The tag has no usage guidance.

learn more… | top users | synonyms

0
votes
1answer
207 views

How wide does a 6x6 concrete post footing need to be using an elevated post base anchor?

I'm building a pergola over a paver patio. The pergola will dimension 11'x 11.5' on center of post with 6x6 posts (4 posts), tied together with sandwiched 2x12 beams. I've laid out footer locations ...
3
votes
4answers
4k views

Framing a wall over a carpeted floor

I have a carpeted basement. There is both pad and carpet over concrete. There is a section I want to wall off and turn into a bedroom, it will not be load bearing. I would prefer not to have to ...
0
votes
1answer
28 views

I need to anchor a standard where there is a one-inch hole in the drywall

While I was putting in anchors to hold a shelf standard I had one that didn't install right and I was left with a one-inch hole. Some kind of anchor or support absolutely has to go there. It's too ...
5
votes
3answers
83 views

How can I attach pony wall to surface of platform and will it be strong enough against lateral forces?

I have a loft area to which I want to add a pony wall for safety. My plan is to drywall its inside and outside faces, all the way down across the beam. Can I built it on the surface of the platform ...
3
votes
2answers
873 views

How should I anchor a hand railing to sandstone steps?

I've got three exterior steps made of natural sandstone. They are 6 ft wide, and 10" thick. I need to anchor a metal handrailing to them. The railing has two feet: 1/4" metal plates with 3/8" holes ...
11
votes
3answers
46k views

How much weight can I hang from a drywall ceiling?

I have a potted plant (approx 5kg/10lbs) that I wish to hang from a drywall ceiling of a window aisle. Unfortunately, I have no idea about what specific kind of drywall plate it is or how it was ...
0
votes
3answers
984 views

What type of anchor should I use for ceiling hook for ceiling fan?

Going to install a ceiling fan, may I know what type of anchor bolt/sleeve to install ceiling hook? Yes is a norm. Location : Singapore Ceiling Hook http://www.kdk.sg/ceiling-hook.html
0
votes
1answer
35 views

Wall Anchor for shower door slider

I am going to be installing a 3/8in glass frameless shower door system in my new project. I have the opportunity to screw into a stud on one side, but not the other. I would have added a stud in the ...
22
votes
8answers
3k views

How to avoid wires when drilling into the wall?

I have to anchor a bookcase to a wall to prevent it from tipping over. When drilling into the wall, how do I make sure I can avoid drilling into the wires behind the wall? I have bought a Stud ...
1
vote
3answers
315 views

Hanging picture on a very hard concrete wall

Situation: Appartment in a panel building. Very hard concrete walls -- all, thick or thin. No plastic hooks (like these on alibaba that usually work for people around do not work for me, the little ...
0
votes
2answers
119 views

how to repair holes left by expanding anchor bolts in concrete

I have a large workbench which I inherited with my current home, and I'd like to replace it with one I'm currently building, mainly since the current one is pretty small, and the top of the bench has ...
0
votes
1answer
79 views

Adding partitioning stud wall anchoring to sides instead of top and bottom

Hi I want to add a partitioning stud wall in my basement. Ceiling and floor are concrete and sides are brick walls. I want to know Must I build a full height wall touching the ceiling and anchor the ...
1
vote
5answers
751 views

What's the strongest anchor for something heavy in double drywall?

I have a party-wall in my apartment-née-condo that seems to have two sheets of drywall installed against eachother. All attempts to find some sort of stud or resilient channel / furring strip have ...
2
votes
2answers
62 views

Nylon “expansion” anchor in drywall

Here we have an anchor named "universal anchor", that is supposed to work in every kind of wall (concrete, hollow, drywall, etc). I've used it in concrete and it is very good, but I'm a bit worried ...
0
votes
4answers
110 views

How can I anchor something in the gaps between the bricks or rocks of a fireplace without damaging the masonry?

I want to hang fireplace tools next to my fireplace without damaging the stone work. I don't want to drill into it. The stones have mortar between them with gaps about half an inch wide: I have ...
1
vote
1answer
42 views

What type of anchor for fastening to block wall?

So, I started with What type of screws and anchors are used for concrete? - but it's not particularly clear to me. I (hammer) drilled 5/32" holes into an exterior wall for 3/16" tapcon screws. These ...
12
votes
4answers
9k views

Does XPS+OSB subfloor need to be anchored?

