Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

The legs' length is adjustable, each leg is connected to the desk by means of a plate with 4 screws on the perimeter. I want to lower the table's front legs so the table becomes slanted. I would like to be able to adjust the slant degree so placing wedges between the legs and the desk does not help me. I've been thinking on adding some kind of bearing between the desk and the legs but haven't found any bearing that would enable me to do that. Any suggestions?

share|improve this question
add comment

1 Answer 1

I would use a hinge on each leg as the attachment, with the hinge facing forward. You want something reasonably tight so it doesn't shake the desk around.

You'll probably have to put a wood block on top of the legs, so that the legs and hinge both have something to attach to.

enter image description here

share|improve this answer
    
Constrain that sucker into a four bar linkage so it's only got one degree of freedom. A hinged cross-piece that's parallel to the tabletop should be placed between the legs. Otherwise it will be unstable. Good concept idea to get things rolling though. –  Doresoom Sep 8 '11 at 22:55
    
Greg, thanks. I'll do that and use a crosspiece for the legs as @Doresoom said. –  Noam N. Kremen Sep 10 '11 at 7:30
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.