Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

Today I noticed that the gasket seal surrounding the refrigerator door has a bit of a gap along the lower quarter of the door. The photo below shows my refrigerator door - notice how the white gasket is flush with the refrigerator from the top down to about six inches below the bottom of the door handle, but then there is a gap that starts to grow and runs down to the end of the door.

Gap in the refrigerator door insulation.

How would I go about fixing this gap? Do I need to buy a new strip of the door gasket and replace the existing one?

share|improve this question

1 Answer 1

up vote 2 down vote accepted

Measure the space between the door and refrigerator on all sides/corners to see if something is out of alignment. One of the steps in replacing most gaskets is to fix the alignment of the door before tightening the screws. To fix the alignment, you would loosen the gasket screws, push or pull the top and bottom corners of the door until it's properly aligned, and retighten the gasket screws.

See these instructions on the steps to replace a gasket to get a better idea of the steps involved.

share|improve this answer
    
I don't think that's the problem. With the door open the insulation is clearly "squished" where the gap is. It does not extend as far out as the insulation above. –  Scott Mitchell Jul 24 '11 at 15:34
    
In that case, you'll likely have to replace the entire gasket. Here are some sample instructions that will put you on the right path, but review the instructions that come with the replacement seal: doorseal.com.au/fittingguides/d4-fitting-instructions –  BMitch Jul 24 '11 at 17:34
    
I broke down and called an appliance repairman. Your initial assessment was correct - he reseated the door and the gap no longer exists. –  Scott Mitchell Jul 25 '11 at 23:58

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.