For questions regarding the room where one bathes or uses the toilet.

learn more… | top users | synonyms

4
votes
2answers
279 views

How to clean hard soap scum and lime from bathtub?

All this dirt has been on the bathtub for like a year or so since the previous owner just remodelled my house before we bought it and he didn't live there. I read many articles and videos to learn how ...
4
votes
1answer
119 views

What areas of 1st floor sheetrock sould be replaced subsequnet to a major 2nd floor water leak?

In our apartment, the ceiling began leaking in 2 places. One of the places, the water was brownish and had multiple droplets, the other the water was clear. We called maintenance at 8 am and no one ...
5
votes
3answers
1k views

How can I brace a bathtub faucet without tearing out the tile wall?

I pulled the trim off of my bathtub faucet to grease a sticky cartridge and I saw that the plastic brackets that were used to secure the pipes to the studs were broken. My shower is tile, so I don't ...
3
votes
1answer
2k views

Should I use underlay when tiling a bathroom?

Recently I had a water leak in the bathroom. I noticed water spilling out from the tiles grouting and I removed them to prevent any more water penetration. I noticed that the following layers have ...
3
votes
1answer
4k views

What should be done about water under bathroom floor tiles?

There is water getting under our bathroom floor tiles. The landlord believes that due to a recent remodel of whole bathroom, water is not draining from the window ledge but is instead going into the ...
4
votes
2answers
898 views

How do I fix this leaking tub faucet?

I have an old tub/shower with 3 handles in it (hot/cold/shower on) that are all twist knobs. The hot or cold can not fully disengage because they are a bit older and have some sediment built up in ...
4
votes
3answers
701 views

Is it a problem that my toilet flange is 3/8" below the surrounding tile?

My tile setter had to elevate the tiles around the toilet hole in order to make up for some unevennesses. As a result, the toilet flange is approx. 3/8" below the surrounding tile. Can that be ...
4
votes
1answer
118 views

What is the best way to build a box to elevate my bathroom fan above joists?

I want to create a register/ return air type box about 4" high so my bathroom fan's exhaust will be above the joists so that the duct can have the shortest and most direct run to a gable vent. Is ...
1
vote
1answer
80 views

What type and rating of insulation should be used in a basement bathroom?

I need to replace the insulation on the back and side of the bathtub. The walls face the exterior of the house (poured foundation). What type and rating should I use? I can't tell what the ...
0
votes
2answers
436 views

How do I get even water pressure from a bathtub mixer faucet?

I just bought my house and noticed there is a problem in the bathroom tub faucet and that is: the valve starts from the cold toward hot and as it goes toward the hot the water pressure increases and ...
3
votes
1answer
2k views

How to tile over shower wall surround flange?

Background I've been following this guide from Family Handyman on installing a fiberglass tub surround, and am to the point where I need to tile over the nailing flange. They say to put 1/4" tile ...
3
votes
1answer
145 views

How do I install a bathroom exhaust system?

We are set to close on our house in about three weeks and one of the problems that the inspector noted was that the vent in the guest bath vents into the attic (never going outside) and the master ...
2
votes
1answer
240 views

How can I hang a heavy mirrored bathroom cabinet?

I purchased a bathroom cabinet today that is 1200 mm wide, by 750 mm tall, and 150 mm deep. When I brought it home, I discovered it weighed nearly 40 kg (88 pound) empty. I was told that I could use ...
3
votes
1answer
171 views

Can you identify this seal?

I have a slow-filling cistern and, having disassembled all the pipes inside I've identified a ripped seal. Assuming that I didn't cause that myself just a moment ago, I'm hopeful that replacing it ...
0
votes
1answer
133 views

Are PEX required for shower mixers?

From my understanding it is normal to mount a PEX like this one in the wall. And that it is not legal to have hidden connections in the wall. Question Why are PEX so often used (required)? Is it ...
0
votes
3answers
537 views

How to repair this shower/bathroom wall for bathroom remodel.

I have a nasty bathroom downstairs. It looks like the previous owners built it over a floor drain, not entirely sure if this is a good thing or not (not even sure if that's what they did but see ...
1
vote
3answers
244 views

How can I eliminate an odor in an unvented bathroom?

