with only wood and screws. I'm only equipped with a miter saw, a drill, and some hand powered saws and a leveler- this will be my first woodworking project. The goal is ...
0
votes
1answer
57 views

Help identify this cabinet clip used to mount face frame on cabinet?

This clip is used to mount a frame around a built-in oven. Some of the clips have broken and I'd love to replace them. The metal piece goes on the frame, with the plastic piece on the cabinet. A corse ...
2
votes
1answer
48 views

Is it acceptable to install new cabinets parallel with the floor rather than plumb and level?

My house sits on a slab that is currently not level. Given that I have plans to correct the foundation issues in about 1.5-2 years, does it make sense to install the cabinets so that they are squared ...
1
vote
3answers
95 views

New floor up to new cabinets already installed or under? New construction home

I purchased a new construction home through a commercial builder. I will be closing on the house in a few weeks and opted to do the hardwood floor myself to save some money. I did upgrade the ...
1
vote
2answers
38 views

Broken cabinet door.. Need help in identifying the part

My cabinet door is not holding in place any more because of a plastic broken part. I have also attached a pic of the same part that is intact for the other door. I am not sure what is the name ...
0
votes
1answer
101 views

36“ inch fridge won't fit 36” cabinet void

Is this a normal issue? 36" inch fridge won't fit 36" cabinet void. We put in the hampton bay pre-manned hickory cabinets / pantry floor to ceiling with a 36" upper spanning between them. We bought a ...
10
votes
5answers
6k views

How do I keep drawer knobs from loosening over time?

I see knobs like this on cabinets, dressers, and closet doors. They are held in place with a single wood screw. Very often they are loose. I guess when we grab them we often impart a slight twist. ...
0
votes
1answer
63 views

Fix Kitchen cabinets damaged due to fire

Please can you tell me what is the best way to fix these cabinets damaged due to fire. The right most cabinet has it's laminate peeling off and 3 other doors have some black stains. Is it best to just ...
0
votes
1answer
47 views

Do you use tempered glass for kitchen cabinet doors?

Do you use tempered glass for kitchen cabinet doors? This is for uppers. I'm wondering if it's recommended, mandatory (I'm in CA, USA), or overkill.
1
vote
3answers
48 views

How can I protect ultra thin paint on new kitchen cabinets?

I just got new kitchen cabinets, and the paint on the doors (which are hard wood) is ultra-ultra thin. It seems like it will scratch very easily. Is there a way to protect? They are being installed ...
1
vote
4answers
63 views

How to make a 12“ deep wall cabinet face be 15” from existing wall

I'm remodeling my kitchen. First major remodel. I have purchased 12" deep unfinished stock cabinets. I would like to make the face of the 30x30x12 wall cabinet that will be above the stove/oven be ...
0
votes
0answers
93 views

Support for DOMSJO double-sink without countertop on a single 36" cabinet?

The official instructions for the sink have 2 main points: 1- includes countertop, sink sits on top of it 2- has other cabinets on each side of the 36" cabinet where the sink sits. For me, there's ...
1
vote
2answers
608 views

What is this plastic insert called? (Secures a wood screw to a cabinet door.)

The European hinges on my kitchen cabinet doors are held in place with wood screws that anchor into plastic inserts - see the picture below. The one on the right is cracked. I would like to replace ...
3
votes
1answer
62 views

Identifying cabinet hinge

I'm renting this house and one of these hinges broke. 1.) Can I replace this hinge? 2.) If so, what's the model number/manufacturer?
1
vote
4answers
3k views

Countersink and Screw Size

I have been googling this for a few hours now and I really can't find a direct answer. This is a stupid question to validate my logic, however I like firm answers instead of assuming. I need a ...
1
vote
2answers
100 views

Unused live electrical wires in kitchen

I have unused live electrical wires coming out of wall in kitchen where new cabinets are going. How should I handle this?
9
votes
3answers
3k views

Is there any way to fix a hinge pulled out of particle board cabinet door?

I hit my head on the open door cabinet over the sink, yet again, and slammed the door shut in anger. Adding insult to injury, the whole hinge pulled out of the particle board and took a big chunk of ...
16
votes
6answers
20k views

How can I fill a screw hole so it can be used again?

My dishwasher attaches to the cabinets on the side via a screw. This hole has become a little stripped, is there a way to fill it in and then screw in to it again? I can't change the location of ...
1
vote
2answers
76 views

Can you replace upper kitchen cabinets without removing tile/glass backsplash?

Can upper kitchen cabinets be removed and replaced with new ones without damaging a tile or glass backsplash? If not, when the backsplash is removed, can it be done without damaging the granite ...
1
vote
3answers
42 views

Replacing a cabinet face

I've just moved into a new house and decided to paint the kitchen cabinets. Last night I took all the doors off and for the first time got a good look at the shape they're in. It's not so nice, ...
1
vote
2answers
114 views

Electric box for kitchen island cabinets

What kind of electrical box can be used in a kitchen island cabinet for a single duplex receptacle, where there is no structural members to attach an electrical box to? Here is a picture of the old ...
5
votes
4answers
17k views

How can plywood edges be finished to conceal the plies?

My cabinet doors are tired and have many coats of ugly paint. Rather than strip all the paint off, I'm considering just chucking the old doors and making new ones. I like the plain style of just a ...
0
votes
0answers
24 views

Cabinet bottom warping after microwave installation

I had a contractor install a mountable microwave underneath a cabinet. It seems there is a slight warping. The manual says the cabinet must be able to hold atleadt 90 pounds. Question: Can the ...
7
votes
3answers
587 views

Reinforcing a shelf supported only by pins

Our liquor cabinet has the usual row of holes drilled on either side for height-adjustable shelves, with typical shelf pins: I think the wood is MDF + veneer. It might be plywood. It's not holding ...
1
vote
1answer
48 views

new unfinished cabinets in bathroom

The cabinets in my bath are new and unfinished. What is the best way to protect the wood? I would like to stain rather than paint. Do I need to cover with polyurethane after I stain? Also, what is ...
4
votes
3answers
24k views

How can I refresh the finish on my kitchen cabinets?

