1
vote
2answers
84 views

Should electrical wiring be placed above or below plumbing pipes

I'm putting a bathroom in my garage/shop. I'm going to have to run wiring and water supply plumbing through the same walls. should I put the wiring above or below plumbing?
1
vote
2answers
60 views

How do I install the trap for a standard bathroom sink?

I have an open 1.5" drain pipe in the wall. I just need to redirect it through the (currently non-existing) drywall and put in a trap. What is the proper way to do this? Do I just put a 90 degree EL ...
3
votes
3answers
159 views

Can I use old style individual faucets on a bathroom vanity?

We have an old home and would like to keep with the period where possible. I have a marble vanity top with individual faucets for hot and cold rather than a single spigot for both. I can buy brand new ...
0
votes
1answer
58 views

How do I frame this oddly spaced rough in

It's been a long time since I posted about this stupid rough in (dang kids), but I'm attempting to get back on it. The spacing for these pipes are driving me crazy. For a quick reference, the ...
2
votes
2answers
224 views

What might cause water to leak under or behind a bathtub?

The floor in my bathroom is constantly wet after showers. House was built in 1970 and this bathroom is all original. From the yellow tile down to the linoleum. The shower curtain is sealed, the ...
0
votes
0answers
44 views

How to resolve a crack in the shower floor?

My dad did a great job renewing his bathroom, but sadly a crack has appeared on the shower's plastic floor base. He believes the crack has developed because he installed it on top of wooden beams ...
0
votes
3answers
91 views

Can I break up the floor of a raised floor basement bathroom without damaging the plumbing?

I have an interesting remodel project. I have an existing basement bathroom - which has a raised concrete floor. The toilet sits on the slab. I am remodeling this to create a bigger bathroom for ...
1
vote
1answer
53 views

How to avoid spinng sharkbite on moen spout? [closed]

What new spout did you get to avoid the sharkbite to moen connection?
2
votes
2answers
133 views

What can I do if drain alignment doesn't allow enough space for p-trap?

I'm remodeling my bathroom. The sink drainage come up from the floor. The alignment between that and the drain coming from the sink doesn't have enough space for a p-trap to be installed so it just ...
3
votes
5answers
573 views

Sink tailpiece doesn't line up with trap

After installing a new bathroom sink, the drain tailpiece doesn't line up with the trap coming out of the wall. I've seen flexible accordion hoses for this, but I think that violates code ...
0
votes
1answer
85 views

How can I remove the stench from a p-trap?

In my shower room, there's a hole that's always filled with disgusting, slimy water. What I've tried I've sponged it out a few times to clean, but that didn't really help. I've poured ...
1
vote
1answer
254 views

What are these two drains for?

I have an unfinished basement and do not have any experience with plumbing a bathroom. I assume the two pipes protruding from the floor are toilet (on the left) and either sink or shower (on the ...
2
votes
1answer
62 views

Raising porch floor to accommodate plumbing and keep first floor all one level

I have a question whether or not building a floor on top of concrete is a viable option to insert plumbing underneath for a half bath. I am looking to finish a small porch off of my kitchen and turn ...
1
vote
1answer
52 views

How can I install a tub over this tub box?

In our unfinished basement, we have a roughed-in bath. I can see a water closet exit, a sink exit, and a tub exit. The tub exit is covered by this product: ...
1
vote
1answer
158 views

Basement Bathroom Rough-In Configuration

I'm investigating if I can use an existing basement bathroom rough-in as is. To date, everyone I've asked has said the concrete needs to be broken up and the plumbing re-arranged. I think the tub ...
0
votes
0answers
36 views

How can I stop my fluidmaster pump from opening when I open the water in my bathroom sink?

My fluidmaster pump in my toilet opens up sometimes when I open the water in my bathroom sink.
2
votes
2answers
716 views

Is a raised floor viable and safe in a basement bathroom?

A contractor wants to build a raised floor for my bathroom basement that he is building for me instead of breaking the concrete. The plumbing would be underneath the floor. Is this a viable and safe ...
1
vote
1answer
426 views

How do I replace the water supply line that appears to be built in to the shutoff valve?

