8
votes
1answer
539 views

Can I use Romex in an unfinished basement or attic?

I am asking in reference to articles 382.2 & 382.12 in the 2008 edition of NFPA-70. The following definition appears to me to be describing Romex (NM-type) cabling: **382.2 Definitions** ...
1
vote
2answers
284 views

How can I seal electric outlets to prevent garage fumes from seeping through?

Two of my bedrooms share a wall with my garage attic. One of the bedrooms started smelling like gasoline after my snow blower started leaking in the garage. After long investigation, I found out the ...
3
votes
1answer
127 views

How do I install a bathroom exhaust system?

We are set to close on our house in about three weeks and one of the problems that the inspector noted was that the vent in the guest bath vents into the attic (never going outside) and the master ...
3
votes
4answers
4k views

Can I cover junction boxes in the attic with insulation?

This may be a duplicate of What are the codes for electrical wiring in attics? I have an attic which is accessible via a ladder through an access panel in the garage and in a bedroom. The trusses ...
2
votes
1answer
2k views

What are the codes for electrical wiring in attics?

What is the typical code for wiring in attics? I understand these vary but what's best practice? Can you just have electrical wires exposed with all the junctions, in junction boxes, provided all the ...
1
vote
1answer
458 views

How can I wire an HD antenna into my attic?

I have a 2 year old house 2 floors and then an attic that you have to use a pulldown to get into. The house has an ethernet cable (90% sure it is an ethernet cable) that is in the attic, I have a HD ...
6
votes
2answers
2k views

Do I need exterior grade cables or conduit to run wire in an enclosed soffit?

I'm looking to add some lights on motion detectors (un-switched) and security cameras under the eaves of our house. I know standard romex is often used in attics, but the soffits seem like they might ...
7
votes
2answers
212 views

Is it a good idea to chisel out the edge of rafters for wires?

I am wondering if it is a good idea to chisel out the edge of rafters for wires? We want to floor our garage attic, and there are wires criss-crossing on top of the rafters. Update: These are regular ...