5
votes
2answers
235 views

Can 18/2 CL2 barostat cable be used for speakers?

We're wiring our kitchen for a stereo speaker system. There was only enough 18 gauge speaker wire for one speaker, so the electricians used 18/2 barostat wire for the other. The speaker cable seems ...
1
vote
2answers
5k views

What's causing the popping noise from my speakers?

Several weeks ago, I moved into a new home. In office, I have my computer set up with a set of media speakers (older model of Logitech Z-550's). Every now and then the speakers will make a popping ...
4
votes
2answers
355 views

How should I connect these two yellow wires?

I don't know what this cap is... is it ok to cut it off and splice the two yellow wires together as I have been with the previous splices.
0
votes
1answer
234 views

Does the listed gauge on a crimp cap take into account that two wires would go in the same end?

What size of crimp cap be used for 16 AWG wire? I could use butt splice of size 22-18 AWG but prefer crimp cap connector where both wires go in the same end (so double the diameter). Should I buy ...
3
votes
3answers
1k views

Do speaker wires need to be protected at exposed end-points?

Ah the joys of new home ownership. In preparing to prime/paint our family room ceilings, we took down some old (really old) speakers the previous owner had set up. We're not planning to use them ...
5
votes
4answers
2k views

What are some ways to wire rear speakers in a home theater system?

I have two rear speakers, that I never use, since I don't have a good way (yet) to wire them. I have a hardwood floor. And the side of the room that is nearest to the TV+Audio source is open. So I ...