What can soak up moisture from a closed space

Question

I have a really weird problem. I have a bedroom wall where the paint kept bubbling and peeling off. I have re-textured and painted it several times. I finally ripped all the drywall off and discovered that there is a large space behind the wall that has all the plumbing for two adjacent showers. The problem is that those pipes changing temperatures are causing enough moisture to build up in the space that the adjacent drywall gets wet and will not hold texture and paint. I checked for any leaks because it seemed weird to have that much moisture from the existence of pipes.

The question is: Is there anything that I can put in there when I close it back up to reduce the moisture? Would a vent work? A piano dehumidifier? A combination of the two? I would rather not have a random thing plugged into the wall.

EDIT: There are some really good answers so far, but I think I need to better explain. Here is the set up:

I tried spraying down the roof and looking for leaks. I tried turning all showers and flushing all toilets. There is no water coming from anywhere. The vents go straight to the roof. There is some insulation in there so I hate to just put an HVAC return register on it, but that and insulating the pipes looks like the only option.

Answer 1

I'd be surprised that you'd have this much moisture from condensation, especially since condensation doesn't change the net moisture level, it's actually removing moisture from the air. Double check for leaks, signs of corrosion on pipes, particularly at the joints, for caulk that is cracking in the showers, and the drain pipes.

Edit: One more thought, check where the bathroom vents are blowing. It should be outside, but a lazy installer may have them venting into this space.

That said, without knowing more about the floor plan and what's above and below this space, it's hard to give a good suggestion, so I'll give several:

• While you've got the opening in the wall, consider turning it into an access panel to more easily get to the plumbing in the future. This can just be a few pieces of trim that are attached over the joint between the wall and cutout drywall.

• If you want a vent in the wall, you can put in a simple hvac return grill. That could also double as an access panel.

• Insulate the pipes to prevent the air from interacting with the cold pipe and to reduce loss from the hot pipe.

• If there's an exterior wall involved, check the insulation and make sure the vapor barrier (paper on fiberglass) is intact.

• If you redo the entire wall, use moisture resistant wall board (green board may be more than enough, but they make stuff that's even more resistant). You can also install an extra vapor barrier behind this.

Answer 2

You could try lagging the pipes - both hot and cold. This should keep the temperature in the space more constant and therefore reduce the build up of condensation.

Another thing to try is to put a second wall between your bedroom wall and the shower pipes. Again the goal here is to keep the temperature behind your bedroom wall more constant and less humid. This would mean that your access to the pipes would be more difficult.