Mike Holmes is a big fan of OSB/plywood over 1" XPS for basement floors, though his book leaves something to be desired in terms of details. His book says: ...on top of the foam, you want to have ...
2
votes
4answers
306 views

Is it okay for one curtain hanging bracket to be screwed into drywall with no anchors?

I'm trying to hang curtains from near the ceiling. I have 5 brackets. 4 of them have successfully been screwed into wood, at least with the top screw (the bottom screw was as a wall anchor into ...
1
vote
3answers
178 views

What kind of wall bolt/anchor is removeable?

What kind of wall bolt/anchor will allow me to remove and replace it as many times as necessary? I am looking to attach a couple of 2x4's flat against a brick wall, however they would only stay there ...
1
vote
2answers
149 views

Did I install my sleeve anchor correctly?

I installed a M8 x 40mm anchor bolt, but I was not able to tighten it any more beyond the point in the photo. My worry was the thread was damage when I tighten the nut. Basically now the nut still ...
0
votes
2answers
3k views

Deck posts - set in concrete or use anchors?

I'm planning to build an elevated deck. I was going to dig the holes for the posts, put them in and set them in quikrete. I've done this for a fence and I'm comfortable with the process. A deck ...
0
votes
0answers
20 views

What load rating for securing bookcases/cabinets with anchors?

I have two full-height bookcases that I want to anchor to a concrete wall. Unfortunately I think I have only 3/4" max. embedment because of pipes, etc. I can only find two anchor options, a #6-3/4" ...
1
vote
0answers
23 views

How can I attach a kitchen hood to a mud wall?

I am trying to attach a kitchen hood to a wall in a 200 yr old house. The wall is quite poor quality: random rubble I believe it's called. From what I can see it's essentially mud. The kitchen hood is ...
2
votes
1answer
349 views

How to anchor zipline to house

I want to add a zipline to my backyard. I'd like to anchor one end to the house itself. The other end will probably anchor to a tree in the back end of the yard. There is a lot of information for how ...
23
votes
7answers
6k views

Pouring concrete, is it safe to add large rocks to increase volume?

Backround I'm going to pour some concrete to anchor a swing set. The base of the swing set that is being anchored is two 4x4s with a 2x4 footer crossed perpendicularly to the 4x4s. I have a bunch of ...
2
votes
3answers
311 views

Attach net/hammock to interior walls

Imagine a square room with four walls (12x12). Say you wanted to string a net across the area at a height of 6 ft, like a hammock. The net will be attached on all 4 walls, and it must support up to ...
0
votes
1answer
57 views

How to prevent Epoxy from sagging/dripping

I have to anchor a bolt to concrete, but I can only find 2 component epoxy in "medium viscosity" around here (Brazil). I made a test setup to see how much might drip out and it is much more than i ...
1
vote
1answer
160 views

Anchors in a solid plaster wall

I was going to hang a heavy whiteboard on my plaster walls using molly bolts, but when I went to drill the holes, the drill bit never broke through - it penetrated (exactly) 2" into the wall before ...
3
votes
3answers
2k views

I drilled holes in my brick too big for my anchors. How can I fix this?

I am mounting some bike racks to a brick wall (basically, a special hook that you hang your bike on). The holes in the metal bike racks are big enough for #8 screws. I purchased some lead plugs ...
1
vote
1answer
544 views

How to properly anchor wooden porch columns to concrete pad?

I have a country style front porch that has non structural wooden columns that are anchored to the overhang and hang to the floor, a concrete pad. To stop the columns from moving around the builders ...
4
votes
3answers
622 views

Is it OK to install a TV mount when it can't be attached to a stud at all mount points?

I have a TV wall panel that can only reach two studs. I was wondering if it's fine to screw the left side and the center on studs, and have the right side anchored in the drywall. My TV is 30lbs with ...
0
votes
1answer
57 views

Will a drywall anchor work fine after it's already open or engaged?

I'm going to install some shelving that is going to require either drilling into the stud, or using drywall anchors. The brackets are kind of thick (half an inch), so I'm wondering if it matters if ...
2
votes
3answers
787 views

What should I use to hang a coat hook on a brick wall?

