The tag has no usage guidance.

learn more… | top users | synonyms

2
votes
1answer
597 views

Why does half the house go out when a single breaker trips?

The breaker box at my brother's house is well marked and balanced except when a breaker is tripped half the house goes out. I'm currently living on the third floor of his house. When I turned on a ...
12
votes
7answers
37k views

What is simplest strategy to map circuits to breakers in the panel?

My breaker box is very poorly labeled and I want to figure out which circuits may have overloaded (or close to it) and which could reasonably handle a little more. In the past I have just tried ...
4
votes
1answer
3k views

What is permissible for a breaker box cover?

We're doing some remodeling in our kitchen and unfortunately the breaker box is right in the middle of a wall we are going to cover with tile. My current thought is to replace the existing metal ...
4
votes
5answers
7k views

How Do I Power A 220 Water Heater Off Two 110 Breakers

First off I know this is not the best idea. To start my 200 Amp Main has suffered a partial failure and as it is old (60s) and unusual it will be very hard or impossible to replace it. Since the main ...
5
votes
1answer
155 views

Can I use a hot wire on another panel?

I have a room upstairs that's the size of a small studio apartment. My daughter decided to move back home but my tenant noticed that the room she moved into is tied into their apartment. I went to the ...
12
votes
4answers
1k views

What is this 110/24V 60Hz transformer in the breaker room for?

My friend sent me a photograph of this transformer, which is installed above the main breaker panel, with leads running from the panel into the transformer. The stamped labels read PRI. Volts: 110 ...
6
votes
5answers
7k views

Does a grounding wire from a breaker panel to an outside grounding rod need to be in conduit?

I've got a breaker panel in my detached garage (it is not a sub-panel, but is a primary forked off just past the meter). The panel seems to be wired correctly- the neutral and ground bars are tied ...
3
votes
2answers
534 views

Should I run 2 regular circuits or a subpanel to my septic site?

We're installing a septic system on otherwise undeveloped land. Eventually there will be a house near the septic system, but that could easily be years away. The electric service entrance is on a post ...
8
votes
2answers
2k views

Large voltage swing on incoming main hot line- definitely outside?

So for much of last fall, I had an issue of flickering lights in my house (half of the house seemed to flicker in unison). Back in December, I called the electric company, who came out, and claimed ...
7
votes
2answers
13k views

Can I install an additional breaker bus bar on my main breaker panel?

I'm adding several new circuits to my main electrical panel as part of a kitchen remodel. The panel with accommodate the new circuit breakers, but it does not appear to have enough neutral and ground ...
5
votes
2answers
4k views

Why doesn't the main breaker shut off power for house?

Location: California | United States I'm certain I'll need a licensed electrician for this but wanted to get thoughts on what could be going on. I recently noticed that power remains on in my house ...
8
votes
1answer
1k views

Is some asymmetry in a breaker box normal? What about neutral to ground having voltage?

So, next in my quest to evaluate the health of my new home's electrical system, and call in professionals if needed, was some voltage checking of the panels/outlets around the house. What I have is a ...
15
votes
5answers
122k views

Is it ok to have mixed grounds and neutrals on bars in a breaker box?

So to continue my line of electrical questioning (and perhaps narrow down my flickering light problem), I took a look through the two panels in this house. There is a 200amp main service in the ...