For questions regarding the room where one bathes or uses the toilet.

learn more… | top users | synonyms

1
vote
1answer
56 views

Water flow reduced after a few seconds in 2nd floor bathroom sink, cold side

If you turn the cold water on full blast, it flows for 2-3 seconds at full, then drops off to a trickle thereafter. The hot side does not have the same issue. This began happening a few months ago, ...
2
votes
4answers
454 views

What is the proper order of layers for bathroom walls?

Region: Santa Cruz, California, USA. I'm gutting a bathroom down to the studs and would like a reminder on the proper order of layers for them to ensure that it's moisture-resistant. As far as I ...
8
votes
2answers
37k views

Should the backer board be in front of or behind the tub flange?

I'm installing a new bath tub and shower. I've removed the old tile down to the studs. Should the backer board be in front of or behind the tub flange? I put it on the rear tub wall from floor to ...
8
votes
2answers
2k views

My toggle bolt hole hit a stud. What do I do now?

I'm installing a pedestal sink and was screwing a hole for the toggle bolt and ended up hitting a stud. Now I have this hole I can't use for the toggle bolt, and I'm stumped on what to do. What's the ...
4
votes
3answers
874 views

Fire hazard of exhaust fan with heating bulbs in bathroom?

Our strata gave us permission to install an exhaust fan with 4x 250W heating bulbs into our bathroom. We are on the top floor and the roof cavity above us is the ceiling for the building. There are no ...
2
votes
0answers
91 views

Need to unstick stuck shower divider valve

The shower divider value (which chooses between letting water flow into the tub or up into the shower) is stuck. I can't spin it with the installed plastic handle. Here's some pictures: With the ...
4
votes
4answers
11k views

How do I repair my cracked shower pan?

My shower pan, made of gel-coated fiber glass, has three cracks, as shown in the photo below. The cracks radiate fairly straight from the drain in the center at twelve, four, and eight o'clock. (All ...
5
votes
5answers
52k views

How do I remove a stuck faucet/tap cover?

I've been fixing leaking faucets in a bathroom. There are total six faucets in a bathroom, two made into a bathroom basin, two made into the wall in the shower tube and the last two are on the wall ...
3
votes
2answers
847 views

Timer needed on bathroom vent fan?

Does the International Building Code (IBC), or International Residential Code (IRC) require a timer on bathroom vent fans? (I realize all code is local, but just trying to get the standard rule.)
1
vote
5answers
191 views

Would it make sense to have a bathroom without a sink?

I had this idea to maximize the amount of space in my small bathroom, to redo it and the kitchen in one go, put the kitchen sink next to the bathroom, and skip the bathroom sink. A quick internet ...
2
votes
1answer
197 views

What is the correct procedure to turn a 10“ rough-in toilet drain into a 12” rough-in drain when the drain goes through a slab-on-grade?

I need to replace a leaking toilet, but the distance from the drain to the wall is about 10.75". The selection of toilets that I'm finding in the 10" rough-in range is pretty pathetic and overpriced, ...
0
votes
0answers
18 views

renewing a heated bathroom floor

I heard there is a material that works great for renewing a bathroom floor which has a heating system integrated. We would like to give a new shine to ours but we don't want to break everything. I've ...
0
votes
1answer
70 views

How do I remove mildew from walls and ceilings?

My bathroom has some mildew on the walls and ceilings, and I desperately want to get rid of it. How can I remove it?
0
votes
0answers
98 views

How to prevent sudden changes in water temperature (shower)?

I have an apartment in an older building. The boiler apparently was recently replaced by the building manager in the past few years, but every time I take a shower, the temperature changes are pretty ...
2
votes
2answers
1k views

How much heat loss through bathroom fan vent?

My master bathroom did not previously have bathroom fan, but I installed one and have had wonderful results with keeping the steam from building up and exhausting the moist air. I am using both a fan ...
2
votes
3answers
484 views

How to white spray paint bath window for privacy?

What are tips to paint on privacy for bathroom windows? White spray paint sounds easy, but would make it harder to clean the window, would it not? Pros: Privacy with natural light. Window shades ...
0
votes
0answers
53 views

Fan speed control with timer?

I'm looking for a device that will allow me to control the fan speed as well as have it timeout. In theory this might work if I used the output from the timer to feed into the dimmer, but it doesn't ...
3
votes
4answers
894 views

What are some methods to get rid of and prevent pink mold in the bathroom?

