Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

The water dispenser on my refrigerator sticks when you press it in. Sometimes it pops right out, and sometimes it stays in for 10-15 seconds. I've taken it apart a couple of times, cleaned it out, and tried spraying lithium grease and Liquid Wrench "Dry Lubricant" in there. Both work for a few weeks, then it starts sticking again, and gets worse over time.

The switch is a little plastic wedge that slides inside a plastic opening. Any tips?

share|improve this question
    
are you talking about the electrical switch? –  longneck Aug 12 '11 at 15:07
    
It's the switch that opens up the water valve when you press your cup against it. –  chrispix Aug 12 '11 at 15:52
add comment

2 Answers 2

up vote 1 down vote accepted

If it's entirely a mechanical valve, then use food-safe silicone grease. If it still sticks, you can just replace it.

If it's an electrical switch that opens a solenoid on a water valve, then you should just replace the switch.

I've had really good luck getting replacement parts and advice from http://www.repairclinic.com

share|improve this answer
    
Thanks, I used some silicone grease and it's working great. I'll update the thread in a few months when I see how it holds up. –  chrispix Aug 15 '11 at 6:44
add comment

You could try silicone grease. It's usually used to lubricate O-rings. It's food safe. You can buy a small container at the home store for a few dollars.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.