Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

To seal the seam between a doubled joist or beam, what type of caulking is best? The Home Depot Decks 123 book recommends Alex Plus (acrylic latex plus silicone) while a guy at Home Depot suggested Mono Ultra Exterior (latex). How about Blueskin?

I initially used Alex Plus, it rained before the caulk cured, the caulk became a shriveled and cracked mess, I scraped it and replaced it with Mono Ultra Exterior.

share|improve this question
add comment

1 Answer

up vote 2 down vote accepted

Maybe I'm just sloppy, but I've never bothered to caulk the seam on a doubled up joist with treated wood.

There was one time I felt I needed to worry about that, but that was with a cantilevered deck using untreated wood. In that case I just used aluminum flashing over the top of the joists.

I suppose if I were going to caulk it though, I would use a silicone caulk over a latex caulk since they generally adhere and hold up to water better (cleanup is messier, but it's a deck, so it probably doesn't matter).

share|improve this answer
    
+1 For the aluminum flashing. I didn't mention it, but I actually ended up using Blueskin on one of the doubled up joists, essentially covering the seam instead of caulking it. I'll wait a bit more to see if there any other acrylic vs. silicone comments before accepting yours as the answer... –  Ates Goral Aug 3 '10 at 15:41
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.