Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

While remodeling my basement, I had several walls where I just put up furring strips and foam insulation rather than framing in a "real" wall. I used 1x2 furring strips and attached them with a ramset and 1 1/2 inch nails.

Problem is, putting the nails through the furring strips would quite often cause them to crack. I tried pre-drilling (didn't really help) and also tried using 1x3 strips in some places (helped a little, but not much).

Is there some trick to nailing up furring strips to keep them from cracking on you?

share|improve this question

5 Answers 5

As an aside, remember that basement concrete walls are not watertight, so when the ground is wet, the interior concrete may get moisture on the inside. Furring strips directly against concrete is a good way to end up with wet wood, which means mold and rot. Same goes for where the basement floor meets the studs. Full framing an inch or so from the wall with foam insulation behind is better for keeping the finished wall dry, even though you'll lose some interior space.

share|improve this answer
    
That's why it's good to use pressure-treated furring strips. –  staticx Jul 28 '10 at 20:16

You may be using the wrong load. This site recommends using a Yellow #4 load on strips 3/4" thick, or Green #3 for 1/4" - 1/2".

You could also use concrete screws.

  • Pre-drill holes in furring strip and wall (about every 24").
  • Clean holes in walls well (with shop-vac).
  • Using concrete screws fasten furring strip to wall (do not over tighten).
share|improve this answer
    
Good thought, but I was using #3 loads. Concrete screws would probably work, but would take quite a bit longer to do. –  Eric Petroelje Jul 24 '10 at 2:52

Also look into using construction adhesive to attach the furring strips and then fewer masonry screws.

share|improve this answer
    
Yup, used adhesive as well, and only two nails per strip. Made sure to keep them away from the ends of the board as well. –  Eric Petroelje Jul 24 '10 at 2:57

I figured out a workaround for this. Today, rather than using actual furring strips, I just ripped a sheet of 3/4 inch plywood into strips on the table saw. Being plywood, it doesn't split. Not an ideal solution, but worked out pretty well for me.

share|improve this answer

When you hammer a nail through a strip of wood, the point of the nail splits and goes between the fibers of the wood. Instead, take each nail as you use it, put the head on a firm surface and tap the point once or twice with your hammer. This will flatten the point so that instead of splitting the fibers of the wood it cuts the fibers of the wood as it penetrates and is thus far less likely to crack the board.

share|improve this answer
3  
Interesting, seems like this would work in general, but would it work in my case with a ramset and cement nails? Seems like those nails are tough enough that pounding them with a hammer a few times wouldn't dull them much. –  Eric Petroelje Dec 14 '11 at 13:53

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.