Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I recently installed a new kitchen sink and faucet. It was one of those with the spot for a dish detergent pump.

After getting everything in, I come to find out there just isn't enough room to fit the bottle for the pump.

What I need to do is cut about 2 inches of wood that is about 1/2 inch thick, however, it's in a very awkward position.

Are there any suggestions on what I could use to cut?

share|improve this question
3  
A picture might help –  gregmac Mar 7 '11 at 21:01
    
@gregmac - I'll see want I can do. –  John Giotta Mar 7 '11 at 21:04

4 Answers 4

up vote 9 down vote accepted

Do you have enough room to use an electric drill with a 2" hole saw? If not, perhaps a Dremel or similar tool with a routing bit?

share|improve this answer
    
I do have enough room. I also have a Dremel. The hole saw might work, I was focused on something the that cut down or across and in. –  John Giotta Mar 7 '11 at 18:40

Like @Niall I would first recommend a Dremel tool (if you don't have one or can't borrow one, it's a sound investment for any DIYer's toolbox!).

Alternatively, a new oscillating tool by Bosch is made specifically for small, hard-to-reach jobs like this. You might want to check that out as well.

share|improve this answer
1  
I actually have a Dremel rotary and a multi-max (oscillating). The problem I had with the oscillating was I created more a friction fire than actual cutting LOL. I'll definitely try the routing bit. –  John Giotta Mar 7 '11 at 19:05

Keyhole saw might be your friend here. I actually have one where I broke MOST of the handle off so it fits smaller spaces :) For those in need, here is a picture of one: http://en.wikipedia.org/wiki/Keyhole_saw

share|improve this answer

If there's enough space to tap a hammer you could also try a chisel. I've found myself getting out the chisel now and then for tight situations.

share|improve this answer
    
A great "less power" solution. –  Tester101 Mar 19 '13 at 15:53
    
Unfortunately, there wasn't enough swing space for a hammer. –  John Giotta Mar 19 '13 at 16:03

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.