The tag has no wiki summary.

learn more… | top users | synonyms (1)

1
vote
2answers
77 views

What is best way to caulk this improperly installed bathtub?

How do I caulk this beast? I was trying to replace the caulking, took out the old caulking to find out that the bathtub was improperly installed, and the tiles are not over the lip. There is this half ...
0
votes
1answer
310 views

How do I patch a gap between my bathtub and wall?

The wall of my bathtub was cut too short when installed and water leaks to downstairs when I take a shower if it gets into the space between the tub and the wall. My father has tried caulking and even ...
4
votes
4answers
169 views

How do I fix my clogged bathtub drain?

I have a trip lever drain in my bathtub. Thought it was the problem, but it's completely out and the tub still won't drain. Any ideas?
1
vote
1answer
31 views

How can I repair a bathtub that is peeling?

My bathtub surface paint is peeling but I don know how and what the material is I never seen a bath with this kind of surface before so what can I do or use to fix the problem?
2
votes
2answers
206 views

What might cause water to leak under or behind a bathtub?

The floor in my bathroom is constantly wet after showers. House was built in 1970 and this bathroom is all original. From the yellow tile down to the linoleum. The shower curtain is sealed, the ...
0
votes
2answers
132 views

Bath tub spout rough in

I am surprised it is so hard to find a diagram or description of the proper way to rough in a bathtub spout. In case it makes any difference, the specific spout will be a Toto TS210EV with diverter. ...
1
vote
1answer
219 views

How to change a bath plug chain?

I have been looking around for a tutorial to chane a simple bath plug chain. My chain has snapped, so the plug is not connected. I assumed it would be a simple job, but i can't find anything online ...
3
votes
1answer
90 views

Shower Pressure Decreases after thumping noise behind wall

With the shower on, I hear a thumping noise behind the wall and the water pressure immediately drops. This happens every few days, so not every time I take a shower. It happens almost immediately ...
3
votes
2answers
77 views

Epoxy fumes won't leave our home. Help!

So my husband decided to paint our smurf blue tub and shower with an epoxy white paint. He used two cans that came with the kit and it didn't cover. When the nearest Lowes was without another spray ...
0
votes
3answers
76 views

Manufactured home bathtub/shower wall installation

We purchased a 15 yr old mfd. home. Master bath has an ABS(?) bathtub with separate shower walls. It's serviceable, but will eventually need to be replaced(ugly). A: I would like an all in one insert ...
4
votes
4answers
54k views

How soon can I use my shower that I recently grouted and tiled? Should it cure first?

We have been retiling my tub surround area and finished grouting the tile last night. I used non-sanded PolyBlend grout (sold at Home Depot) and added a bottle of Grout Boost Advanced Pro. Everything ...
1
vote
1answer
56 views

How can I remove this bathtub drain?

I have this bathtub that had a trip lever drain that kept getting stuck so the water would not drain unless you have a foot on the trip lever while you're showering (not ideal). I decided to replace ...
5
votes
1answer
2k views

Tile Around bathtub. Over drywall vs. vapor shield & backerboard

I am remodeling my bathroom, and the last step is the tub. The Place for the tub was about 3 inches longer than the tub, so we built the wall out by putting drywall over the studs. I keep reading ...
0
votes
0answers
48 views

What can I do if the sink tailpiece is too close to the wall?

I have a small Porcher brand, Elfe model, sink, whose tailpiece is only 4 inches [OC] from the finished wall. One solution is a non code compliant bottle trap, but is there a code compliant solution? ...
8
votes
4answers
832 views

How to fix small holes/separation in caulk around bathtub?

I'm sure this is a relatively simple task but I've never done it before and want to make sure I get it right. There are some holes/separation appearing in the caulk between the bathtub and the wall ...
2
votes
2answers
1k views

What are the pros and cons of adding a vapor barrier behind shower backer board?

After much research, I have a lot of conflicting advise about the need to add a vapor barrier before installing the backer (hardy / cement) board for my bathroom shower. The "expert" at Home Depot, ...
1
vote
2answers
913 views

Questions about shower wall tile install

I'm getting ready to install 12x12 ceramic tile on our tub walls. What type of thinset should I use? Ancillary to that is the type of grout to use? Sanded or unsanded? While researching the ...
6
votes
7answers
17k views

How do I retrieve a detached plunger from a bathtub drain?