I have some pink mold on the seam where the bathtub connects to my wall tiles. There's also some on the grout on some of my tiles. I've tried to clean them with ajax. It doesn't get it all off. I've ...
3
votes
3answers
128 views

How can I prevent water from puddling on a shower ledge?

I'm about to paint/re-caulk the walls above a fiberglass shower. There's a ledge that I'd just as soon eliminate by putting in something to slope and prevent water from puddling in the corner (shown ...
1
vote
2answers
450 views

Bathroom faucet drip

I had a faucet drip in my bathroom sink. I determined it was the hot water (confirmed by the warm drip and it stopped when I shut off the hot under the sink). I assumed that the stem went (which ...
1
vote
1answer
246 views

Waterproofing 1st floor bathroom with original wooden floor boards in a Victorian house

I want to convert a 1st floor room into a bathroom, retaining the original wooden floorboards. There will be no shower, just a bath in the room. What needs to be taken into consideration with regards ...
0
votes
0answers
39 views

Can/Should I use Uncoupling Membrane for tiling stairs?

I am preparing to tile my bathroom, which currently has carpet. I would like to use uncoupling membrane as a base, but there is a small step in front of the shower. Since it's in front of the shower, ...
3
votes
1answer
17k views

How can I stop exhaust fan vent condensation problems?

So, our bathroom fan leaks when it is cold. In the attic, the PVC pipe connected to the exhaust is uninsulated, and frosted -- shock! So, my question is, what is the best way to fix this? Do I cut ...
0
votes
2answers
1k views

Can I add an exhaust fan to bathroom without exterior wall or roof access

My master bathroom is wired for a fan, but I opened it up and found that it is just venting into the joist between the ceiling and the second floor. There are no exterior walls to access in the ...
7
votes
3answers
6k views

What could cause water hammer after changing a valve cartridge?

I fixed my delta 1400 series shower faucet the other day by replacing the valve cartridge with a non-delta brand. Everything went well, until I turned it on, now the shower pipe is hammering. The ...
7
votes
4answers
1k views

Is a timed electrical switch causing vent fan to run slower / with less power?

I bought this timed electrical switch and used it to replace a standard switch that turned on my bathroom vent fan (I'm always forgetting to turn it off and it often will run all day.) after the ...
0
votes
1answer
604 views

How can I move sink supply lines from the floor to the wall?

So before I make any cuts into my subfloor and wall I wanted to ask anyone with experience in this area on what my best course of action would be. Basically, I would like to have the pipes you see ...
2
votes
1answer
67 views

Is it code compiant for a new construction bathroom vent (no shower) to go down and then lateral?

I have a challenge on floor two where a curved steel roof and spray foam makes the best option in a toilet/sink small bathroom fan to route down and laterally out the side of the side of the home. I ...
1
vote
1answer
96 views

How can I fix a very slow drain?

I have a bathroom with a bathtub, toilet, and sink that are all very, very slow to drain. When water drains out of the toilet, it backs up into the tub, and vice-versa. Here's what the setup looks ...
0
votes
0answers
43 views

Should I be concerned about the waterproofing method of this tub surround?

I had two tub with tile surrounds completed, one looks terrible so it needs to be replaced. The other looks great, but I am going with a new contractor who says we should redo both. We have metal ...
2
votes
3answers
347 views

Do subfloors in bathrooms require any special sealant or moisture barrier prior to adding standard floor covering (like tile)?

Region: Santa Cruz, California, USA Do subfloors in bathrooms require any special sealant or moisture barrier prior to adding standard floor coverings (like tile)? I know walls need a covering and ...
5
votes
3answers
1k views

Can a freestanding bathtub drain be damaged by regular use?

I recently moved out of a house with a freestanding bathtub. During our tenancy there, the floor developed cracks which I reported and 2 months before we left, we would find water on the floor every ...
1
vote
0answers
31 views

Epoxy / Urethane grout - double membrane?

I'm getting started on a bathroom remodel, going to make a "wet room" with Redguard waterproofing membrane painted up the walls and floor to "tank" the entire room. I've also settled on using a ...
0
votes
2answers
309 views

Is it normal for there to be a small gap between toilet tank and wall?