I have a very small bathroom in my office. The said bathroom is unventilated. Obviously it leads to a foul smell in the bathroom. Please suggest to me some method by which the foul smell can be ...
2
votes
1answer
478 views

How can I stiffen the subfloor of an upstairs bathroom?

I have been doing polished concrete throughout my house. My wife loves it more than I thought she would and now wants me to do it upstairs. I am afraid that the subfloor flexes too much, which ...
4
votes
1answer
581 views

How do I replace this bathtub handle that has a plastic piece?

I have followed a number of videos, but they all seem to have a copper (?) stem. At this point I'm up to some plastic piece that has no notches (namely around the metal piece) to use a wrench on. ...
0
votes
2answers
103 views

Can I paint over a stain on a laminated cabinet?

I got a stain on my bathroom cabinet that won't come out. It is a laminated wall cabinet. Can I paint over this?
-1
votes
1answer
192 views

Is it legal to just replace an existing extractor fan in a shower room with a similar model?

The existing ceiling mounted fan is not working correctly now. It is wired via an isolating switch high up in the room away from the shower. The fan has a built-in pull cord: pull for on, pull again ...
1
vote
0answers
268 views

How can I unclog a passive bathroom air vent?

I live in a prewar apartment building. At the top of the shower, on the wall where the water comes in, is a passive vent. There is no powered fan that is installed and no nearby electrical wiring to ...
1
vote
1answer
319 views

Where should I discharge my bathroom exhaust to?

Everyone in general lean towards roof or gable end of house venting. Then of these two whichever is shortest run..Also everyone agrees down hill slope toward exterior of house..If one is to vent ...
2
votes
1answer
2k views

How can I vent my bathroom through a ground floor vertical-slider privacy window?

I live in an old style garden level unit in Chicago (roughly 80 years old). The bathroom currently has no ventilation. The window is cracked and I'll leave the bathroom door open when I shower, but ...
4
votes
1answer
3k views

Should I use caulk or grout between the edge of a tiled bathroom floor and the walls?

I just tiled my bathroom floor. What should I put between the tiles and the walls, silicone or grout?
1
vote
0answers
239 views

Why do I have to seal my bath screen from the outside?

I bought a pivoting bath screen. In the documentation that comes with it they say to seal it from the outside. They even put an exclamation mark ! What's the logic behind that?
2
votes
1answer
184 views

Why is there a sewer gas smell coming from my door jamb?

I am at the tail end of tiling my basement floor and undercut the existing trim on the bathroom door. I started noticing a sewage smell and pinpointed it as being strongest at this point. This is ...
2
votes
1answer
479 views

How can I repair my bathroom cabinet?

I've got a Medium-density fibreboard (MDF) sink cabinet that is at least 30, if not 50 years old. The bottom has gotten wet a few hundred times from a shower that was near it, and it is flaking apart ...
2
votes
1answer
772 views

Is it code compliant to vent my bathroom exhaust through the turbine vent in our attic?

My contractor wants to vent our bathroom exhaust fan by connecting tubing to our attic turbine vent (aka whirly bird) to exhaust it to the outside instead of plumbing it to the outside through the ...
2
votes
1answer
335 views

How can I repair this broken bathroom tap?

So we had a bathroom tap that looks pretty much like this: the red lines I drew are where the tap has a kind of screw joint that separates the head from the side hot/cold taps. The problem is the ...
1
vote
0answers
177 views

How to remove flex hose from a single-control, tall faucet?

I have a faucet that is leaking down the flex hose. The one flex hose unscrewed easily. The second is turning but not coming out. I assume the nut has become separated from the crimp on the hose. ...
1
vote
2answers
2k views

How do I apply the same texture to the bathroom wall after patching a hole?

My repair guy patched some holes with drywall mud on walls that had been painted with semi-gloss; we went eggshell. He then painted over the area after the mud was supposedly dry. The area did not ...
4
votes
3answers
5k views

Is it wrong to connect multiple J-bends (traps) together?

My tenants recently told me that they have constant clogging problems with their bathroom sink and had me come take a look at it. I found the following 3-trap configuration: This was done because ...
5
votes
2answers
1k views

How do I make my bathroom pipes more practical?

I need to install a new vanity in my bathroom but I'm not sure what to do about the plumbing for under the sink. I believe the present location of the sink was originally where the bathtub was. The ...
3
votes
1answer
250 views

Can an alcove tub be installed with most of it behind a wall?