I am getting ready to put my house on the market and I would like to clean \ "restore" my kitchen cabinets. They are an oak cabinet that aren't painted, they are stained. I don't know exactly what ...
2
votes
3answers
151 views

Looking for a particular dual-track shelving bracket.

I'm considering a dual-track wall shelf system for our living room: (Photo from Home Depot/Rubbermaid) I'd also like to hang a few things from the tracks other than shelves. For example, I'd like ...
1
vote
1answer
316 views

Cabinets with existing dowels in the wrong place. How do I fill for new hinges?

My cabinet hinges are the sorely inadequate euro hinges that used a piece of plastic to hold the door shut. These plastic pieces have broken on nearly every cabinet which requires the entire hinge to ...
2
votes
3answers
1k views

How do I stop my in-cabinet lights from falling out?

I bought a house three months ago and I'm slowly getting around to different projects. We have beautiful halogen in-cabinet lights above our kitchen sink but the light fixtures seem to fall out every ...
1
vote
1answer
77 views

Are stainless steel garage cabinets suitable for unheated garage?

I am considering adding stainless steel garage cabinets to my garage such as this one. As you know they are not cheap. My concern is my garage is not heated and it gets wicket cold in north east ...
1
vote
1answer
173 views

Above cabinet LED light placement

I am considering installing LED tape lights for under/above cabinets in my kitchen. For under cabinet lighting, placement is easy and obvious. For above cabinet lights, I wonder what to do. The ...
0
votes
2answers
214 views

Heat shield for pantry cabinet?

The wonderful designers of my kitchen installed a tall (oak) pantry cabinet next to the range. I am concerned that this is a fire hazard. Is there anything I can do to mitigate the heat from the ...
1
vote
1answer
89 views

What shelves to get for a china cabinet?

I just purchased a somewhat old China cabinet. It has 2 heavy, thick glass shelved. One shelf is cracked so I plan to replace both shelves with painted wood shelves. The width is 40 3/4 inches by 15 ...
0
votes
1answer
178 views

How to install crown molding or valance board around a cabinet?

I am replacing the cabinets in my kitchen and am going to be installing some crown molding (actually a valance board and then crown molding) around the top of the cabinets, as in this picture. The ...
7
votes
4answers
12k views

How do I install cabinets on a floating hardwood floor?

We just purchased a bunch of cabinets for installation of a bar / kitchenette in the basement. There are 4 wall cabinets and four base cabinets. These are going to be installed on the existing ...
1
vote
2answers
112 views

Receptacles in Kitchen Cabinets

I am roughing in some plugs in my kitchen for when the workers come and hang the cabinets. I am getting cabinets with LV lights on the underside of them. The cabinet makers asked me to make sure I ...
4
votes
4answers
799 views

How to determine if hardwoods are under cabinets?

I'm house shopping and some homes have built-ins or kitchen cabinets that I'd like to remove. I was wondering, first, is it possible to determine without taking the cabinets apart whether there are ...
1
vote
1answer
2k views

Can I hang cabinets and shelves on metal studs?

I recently moved into a high rise apartment and need to hang some cabinets. The cabinets themselves weight about 20lbs and I'm thinking the stuff stored inside them will be around 40lbs. I know I ...
0
votes
0answers
20 views

What load rating for securing bookcases/cabinets with anchors?

I have two full-height bookcases that I want to anchor to a concrete wall. Unfortunately I think I have only 3/4" max. embedment because of pipes, etc. I can only find two anchor options, a #6-3/4" ...
2
votes
2answers
290 views

Cabinet door opening on it's own, how do I adjust this type of hinge?

One of the cabinet doors in our kitchen is swinging open on it's own. You shut it and it slowly creeps back open. I've seen the hinges that allow you to adjust x/y axis angles but these only have ...
1
vote
3answers
101 views

update/refresh kitchen cabinets

I have builders grade cabinets. They are smooth fronts (sort of modern) they are dark brown and not varnished or stained. I think sort of melamine front....definitely a man made product...so I can't ...
1
vote
0answers
165 views

Converting 120V undercabinet lighting to 12V strip lighting

We redid our kitchen cabinets and want to change from the previous hardwired 120V fluorescent under cabinet lighting and above cabinet cove lighting to 12V flexible LED strip lighting. The cove ...
2
votes
3answers
2k views

What translucent material can I use to cover the bulbs at the top of a medicine cabinet?

I am restoring a medicine cabinet that has light bulbs on the top but no covering. Should I try to cover that area with glass (I'd like something frosted or opaque) or is there some type of plastic ...
2
votes
0answers
239 views

Broken cabinet hinge?

I noticed that one of my Mepla kitchen cabinet hinges looks like it's broken, as the swinging arm (from the door) at the lower left of the picture is no longer connected to the mounting plate (that is ...
5
votes
3answers
6k views

Should I be concerned about fridge/freezer airflow?

We just recently had the following counter/cabinet system put into our basement family room. After everything was done, I started to get concerned about airflow. The enclosure was built in such a ...
2
votes
1answer
12k views

How do I re-attach my kitchen cabinet's laminate?

Steam from my electric kettle has caused the veneer of one of my kitchen cabinets to separate from the doors and I need to stick it back on. What is the best method to use? Should I peel the veneer ...