Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a Trane XB80. I opened the panel yesterday to check the wiring inside, and then replaced it and turned it back on. I did not notice if it was working or not, but I suspect the fan did not come back on after I closed the panel.

Today, the fan is not blowing air. The compressor and pump are working, and the furnace also works (I tested it). However, the fan will not blow in any of the three modes.

What is wrong, and how do I fix it?

share|improve this question
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.