Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I drilled holes for drywall anchors too wide - so now the anchor and the screw is loose. How do I fix this?

share|improve this question
add comment

2 Answers

up vote 7 down vote accepted

This is very complicated, and I'm hoping that you'll stick through all of the steps with me. ;)

  1. Go to the store.
  2. Get bigger anchors.
  3. Return home and install bigger anchors.

(No, really, that's the answer. You can't patch the drywall and put anchors in; the most you could hope for would be re-drilling holes near to your anchor, but you really risk cracking the drywall if you do that. I'd just get bigger anchors.)

share|improve this answer
    
Sound advice and good comedy all in one. Love it! :D –  The Evil Greebo Sep 5 '11 at 17:24
add comment

You could switch to a toggle anchor. It requires a larger hole to install because the wings need to pass through, but it will hold much better than a plastic anchor.

They won't work if you need the screw head to protrude from the wall (to hang a picture wire, for example) because you screw it all the way down so the wings are pressed against the inside of the wall.

That said, If I need to hang a fixture, and I can use a toggle instead of the plastic anchors that came with it, I'll discard the plastic anchors and use a toggle anchor.

toggle anchor

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.