I have an old bathtub drain assembly that is similar to this: As far as I can tell, the linkage broke off completely due to old age. If I unscrew the trip lever and cover, it's not attached to ...
4
votes
3answers
1k views

Why does cold water always mix in bathtub mixing valve, even on hottest setting?

I have a single-handle (rotates 270 degrees) faucet in my tub/shower. I've noticed that it is always mixing in cold water, even when turned all the way to hot. I can prove this by holding the cold ...
1
vote
3answers
459 views

Who manufactures this bath tub faucet?

I have a bath tub faucet that leaks and needs valve replacement. No one seems to know what kind of faucet it is. I have sent a picture of it to the major suppliers and no one seems to know. Maybe ...
2
votes
4answers
9k views

Why does my shower head drip when the tub faucet is on?

I just installed a new tub fixture set: There are two controls - one for temperature and one for volume. The large handle is volume. When the diverter valve is engaged the shower sprays properly ...
2
votes
1answer
46 views

How do I restore the original finish of a reglazed plastic tub?

I bought a house a few years back. The previous owner had reglazed the plastic tub and wall unit and the glazed paint is starting to peel and looks pretty bad. How do I remove the glazed paint to ...
2
votes
1answer
137 views

How do I snake this tub drain?

I have a Trip Lever Plunger Style Stopper. I removed the faceplate and there was no plunger attached to it or in the pipe, and it seems like the stopper closed. Why i say this is because when we ...
1
vote
3answers
194 views

How can I fix floor cracks in bathtub (enamel?) coating?

We just moved into our new home (not a new build) and noticed flaking of the material in the bottom of one of the bathtubs. It appears as though the coating (enamel?) has flaked away in some places. ...
1
vote
1answer
566 views

What caused a stuck tub drain stopper linkage and how do I fix it?

I have a tub and shower combination. It has a plunger stopper assembly which was not holding water and the lever would not function correctly. I removed the assembly, cleaned it with vinegar and ...
4
votes
6answers
4k views

How can I fix a bathtub that was not set properly?

I think the floor was not prepped correctly. The tub creaks a lot and there is a great deal of vertical play when standing and moving around. The tub does appear to be level, so I don't think that's ...
2
votes
1answer
163 views

Is caulk sufficient to seal around my new bathtub?

I installed a new tub which does not have a flange. Before I put up Duraboard what product, if any, should be used to seal the space outside of the tub's edge (garden/jacuzzi type of bathtub edge). ...
11
votes
4answers
8k views

How can I prevent spillage from my bathtub?

Let's set the scene: The horizontal surfaces of the bathtub in my apartment are flat. We have a double shower curtain (with the waterproof bit that hangs on the inside of the tub and the fabric bit ...
1
vote
3answers
2k views

Grout or caulk between acrylic bathtub and tile?

Contractor who remodeled our bathroom used non-sanded grout between bathtub (acrylic) and first layer of tile. He said that he recommends that instead of caulk as caulk will be trapping moisture and ...
0
votes
0answers
380 views

How can I repair broken off screws in tub overflow pipe?

Water has started leaking from my tubs overflow drain, down into a garage below. My tub's overflow pipe is brass, and the two broken off screws in it are steel. Their stubs are about 1/4", weak, very ...
1
vote
0answers
67 views

Is there a way to install a tub such that it can dry out if water gets behind it?

When you install a tub, you try to build the surround such that water can't get through to the wall. That's great. Nothing is perfect, and eventually small amounts of water will seep through. Then ...
1
vote
1answer
284 views

How do I repair broken bathtub faucet handles?

How can I repair the faucet handles on my bathtub? It snapped off then when I was trying to use it; it shot off the wall and water constantly pours out where the handles go.
7
votes
2answers
9k views

Should the backer board be in front of or behind the tub flange?

I'm installing a new bath tub and shower. I've removed the old tile down to the studs. Should the backer board be in front of or behind the tub flange? I put it on the rear tub wall from floor to ...
4
votes
3answers
479 views

Can I fill the void behind the shelves in a tub surround with polyurethane spray foam for added strength?