We recently replaced the toilet in our bathroom and I'm noticing a gap between the tank and the wall. Example: Is this normal? Our last toilet tank was flush against the wall. My concern is ...
1
vote
3answers
118 views

How can I mount a clock on tiles?

My father likes to have a clock in our bathroom. Currently, it looks like this: As you can see the clock is already damaged because we need to move it all the time when we want to open the window. ...
6
votes
4answers
30k views

How can I make suction cups stay securely to a tiled shower wall?

I am trying to hang a mirror in the shower and it simply will not stay on the wall. It does not weigh more than a couple of pounds. There are two suction cups. Things I've tried: Cleaning the tile ...
0
votes
3answers
409 views

What pipe/adapter do I need to make this sink connect to this P trap?

I'm getting ready to connect a custom vanity to a P-trap and I'm not sure what kind of pipe/connection/adapter I need. The P-trap looks like this: (note that it won't be sticking out that far ...
1
vote
2answers
140 views

What shape/bends should a bathroom sink drain pipe have to generally comply with US code and avoid clogs?

Santa Cruz, CA, USA I think this question might be related to Under bathroom sink piping (exposed) but my question is more general so I decided to post it separately. I'm in the middle of a ...
1
vote
0answers
24 views

Should there be nylon seals between a basin and taps?

I have just had a new bathroom installed and the plumber has not put any rubber or nylon seals between the basin and bath taps that are placed on ceramic fixtures. Should there be seals between ?
1
vote
5answers
438 views

If walls and floors aren't exactly perpendicular, which side should I align tile with?

I'm getting ready to tile my bathroom floor and tub surround. Our house is older (about 45 years old) and the walls/floors aren't exactly perpendicular. With that in mind, I'm wondering if I should ...
1
vote
1answer
729 views

How to GFCI protect bathroom lighting circuit

I have an old house with 3 bathrooms all on the same circuit. Each has an light with a receptacle above the sink controlled by a wall switch. (See image below.) I want to GFCI protect the entire ...
3
votes
3answers
120 views

Do we need to re-install tiles if it was exposed to water for 20 minutes after installation?

The tile installers didn't shut off the shower valve when they left after installing tile work in our shower. We turned on the main water supply and 15 minutes later, we went to the bathroom to check ...
0
votes
3answers
2k views

What should I use to seal around the perimeter of a tile floor?

I recently tiled our bathroom floor (nothing fancy - just a 7 x 5 room). In between the tiles, I've used a sanded grout and that's worked nicely but I'm confused on what to use around the perimeter ...
0
votes
0answers
72 views

Multi-turn under sink shut-off valve doesn't shut off when faucet falve fails

I replaced the hot water faucet valve in my Price-Pfister bathroom fixture. When I turned the shut-off valve back on then turned the faucet on, water came out of the faucet valve. Turning faucet off ...
0
votes
0answers
49 views

Strange configuration for laundry area needs solutions

We are being given the chance to buy the house we are renting, but I have some major concerns where it comes to the laundry area. You see, the washer hookup and gas hot water tank are in a closet ...
0
votes
1answer
81 views

Window for shower

I'm doing a bathroom remodel, and there's currently a large window smack in the middle of the place where I intend to have a walk-in shower. I'd like to keep that window - I love the natural light. ...
2
votes
1answer
4k views

How do I install a bathroom exhaust fan?

I need to know how to wire a bathroom fan with a light and night light. The wiring has a black/white red/white blue/white and green. The bathroom has a light switch for the light fixture over the ...
-1
votes
1answer
46 views

All Bathroom lights on same circuit flicker

bathroom lights flicker and stop when exhuast fan on a dimmer is turned on. Multiple bathrooms/lights on same circuit. Sometimes GFCI (new) trips without fan on and only one bathroom light on. Problem ...
3
votes
2answers
3k views

How high must a shower pan curb be?

Releated to: Building on top of 3/4'' plywood subfloor (link for impatient: http://www.mrmoneymustache.com/2012/12/21/how-to-make-a-relatively-sweet-shower-cheap/) I would like to know how ...
1
vote
4answers
1k views

Hardie Board Subfloor—Thinset or No?

I'm remodeling the bathroom in my house that was built in the 1930s. I stripped out the old flooring down to the 1x8 wood planks (about 1/4" between each). I have 1/4" Hardie Board to put down in ...