The tag has no wiki summary.

learn more… | top users | synonyms (1)

2
votes
1answer
30 views

Can I glue vinyl flooring to my bathtub's side panel?

We’ve just bought our first house, and obviously have very little money at the moment. The bathroom is horrible and we’d like to make some small changes to at least make it look slightly nicer. As ...
1
vote
2answers
14 views

Squeaking fiberglass bathtub

I have a fiberglass bathtub in my mobile home that is roughly 5' x 4' in size. The mobile home is a 1978 doublewide, and the tub was in the home when we purchased it, 5 years ago, so I'm sure it's ...
2
votes
1answer
41 views

The weird bathroom tub leak that went away

Something strange happened in my bathroom, for a few days the tub spout was leaking non stop. During that time the water pressure had been low and there was no hot water. I thought that the leak was ...
0
votes
0answers
31 views

How do we remove a 1940 Crane tub spout base adapter that is inside the wall?

We have a 1940 Crane bathtub spout that leaks when the shower-head is on. We want to replace the spout, so we have removed it but need to remove the base adapter (correct term?) that is inside the ...
3
votes
1answer
272 views

How can I move a tub drain plunger, if the linkage chain is missing?

The broken linkage chain was removed from our tub a couple of years ago. All has been good until now the plunger has fallen shut and the water drains v e r y, v e r y s l o w l y. any suggestions how ...
0
votes
1answer
42 views

Leaking whirlpool tub; in alcove, but no tile flange at bottom of walls

In brief: my alcove whirlpool tub has always leaked at the seam between the tub and tile wall, and it needs to be fixed. I just discovered that this tub has no tile flanges where it meets the walls; ...
3
votes
1answer
877 views

Why does my bath faucet drip for a few minutes after it's shut off?

I have a traditional two handled (one hot and one cold and they are separate) bath faucet. I recently had it reseated and the washers replaced, however, what I noticed was that immediately after shut ...
1
vote
0answers
51 views

The tube drain pipe is in bad shape

Okay, two months or so ago I had the drains in the house snaked because of slow draining at almost all of the fixture sites. After the plumber was done, everything was great, but two days ago I walked ...
3
votes
5answers
22k views

Why does my shower head drip when the tub faucet is on?

I just installed a new tub fixture set: There are two controls - one for temperature and one for volume. The large handle is volume. When the diverter valve is engaged the shower sprays properly ...
1
vote
1answer
42 views

Stuck tub drain

I am having trouble removing a tub. Specifically, I cannot seem to loosen the drain. I've tried a proper tub drain wrench, but it still won't budge. Any ideas how I can get this thing to loosen?
1
vote
1answer
26 views

How can I remove the faucet cover I dropped down the drain?

I dropped the plastic (H) round faucet cover of my bathtub faucet down my tub drain, and now the water will barely drain out. What do I do.
1
vote
1answer
102 views

Bathtub separating from wall

I recently bought an older house. It has had some work done in the master bath, and I just noticed that the tub is separating from the wall. What would be the best way to fix this? Oh I should mention ...
0
votes
1answer
120 views

I am trying to identify the brand of this bathtub faucet

I am wanting to replace this bathtub faucet without changing the plumbing behind the wall. I am assuming by identifying the brand/type of faucet already installed I could have success by getting ...
0
votes
1answer
162 views

Is it okay that my bathtub is not level?

I'm in the process of remodeling a bathroom. I am down to the studs. I am a bit of a perfectionist and find the bathtub itself is not made completely level. Is this normal?
0
votes
0answers
15 views

Greasy Bathroom Door

I have a bath door that surprisingly gets tacky with like a grease, the paint is not tacky but it seems to get greasy. What could this be. Moisture, air flow. Not sure what to do.
1
vote
5answers
7k views

Should galvanized steel pipe be used as a tub spout?

I have a 90 degree fitting coming down from my shower valve. Also have a screw on tub spout trim. Right now there is a 6" galvanized pipe that connects the 90 to the tub spout trim. Is the ...
4
votes
4answers
631 views

How do I fix my clogged bathtub drain?

