2
votes
0answers
39 views

Is it ok by code to enclose a residentail breaker box in a finished basement as long as there is an access door and what are the requirements? [duplicate]

I am finishing a basement and want to enclose the 200a service box and wiring with a framed cabinet of some sort. Is there any requirements for clearances and what you can enclose it with? I am in ...
3
votes
2answers
674 views

Can I terminate a ground wire to the neutral bus if the ground bus is full?

I have a Crouse-Hinds main load center. The ground bus is at the top left of panel and the neutral bus is at the bottom right of the panel. I want to add a 15 amp circuit for two outlets in my ...
3
votes
2answers
2k views

Does it matter if I mix neutrals and grounds in the main panel?

Code question here. I do a lot of electrical and like to follow code exactly. I have done pretty much everything but hook up lines to main box. Taking a stab at it this time. First I see that I ...
2
votes
2answers
2k views

Can I extend the ground/bus bar in a main service to accomodate subpanel equipment ground?

I am about to replace the main service breaker panel in my house. The old panel (a 200amp Siemens 40-circuit) had bus bars that extended the entire vertical length of the box. The new panel I would ...
5
votes
2answers
5k views

Is it code-legal to have a circuit breaker box within a storage room?

I am currently in the process of planning a room remodel to convert an existing bedroom into a home office and storage room. One thing that makes this conversion a little bit tricky, is the existence ...
4
votes
1answer
817 views

What is permissible for a breaker box cover?

We're doing some remodeling in our kitchen and unfortunately the breaker box is right in the middle of a wall we are going to cover with tile. My current thought is to replace the existing metal ...