Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

My master bedroom has a set of French doors with a window above the doors. During a recent thunderstorm, I noticed the window was rattling. Upon further inspection, the window is held in with little strips of wood at the top, left and right, but not the bottom. there is also nothing sealing the gap between the glass and the frame/wood.

I'm going to remove the strips and the glass this weekend and reinstall it properly. My question is: what type of product should I use to seal the glass in the frame?

share|improve this question
add comment

2 Answers

up vote 6 down vote accepted

You'll want to use glazing compound, which comes in both oil-based, and latex, and can be found in both cans or tubes.

Once you have the glass removed, and the frame cleaned up.

  • Run a bead of glazing compound around the frame (where the glass will sit).
  • Set the glass in the compound giving it a little wiggle to work out any air bubbles, and to make sure the glass is set in properly (don't worry about a little excess oozing out, you can trim it off later when it cures).
  • Using a putty knife push in glazing points every 6-8 in.

Glazing point

  • Install the interior trim, and wait for the glazing compound to cure.

  • Once the compound has cured enough (24-72 hours), using a utility knife carefully trim off any compound that has oozed out.

  • If you are not using interior trim, you will want to apply a bead of glazing compound to the interior side of the frame, and use a putty knife to smooth it to a nice finish.

  • After 7-10 days you can paint the glazing compound to match the frame.
share|improve this answer
    
the removable trim is actually on the OUTSIDE of the window. does that make a difference? –  longneck Mar 11 '11 at 18:33
    
@longneck - Yes. in that case you will want to finish the outside with glazing compound, smoothing it at a 45 degree angle with a putty knife. You want to make sure water will not sit on the lip of the frame, so make sure the glazing compound bonds well to the glass and is angled to allow water to drain away. –  Tester101 Mar 11 '11 at 20:56
    
great answer, sounds like you have done some glazing.....I hate glazing....LOL +++ –  shirlock homes Mar 11 '11 at 21:48
    
@shirlock - does anybody like glazing? –  Tester101 Mar 13 '11 at 15:00
add comment

You should use putty to bed the glass into the frame.

This will form an air- and water-tight seal.

You could even put the wood strips back on.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.