I have a trip lever drain in my bathtub. Thought it was the problem, but it's completely out and the tub still won't drain. Any ideas?
1
vote
2answers
41k views

What type of tile should I install in a bath/shower surround?

I am about to remodel our bathroom. Currently the tub/shower is all tiled but the backing is not secure/stable so there is cracking in the grout and I know water is getting behind. I prefer the look ...
4
votes
5answers
20k views

What are the pros and cons of adding a vapor barrier behind shower backer board?

After much research, I have a lot of conflicting advise about the need to add a vapor barrier before installing the backer (hardy / cement) board for my bathroom shower. The "expert" at Home Depot, ...
2
votes
2answers
88 views

Soaking tub on the second floor: safe?

I am considering getting a soaking tub (pdf here) for my second floor master bathroom. However, I am unsure of how much weight the floor and walls below can support. The house itself is wood frame ...
2
votes
4answers
25k views

Grout or caulk between acrylic bathtub and tile?

Contractor who remodeled our bathroom used non-sanded grout between bathtub (acrylic) and first layer of tile. He said that he recommends that instead of caulk as caulk will be trapping moisture and ...
0
votes
0answers
45 views

How to install bathtub

I want to install a tub on basement bath where drain pipes are already installed and sticking out from concrete floor. I need to know how to raise the level of the tub from the floor in order to have ...
0
votes
1answer
3k views

Bathtub trip lever broken and detached

I have somehow broken the bathtub trip lever and it is detached from the inside. How easy is it to fix it? I am worried that whatever (chain, rod) that is behind the bathtub might be falling down to ...
1
vote
1answer
51 views

Brass tub overflow pipe stuck in brass tee. How can I remove it?

I am repairing a tub overflow. The screws for the cover plate were very corroded and broke off. I am trying to remove the overflow fitting and pipe but it is stuck. The pipe is brass and slides into a ...
1
vote
1answer
73 views

How long should thinset dry before gluing up tub surround?

I replaced the walls in my bathroom and used concrete board around the shower. I plan on finishing the concrete board joints with the proper mesh tape and (premixed) thin-set as recommended but ... I ...
1
vote
0answers
60 views

Bathtub shower leaks in wall only when turned off

Our upstairs bathtub has a small leak inside the wall that over time softened the ceiling sheetrock below. After removing the sheetrock we tested the shower, and it's weird -- it leaks about 1/4 cup ...
1
vote
1answer
36 views

Bath Tub replacement

We're in the process of looking at getting a cracked fiberglass tub/shower replaced. We had one contractor come out that recommended using an acrylic AKERbyMAAX tub. I'm ok with the acrylic tub, but ...
1
vote
0answers
26 views

Leaky bathtub, need to fix the passthrough hole for the extension

Sometimes when we use the bathtub we get water dripping downstairs, in the kitchen. This morning I've removed the cover of the bathtub and figured that the hole for the extension cord of the shower ...
0
votes
0answers
28 views

Should I apply grease to my bathtub drain stopper

My bathtub drain is the standard plunger style. We were batting about .300 when we lift the lever, either it would seal perfectly or not at all. At first I thought it was the length of the plunger, ...
1
vote
0answers
31 views

Bath handles hanging and small chip in enamel

We let our house for 5 years to uncaring tenants. The bath (was new) now has the grip handles hanging off both sides and there is a small chip in the white enamel. It was assumed the bath would need ...
0
votes
1answer
34 views

water proof tub surround?

I have a basement bathroom with a tub/shower that I plan on tiling. My questions are- Is Duruck, Hardie board and wonderboard the same? The area behind the tub/shower will be unfinished/no drywall, ...
1
vote
0answers
94 views

Should I build tub/shower niche or ledges?

There is 7-8" in front of tub to frame. Will use 4x4 white tiles. What's best? Multiple ledges--framed shelves to fit 4x4 tiles to minimize cutting. Or Large niches/borders that will be framed to ...
1
vote
1answer
92 views

How do we polish an old damaged bathtub?

We have a circa 1940 porcelain bathtub in a rental that has mild pitting and moderate discoloration. Is there an effective way to buff and polish the surface to make it look significantly better? ...
3
votes
5answers
1k views

How do I clean my jetted whirlpool tub?

