Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

It seems whatever method I use I sometimes damage the wire and have to hope I have enough cable to have a 2nd try.

Is there a method that works 100% of the time for someone that is not doing it every day?


A possible duplicate has been pointed out, however it talks about 12/10 guage "Romex" rather then the normal 2.5mm twin and earth we have in the UK.

share|improve this question
    
Are you removing the outer sheath, or stripping the inner wires? –  Tester101 Jan 24 '11 at 13:08
    
Possible duplicate: diy.stackexchange.com/questions/3366/… –  Tester101 Jan 24 '11 at 13:08
    
@Tester, I wish to do both, but removing the outer sheath is the harder bit. –  Walker Jan 24 '11 at 13:11
    
This question has been asked before. Take a look at the answers to the question I linked to earlier, they should answer your question. –  Tester101 Jan 24 '11 at 13:36
3  
2.5mm T&E is very similar to 12/2 NM (non-metallic) cable. Romex is a brand name that has become synonymous with NM cable. –  Niall C. Jan 24 '11 at 15:45

2 Answers 2

up vote 1 down vote accepted

There are tools which do the job for you. They will probably take a little adjustment when first used, but then they're fine. They are literally the easiest way to consistently strip mains cable.

Many years ago my father had a hand-held tool explicitly for stripping Australian 240V household wiring cable. It had two clamps, two blades and a two-part action. The first clamped the cable and made the cuts, the second separated the clamps, neatly stripping the end off the cable.

(I should add that I don't strip cable every day but I learnt how to use a small but very sharp pen knife to strip outer sheaths. A bit time-consuming, but I like doing it that way as it works on any sort of multi-core cable. And the trick to not nipping the conductor is to not cut quite all the way through the insulation: let the stripping effort break the last little bit.)

share|improve this answer

I love this little guy from ideal:

ideal lil ripper stripper

the tool is a hollow tube. there's a hooked blade centered in the middle so that when you push the cable through the tool, it splits the sheath without damaging the conductors. the v-groove at the end is for stripping the individual conductors.

it took almost no time for me to learn to strip the inner conductors without nicking. and now i can strip without even looking at the wire.

share|improve this answer
    
will it strip the outer sheaths as well? –  Walker Jan 25 '11 at 15:41
    
Does anyone know if it is sold in the UK and if so what it is called in the UK? –  Walker Jan 25 '11 at 15:51
    
i don't know where to get one in the UK, but i can confirm that it strips the outer sheath. –  longneck Feb 2 '11 at 3:12

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.