Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

I have pulled up the carpet in my bedroom and got down to the plywood subfloor.

Do I have to prepare the plywood or lay anything down prior to placing the lengths of 3/4" oak flooring down (and nailing it of course)?

I want to make 100% sure the floor will not make noise at all, because this is a problem in other areas of the house. Since i am redoing the floors I want them perfectly quiet.

share|improve this question
up vote 9 down vote accepted

Yes indeed, prep is required and very important. First step is to renail or screw down the plywood subfloor. If you have a pneumatic frame nailer, you can use 2 1/2 inch threaded, ring nails (never use common nails), or alternately use 1 5/8 inch drywall screws. Install your nails or screws every 8 to 10 inches apart along each joist line with special attention to seams of the plywood. The importance of securing the subfloor well cannot be understated. The major cause of squeaky floors is drying or aging wood loosening around the nails, allowing them to move.

The second step is to lay a layer of building felt or rosin paper between the subfloor and new hardwood. Simply roll it out and staple it enough to hold it in place. This will assure that there is no wood on wood contact which can also result in squeaks.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.