My wife and I plan on putting up a tub surround. I have researched a bunch of these and on a few of the reviews I have read that the shelves are flimsy. The surround she likes (therefore the one we ...
1
vote
0answers
22 views

How do I prevent water from leaking from my bath faucet when the shower is on? [duplicate]

When the water is diverted to the shower, water leaks back from inside the faucet towards the wall. How do I fix it?
3
votes
5answers
12k views

Is there an approved way of fixing a cracked Fiberglass Tub/Shower?

I noticed a crack in the bottom of my tub, and noticed that it flexed when I stepped near it. I called in 2 companies to give me an estimate on repair. The first, proposed a more or less ...
4
votes
2answers
884 views

How should I seal a shower base that is leaking?

I have a shower stall with a cement-like slab base. The shower base is ancient and has developed some cracks. The top surface has some sort of sealant which has worn away, with the result that water ...
3
votes
4answers
638 views

How do I clean my jetted whirlpool tub?

The master bath of our new house has a jetted whirlpool tub. We haven't used it yet, since the previous owners were, um, lacking hygiene. Is there a good way to clean it out without taking the whole ...
3
votes
0answers
140 views

How can I move a tub drain plunger, if the linkage chain is missing?

The broken linkage chain was removed from our tub a couple of years ago. All has been good until now the plunger has fallen shut and the water drains v e r y, v e r y s l o w l y. any suggestions how ...
0
votes
0answers
31 views

movable bath screens

I would like to have a bath with bath screen that is movable to the shorter edge of the bath. The problem is that I would also like to have my tap on the same shorter edge of the bath which would ...
1
vote
4answers
3k views

Should galvanized steel pipe be used as a tub spout?

I have a 90 degree fitting coming down from my shower valve. Also have a screw on tub spout trim. Right now there is a 6" galvanized pipe that connects the 90 to the tub spout trim. Is the ...
2
votes
1answer
999 views

How does the drywall meet a direct-to-tub surround edge?

Does the drywall get placed over the lip or meet at the lip?
8
votes
1answer
3k views

How do I prevent this bath faucet from leaking while the shower is running?

Here's a photo of my setup: The hose and nozzle hanging down in the picture make up the shower head assembly (it is a hand shower that can hang up on the wall or be removed for directed use). ...
2
votes
0answers
371 views

Why does my bath faucet drip for a few minutes after it's shut off?

I have a traditional two handled (one hot and one cold and they are separate) bath faucet. I recently had it reseated and the washers replaced, however, what I noticed was that immediately after shut ...
2
votes
2answers
17k views

How should I waterproof an upstairs bathroom floor?

I'm adding on a bathroom upstairs. My question is what precautions should I take to waterproof it. I'll have new copper, PVC drains and the floor itself I'm worried about. It's sitting half above a ...
3
votes
4answers
13k views

What is the best way to repair a cracked bathtub?

Close examination of the floor of my bathtub has revealed a long, thin crack in the bathtub itself. The bathtub is one of the common plastic-feeling variety (though I am not sure if it is actually a ...
1
vote
0answers
78 views

How do I install a bathtub's surround on a cinder block wall?

I'm trying to install a tub and surround. The two short walls (left and right) are studded and I can secure on those studs but the back wall is cinder block. Do I need to add studs to the cinder block ...
4
votes
3answers
644 views

What type of washcloth bar should I put inside a fiberglass shower?

I have a fiberglass bath and shower. I would really like to mount a bar inside it on the back wall for hanging washcloths up to dry. I've tried the suction cup mounted ones with moderate success. ...
4
votes
1answer
549 views

How do I replace this bathtub handle that has a plastic piece?

I have followed a number of videos, but they all seem to have a copper (?) stem. At this point I'm up to some plastic piece that has no notches (namely around the metal piece) to use a wrench on. ...
3
votes
2answers
228 views

How can I clean silicone mastic stains from a bath-tub and tiles?

I was redoing the silicone dilation around the bath-tub, using the silicone mastic from a tube. Unfortunately, I stained the tub and a tile with silicone. You cannot see it really, but they got quite ...