Please forgive the quick sketch for the concept, but I'm wondering if the following is prohibited by code, or failing at that, a bad idea in general. I have a small (6'8" x 9'3") bathroom that needs ...
1
vote
1answer
2k views

How can I wire this replacement bathroom extractor fan?

My old bathroom extractor fan motor burned out, so I got a new one to replace it, I was trying to wire it up earlier and I've hit a bit of a snag... I don't seem to have enough cables. The old ...
7
votes
3answers
6k views

Can I vent my bathroom exhaust fan into a plumbing drain vent?

I installed a bathroom fan in the ceiling. My bathroom is in the room right next to the laundry room. The washing machine has the standard drain pipe vent of a pvc pipe venting to the outside ...
1
vote
1answer
965 views

Why won't my shower fully heat up?

I have a thermostatic shower, but I can only get it to be luke warm. The aquastat is set at 60, boiler at 165. The tap water in wash hand basin beside shower is very warm. I have taken the cover off ...
2
votes
2answers
4k views

What wiring do I need for a fan/light/night-light fixture?

I am replacing a bath fan/light with a fan/light/night light combination fixture. I need a new wall switch with 3 controls. I currently have just a cable with hot, neutral and ground running through ...
3
votes
2answers
780 views

Can I connect a combination heater/fan unit to the existing bathroom wiring?

I have a dedicated 15A circuit for a top-floor bathroom fan with heat lamps which draws much less than capacity. There is nothing else on this circuit. I know that code for a 15A 14ga circuit at 80% ...
4
votes
1answer
849 views

How can I disassemble this old bathroom faucet to fix a leak, without damaging the decorative chrome piece?

Update 4: Once I followed Michael's suggestion I was able to remove the cartridge. Closest match was a Moen 1224, 131222. Inlet and outlet were very different, and rotation of valve was much greater ...
6
votes
4answers
2k views

Should I install an inline water heater for my bathroom?

It takes 3-4 minutes of the shower running before the hot water reaches my upstairs bathroom. I'd like to not have to waste all that water and time. My initial though was to install an inline water ...
3
votes
1answer
550 views

How Can I re-attach my bathroom fixtures which are hanging loose from the wall?

Please see the two pictures below. I'm trying to re-attach the two faucets so that there is no gap between them and the wall. These faucets work perfectly fine its just that they aren't attached to ...
1
vote
1answer
655 views

How can I remove a tub spout with a stripped hex bolt/machine screw?

I have a slip on tub spout with a stripped hex nut. I need to remove it but I don't think it is wise to use the traditional method (drill into the bolt, hammer in an extractor,etc) put the space is ...
1
vote
3answers
175 views

Could my wall have been damaged while the painters were painting?

I recently had my bathroom renovated. Before the renovation I had noticed some minor cracks in the ceiling. The building is 1962 and the walls are plaster. I had semi gloss paint used which I know can ...
0
votes
1answer
80 views

how can i fix my bath tub

When I turn the water on to take a bath the water don't run it just drips and takes hours to fill the tub or I have to add pots of water is there a way for this to be fixed or do I have to call a ...
6
votes
1answer
1k views

Can I ask my contractor to redo a tile job I'm not happy with?

Click on photo for full size I had my bathroom renovated while I was away last week. I'm not happy with how the floor tile came out. I assumed the contractor would lay the tile out in a uniform way ...
2
votes
1answer
188 views

How can I identify my bathroom tub faucet pressure valve?

I am looking for a replacement trim valve kit and I am having trouble finding the right one that will fit my current pressure valve. It appears to me to be a model from American Standard. Click ...
0
votes
3answers
2k views

How can I wire an exhaust fan to turn on from multiple locations?

I just bought a Panasonic FV-20NLF1 inline bath exhaust fan that I planned to used to exhaust 2 different bathrooms. I want each bathroom light switch to control the fan, so when the lighting turns ...
3
votes
1answer
6k views

How can I stop exhaust fan vent condensation problems?

So, our bathroom fan leaks when it is cold. In the attic, the PVC pipe connected to the exhaust is uninsulated, and frosted -- shock! So, my question is, what is the best way to fix this? Do I cut ...