Questions regarding installation, removal, painting of baseboard (otherwise known as skirting board, skirting, mopboard, floor molding, or base molding).

learn more… | top users | synonyms

1
vote
3answers
24 views

Baseboard meeting at top of corner but not bottom

Removed 3" and installing 4" baseboard. The inner corners meet at the top but gap at the bottom ( sheet rock taper is at the bottom and wondering if that's the problem) (have checked the saw and can't ...
1
vote
0answers
80 views

What could be causing my baseboard heater to not heat up?

I have a Dunkirk Gas boiler with an Amtrol Extrol expansion tank Have a weird situation During the winter when it is very cold out, my heat does not turn on automatically. My thermostat may say 70 ...
1
vote
0answers
546 views

What should I do about baseboard anchors in plaster-over-brick walls?

I am restoring some plaster walls in my very old house. Most of the areas that need restoration are around the bottom of the walls since I ripped out old ugly baseboards and that also crumbled the old ...
0
votes
0answers
12 views

Fahernheat 70 in 240 volts 150 watt Hudronic Electronic baseboad heater

I am remodeling a living area which is 20'7 x 13'3 ft. which is now heated by 1 8ft. baseboard heater and 2 3ft. baseboard heaters. Additionally, I have gas logs which I use for back-up heat and to ...
0
votes
0answers
296 views

how to handle baseboard/trim transition

I've done a lot of reading on baseboard/casing installation but one area no one seems to talk about are transitions. I have a few that I've been wondering how to handle, like in the bathroom where it ...
0
votes
0answers
38 views

How do I go about finding the correct size hydronic baseboard radiator covers?

I replaced some drywall behind a hydronic baseboard radiator. The original covers were thrown out. The element size is 2.75x2.75. This is bigger than the covers sold at big box stores. I called a ...
0
votes
0answers
160 views

Baseboard heater install from room to room?

I am looking to install 240v electric baseboard heaters which will be fed with 12-2 on 20 amp breakers. I did my amperage calculation 4000/240v = 16.6 amps. So with that said I can run all my heaters ...
0
votes
0answers
541 views

Heating zone not working when other 2 do

I have three zones of forced air/baseboard heating in my house. I had the furnace shut off for the summer and after turning it back on, two zones in the house work and one does not. Any tips on how ...
0
votes
0answers
312 views

Hot water baseboard heater, one zone is cold

I have a hot water baseboard heating system. I have 4 zones controlled by 4 thermostats. The basement is cold. I installed a new zone valve for that area and it is still cold. I bled the zone of ...