The master bath of our new house has a jetted whirlpool tub. We haven't used it yet, since the previous owners were, um, lacking hygiene. Is there a good way to clean it out without taking the whole ...
0
votes
0answers
34 views

Caulking around tub

I've got a tub that kind of looks like this: http://inspectapedia.com/plumbing/Spa_Jacuzzi_137_DJFs.jpg I am replacing the caulk, and noticed that on the far side, the gap is about 1/4" in height ...
1
vote
1answer
70 views

How can I attach a new drain to a drain pipe that's fallen away from the tub?

Hello everyone, Noobie here and I think I shot myself in the foot! I wanted to replace the old drain with a new one so my almost 2 year can have bubble baths. I was able to remove the old drain ...
1
vote
1answer
180 views

how to setup bathtub spout and shower head in separate locations

I am installing a new bathtub that is big enough for two people. with one person leaning against each end of the tub. So I want to have the shower head in the usual position at the end of the tub, ...
5
votes
2answers
156 views

What is this crud in my shower valve, and how can I prevent it?

I just replaced the pressure balancing valve and valve mixer cap in a shower that had lost its hot water. Replacing the parts fixed the problem, but when I pulled the old valve out, it was covered ...
2
votes
2answers
899 views

Should I use Kerdi membrane or cement backerboard?

I have to redo my tub surround due to moisture leaks and failing grout. One of the company says they are going to apply kerdi membrane on the drywall, then tiles onto the kerdi membrane, and as such ...
0
votes
0answers
19 views

How can I stop this Shower faucet leak?

replaced the pfister diverter stem with a new one, tub spout still leaks water when diverter switched to shower position. It appears the problem is inside the manifold. I cleaned the inside and looks ...
3
votes
3answers
9k views

How do I replace a broken bathtub drain?

I am trying to replace my bathtub drain however the cross bars have broken off so I am unable to unscrew it from the tub. How can I unscrew it? EDIT: This is approximately the product I am trying ...
3
votes
1answer
2k views

How does an external tower style bathtub drain work?

I have this style tub drain and can't figure out how it works. Does it simply block the flow of water when lowered? Or is there something more complicated happening? My tub has stopped draining and ...
1
vote
2answers
4k views

Questions about shower wall tile install

I'm getting ready to install 12x12 ceramic tile on our tub walls. What type of thinset should I use? Ancillary to that is the type of grout to use? Sanded or unsanded? While researching the ...
8
votes
2answers
37k views

Should the backer board be in front of or behind the tub flange?

I'm installing a new bath tub and shower. I've removed the old tile down to the studs. Should the backer board be in front of or behind the tub flange? I put it on the rear tub wall from floor to ...
5
votes
5answers
52k views

How do I remove a stuck faucet/tap cover?

I've been fixing leaking faucets in a bathroom. There are total six faucets in a bathroom, two made into a bathroom basin, two made into the wall in the shower tube and the last two are on the wall ...
0
votes
0answers
31 views

Solving a urine smell in small 1/2 bath

Here is what I have: one sink 4.5 feet from my soil pipe I'm using a Genova special waste and vent fitting. This has a 2" venting pipe going straight up and out of my roof 18" to 24" above the roof ...
4
votes
1answer
13k views

How do I patch rusty spots in bathtub?

One of the tubs in our new home has a few spots where the enamel is chipped away and the metal underneath has started rusting. I don't want to replace the tub yet, so how can I clean and patch the ...
2
votes
1answer
44 views

dripping water from the shower area

Just moved into our new rented apartment and having trouble keeping the water from dripping out the bath tub area. the side of the shower curtain that is closer to the shower head is okay as we have ...
0
votes
2answers
155 views

Stop bath squeaking

I have a bath as shown in the attached images. It squeaks a lot. The bath sits on a chipboard floor as shown. The vertical gap between the chipboard floor and the suspended bath is 14cm. I ...
3
votes
3answers
1k views

How do I replace shower / tub handles / spouts?

I recently bought a house with 20 year old fixtures 3 bathrooms including a shower, shower/tub, and roman tub. The shower knobs say Harden on them and the tub/shower knob has a separate tub/shower ...