I've been using a Beninca TWV remote (Shown below) to open my home garage door for the last 3/4 years without any problems, until this morning when the remote stopped working. To be clear I replaced the battery last night, which is the only thing I could imagine causing this.
I've found a few videos/articles online that show how to program a new remote using either the base unit/receiver or an existing working remote (My girlfriend's remote works fine). There is only a single red button on the board (Shown below) & two red LEDs (Most that I've seen online seem to have just one LED).
The advice that I followed was from the manufacturer's manual for the remote, which said I should press the "Program" or "PGR" button, press a button on the remote within 10 seconds, wait 10 seconds and the remote should be working. I've tried that a few times but it's not working.
I will try to program using my girlfriend's remote when she's back, but I just wanted to see if anyone had any advice as to how I should proceed & if anyone recognized the board shown below.
Thanks in advance.