Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I'd like to construct a case out of PVC schedule-40 bits and pieces. The case is for a rifle-cleaning rod that I want to keep from getting bent/scraped. I'll need to connect schedule-40 pipe to caps/adapters/plugs/etc.

Is there something else I can use for the cement other than the traditional PVC primer and cement?

I'm too cheap to want to spend $15 on a can of each, as I'm unlikely to use them again in the future. I'm hoping that I could use super glue or epoxy or something common, as I don't need this contraption to hold up under water pressure.

share|improve this question
1  
I have definitely seen smaller cans available for ~$6, if that helps your decision any. Another option is to use ABS instead of PVC, and you can just glue it without using primer. –  gregmac Oct 22 '11 at 19:14
add comment

2 Answers

up vote 2 down vote accepted

Depending on how strong you want the joints, you could just push them together and leave it unglued. I've done this to create poster tubes out of 3" PVC which went through airport baggage handling just fine. PVC fittings are tapered on the inside, so the further in the pipe goes the stronger it will naturally hold.

If you want to use some glue, anything which will hold non-porous surfaces should work.

share|improve this answer
add comment

You should be able to find smaller/cheaper containers of glue. You can definitely skip the primer for this application, using the PVC cement by itself will be plenty.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.