We're preparing to replace our bathroom faucet. We were able to easily disconnect the cold water supply line from the shutoff valve to the faucet by simply loosening the nuts holding it in place. ...
2
votes
1answer
320 views

How do I pump up water pressure in my shower?

I have a well system that generates approx 35 psi of flow to my shower. How can I pump up pressure to the shower?
1
vote
1answer
503 views

Basement bathroom rough-in with backwater valve question

I ended up contacted the plumbing company that did my basement rough-in. This is what they said: Drain and vent for basement sink Toilet rough-in Backwater Valve Tub Drain So I guess my new ...
3
votes
2answers
587 views

How do I reroute my existing bathroom piping for a pedestal sink?

(Similar to this question here) I am renovating a bathroom, and I'd like to put a pedestal sink in, instead of a full sized vanity. The primary issue is I would have to move the drain pipe, it is a ...
4
votes
3answers
4k views

What is causing a cat urine smell in my bathroom?

My bathroom has started smelling like cat urine. We have NO cats. I think the smell is coming from the shower drain. What could this smell be coming from and how do I get rid of it?
3
votes
2answers
639 views

How high must a shower pan curb be?

Releated to: Building on top of 3/4'' plywood subfloor (link for impatient: http://www.mrmoneymustache.com/2012/12/21/how-to-make-a-relatively-sweet-shower-cheap/) I would like to know how ...
3
votes
3answers
3k views

Decipher my bathroom rough in

Can someone help me decipher this picture? When I had the house built, the builder roughed in a bathroom for later use. The pipes in this picture are A 2" pipe, possible a vent with a T connector ...
0
votes
1answer
197 views

What type of faucet is this?

I cannot for the life of me figure out what kind of faucet this is. I need to replace the stems as they are leaking but without knowing the brand I am stumped!
2
votes
2answers
306 views

What's the best way to replace this sink supply line?

When removing a pedestal sink to put tile underneath, I busted one of the supply lines. I know I can get a flexible mesh supply line at the store, but I don't see any threaded connection on my wall ...
4
votes
3answers
4k views

How do I repair my cracked shower pan?

My shower pan, made of gel-coated fiber glass, has three cracks, as shown in the photo below. The cracks radiate fairly straight from the drain in the center at twelve, four, and eight o'clock. (All ...
8
votes
2answers
13k views

What would cause air bubbles in the toilet when I'm showering?

My basement bathroom has recently been remodeled, everything was working fine for a few weeks, but now all of a sudden I am hearing bubbles in the toilet when I shower, at which point the shower drain ...
1
vote
2answers
2k views

How can I reattach a drain pipe that detached under the sink?

Recently, I had a clog in my bathroom sink that I wanted to attempt to fix myself. Believing the clog to be in the P-trap, I bought a pipe wrench, removed the trap, cleaned it out, and attempted to ...
5
votes
3answers
1k views

How can I brace a bathtub faucet without tearing out the tile wall?

I pulled the trim off of my bathtub faucet to grease a sticky cartridge and I saw that the plastic brackets that were used to secure the pipes to the studs were broken. My shower is tile, so I don't ...
4
votes
2answers
871 views

How do I fix this leaking tub faucet?

I have an old tub/shower with 3 handles in it (hot/cold/shower on) that are all twist knobs. The hot or cold can not fully disengage because they are a bit older and have some sediment built up in ...
4
votes
3answers
657 views

Is it a problem that my toilet flange is 3/8" below the surrounding tile?

My tile setter had to elevate the tiles around the toilet hole in order to make up for some unevennesses. As a result, the toilet flange is approx. 3/8" below the surrounding tile. Can that be ...
0
votes
2answers
424 views

How do I get even water pressure from a bathtub mixer faucet?

I just bought my house and noticed there is a problem in the bathroom tub faucet and that is: the valve starts from the cold toward hot and as it goes toward the hot the water pressure increases and ...
3
votes
1answer
169 views

Can you identify this seal?

