Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I recently purchased a home, and it appears that the hardwood floors had a very thin and/or cheap top coat of finish applied to make them shiny with minimal effort.

If I slide ANYTHING (even say a kitchen chair with plastic slider feet) across it a thin layer of material comes off and the floor looks less shiny in that area.

I guess this is a two part question:

1 - Is this a known practice? Is there a way to check for it before buying a house?

2 - Is there a workaround for this besides refinishing the entire floor?

share|improve this question
3  
Is it perhaps wax? If so, wax stripper should take it off. –  DA01 Sep 12 '11 at 17:14
    
@DA01- how can I tell? –  JNK Sep 12 '11 at 17:16
1  
See the answer at the bottom of this page for "If I buy a home with hardwood floors, how can I tell if they have a wax or urethane finish?" residentialfloors.com/faqs.html –  auujay Sep 12 '11 at 17:47
    
So it comes up easily with a fingernail BUT it's clear like the urethane. Any ideas? –  JNK Sep 12 '11 at 18:12
1  
Maybe cheap/old urethane finish? Or maybe the last person put a urethane finish over a waxed floor so it did not bond well? –  auujay Sep 12 '11 at 19:25

1 Answer 1

up vote 5 down vote accepted

There could be a few different reasons for your situation. I would lean towards the theory that only one coat of finish, urethane or maybe varnish was applied to a poorly prepared surface. I'm afraid there is not quick fix to your problem. I would be looking at stripping and sanding the entire floor, clean away every spec of dust and refinish with at least 3 coats of high grade urethane. The surface MUST be lightly buff sanded and cleaned between each coat to give you a professional looking finish. It is a lot of work, but the results will be worth it.

share|improve this answer
    
Thanks for the answer, even if it's not what I want to hear :) I came to the conclusion last night that they probably just put a quick coat of thin urethane on without prepping, which makes sense. It's on the todo list now! –  JNK Sep 13 '11 at 12:07

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.