Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I was replacing an old ceiling register cover in my house but I found the screw hole on one side of the opening is kind of loose. Is there a way to patch up the mount point so the cover is fully supported?

share|improve this question
    
Does the cover attach to the register, or just into the drywall? What is it made of (wood, metal, plastic?) –  Niall C. Jan 20 '11 at 20:52
    
A picture might help. Also a better description of the problem might be good. Is the hole for the screw that holds up the grate too big for the screw? Is the screw into just drywall? Is there a drywall anchor for the screw to go into? –  Tester101 Jan 21 '11 at 17:15
add comment

2 Answers

You could probably squirt a bit of caulking or liquid nails in the hole to help tighten it up. Let it dry before putting the register back up.

share|improve this answer
add comment

Break the (non-ignition) end of a balsa-wood kitchen matchstick into the screw hole, then thread the screw into the hole. This will compress the matchstick and provide a snug fit for the screw.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.