I have a slow-filling cistern and, having disassembled all the pipes inside I've identified a ripped seal. Assuming that I didn't cause that myself just a moment ago, I'm hopeful that replacing it ...
4
votes
1answer
565 views

How do I replace this bathtub handle that has a plastic piece?

I have followed a number of videos, but they all seem to have a copper (?) stem. At this point I'm up to some plastic piece that has no notches (namely around the metal piece) to use a wrench on. ...
1
vote
0answers
173 views

How to remove flex hose from a single-control, tall faucet?

I have a faucet that is leaking down the flex hose. The one flex hose unscrewed easily. The second is turning but not coming out. I assume the nut has become separated from the crimp on the hose. ...
4
votes
3answers
5k views

Is it wrong to connect multiple J-bends (traps) together?

My tenants recently told me that they have constant clogging problems with their bathroom sink and had me come take a look at it. I found the following 3-trap configuration: This was done because ...
5
votes
2answers
1k views

How do I make my bathroom pipes more practical?

I need to install a new vanity in my bathroom but I'm not sure what to do about the plumbing for under the sink. I believe the present location of the sink was originally where the bathtub was. The ...
1
vote
1answer
941 views

Why won't my shower fully heat up?

I have a thermostatic shower, but I can only get it to be luke warm. The aquastat is set at 60, boiler at 165. The tap water in wash hand basin beside shower is very warm. I have taken the cover off ...
6
votes
4answers
2k views

Should I install an inline water heater for my bathroom?

It takes 3-4 minutes of the shower running before the hot water reaches my upstairs bathroom. I'd like to not have to waste all that water and time. My initial though was to install an inline water ...
0
votes
1answer
79 views

how can i fix my bath tub

When I turn the water on to take a bath the water don't run it just drips and takes hours to fill the tub or I have to add pots of water is there a way for this to be fixed or do I have to call a ...
2
votes
1answer
187 views

How can I identify my bathroom tub faucet pressure valve?

I am looking for a replacement trim valve kit and I am having trouble finding the right one that will fit my current pressure valve. It appears to me to be a model from American Standard. Click ...
2
votes
1answer
1k views

Under bathroom sink piping (exposed)

We are looking at setting up the piping for under our wall mounted sink (no vanity, ie, piping will be exposed). And after our contractor finished putting the wall we noticed that the hole from the ...
5
votes
2answers
7k views

What are the standard sizes/clearances for bathroom elements?

I expect to be asking several more questions about this project; but I'm starting with a general one, and will get more refined as things develop. We are working on finishing our basement, which ...
4
votes
5answers
6k views

How do I install this wall mount bathroom sink?

I'm replacing a sink that was on a vanity cabinet and hoping to do as little busting through the perfectly good tile as possible. I heard a rumor that I need to make very sure that the sink is ...
1
vote
1answer
166 views

What should I be aware of as I prepare to replace my bathroom vanity with a wall mount sink?

We have a super tiny master bath, and the sink, which is a vanity type is pretty destroyed. I think someone used some caustic cleanser on it or something. I'm thinking of replacing it with a wall ...
2
votes
1answer
563 views

Could water temperature fluctuations be caused by new plumbing?

I'm having a new bathroom installed. I hired a plumber to do all the water works. He ran all the lines; he is now waiting on sink and toilet to arrive to finish installation. Since he ran new line, we ...
4
votes
3answers
291 views

How can I make these bath valves easier to use?

I'm looking for a way to make the valves in the pictures below easier for my mother to use. She has a bad case of arthritis in here hands, so this was suggested by a nurse. I would really prefer any ...
4
votes
1answer
853 views

Can I grind a shallow channel in my basement concrete to correct the height of a shower drain pipe?

Long story short - the people who finished the basement bathroom did so without a permit, and they made full use of the fact that their work wasn't about to be inspected or subject to building codes. ...
2
votes
2answers
2k views

How do I seal a cracked pipe using epoxy putty?

So, I have a broken pipe exactly on the L join on the wall. It's a huge crack but no big gap, just a curved crack along the pipe. At first I thought of replacing the pipe, but it means that I have to ...