I have purchased several of these iron coat hooks: However, they do not come with any kind of screws. I will be hanging them on a (brick + plaster) party wall of my terraced property (UK). I ...
1
vote
2answers
513 views

How to hang a projector screen from a thin horizontal part of slightly curved ceiling

I have a brick wall in front of which I want to hang a projector screen. Here is an image of a typical projector screen that I am looking to buy: The part of my ceiling near the wall is curved(the ...
2
votes
1answer
211 views

Can I use a toggle bolt if there's no space behind the drywall?

While trying to install a 14lb metal shelf to the wall, I had learned from a previous installation mishap to upgrade from plastic anchors to something stronger. I picked up a few toggle bots (3/16" w ...
1
vote
0answers
136 views

Installing an 18kg (40lb) projector screen onto a concrete ceiling

I have a large projection screen that I need to install into a (seemingly) pretty stable concrete ceiling -- at least that's what I assume it is -- it sounds very solid when hit with a hammer, ...
0
votes
1answer
248 views

Best way to remove anchors from concrete?

The people we purchased our home from put up a wall in the 3 car garage between the 1st and 2nd space, but never finished it and I am now looking to remove the entire wall. There are several ...
2
votes
1answer
271 views

What masonry anchor should I use to install both window boxes and shutters into brick?

I have a brick house and my wife and I want to install plastic shutters and wooden window boxes on some windows. I know that the shutters will not be heavy load bearers, but the windows boxes will be ...
2
votes
1answer
381 views

How can I secure a wall-mount server rack?

I would like to install a 2-Post 12U wall-mounted server rack in my utility closet. The rack will hold up to 200lbs. However, my equipment will be just under 180lbs. Most of the weight will be at the ...
2
votes
2answers
294 views

How to remove a brass concrete anchor?

I have brass anchors like below in the concrete deck around my pool. Today, when I was raising the inner screw to install the cover, the screw was being very difficult. Trying to raise it, the inner ...
0
votes
1answer
205 views

Installing a Bench in Garden

I'm looking at two options to cement a bench. 1) I dig the 3 foot hole, pour cement...etc 2) I use a cement anchor. How does the cement anchor work? Is it as follows: create a mound of cement that ...
5
votes
5answers
14k views

What's the best way to remove a wall plug?

I use wall plugs a lot for putting screws into brick walls. It's easy to get the screw out when you want to remove them and usually you can loosen the screw a bit and pull and then both the wall plug ...
0
votes
2answers
683 views

How to attach a new sill to an existing concrete foundation

I have a foundation of block wall. To get it to the correct height I need to put 4" solid block top cap on it and my sill plate on top of the 4" solid top cap. I can fill in the voids in the block ...
0
votes
1answer
235 views

Can you “extend” a drywall stud?

I installed shelves in a closet with unevenly spaced studs. The shelves are mounted to the studs and they are level and secure. The shelve mounts can support a clothes hanging bar. The bar has holes ...
2
votes
1answer
4k views

How wide does a 6x6 concrete post footing needs to be?

Need to attach 6x6x8 posts for a free-standing pergola - I'll use Strong-Tie anchors attached to the concrete footing. The hole for the footing will reach well below the freezing line, but how wide ...
2
votes
2answers
1k views

How to fix over-tightened metal drywall anchor?

I was installing a metal drywall anchor for the first time, and accidentally over tightened it. Now it isn't tight on the wall, and is unusable. I can not remove the screw from the wall, and am ...
1
vote
1answer
454 views

How to attach a bar in a doorframe

For a homemade fitness equipment I need to attach a bar to a door frame without using screws or modifying/damaging the doorframe. The only idea I had was to use a pullup bar which one can clamp into ...
0
votes
2answers
181 views

What is/are the proper method and tools for drilling into masonry?

Related to this question, The blinds project has gone pretty smooth up until this point. It seems that some walls have plaster or masonry behind them. Probably not a big deal, but I've snapped a ...
2
votes
3answers
2k views

Re-anchoring in existing (failed) anchor holes in brick

I've had a shelf come free from the wall on which it was anchored. The shelf is fairly deep (~2') and solid wood, so it's heavy, and it's meant to take some weight (think like a breakfast bar). The ...
1
vote
1answer
559 views

How to secure bookcase to drywall right over concrete without drilling concrete?

I got some tall bookcases and want to set them up against a wall in a condo. The wall is shared with my neighbor and as such it seems to be a half inch drywall right over a concrete wall, so I don't ...