Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have blinds on my new windows and the blinds are too long for the window opening. My guess is this is done to make them universal. How do you remove the excess and reattach the bottom?

share|improve this question
    
Need more info. Horizontal or vertical? Wood/fabric/aluminum? –  James Van Huis Jan 5 '11 at 16:48
    
@James: Faux Wood, vertical (Levolor brand) –  staticx Jan 6 '11 at 0:31
add comment

1 Answer

up vote 8 down vote accepted

If these are slatted miniblinds, each of the vertical strings goes down through the bottom rail and is held in place by a little button. Once you pop out those buttons with a small screwdriver, the strings are free and you can remove the bottom rail. Then you can un-thread the extra slats and re-thread the bottom rail back on, cut the strings and replace the buttons.

share|improve this answer
4  
Err on the side of leaving them too long; better to have one or two slats resting on the bottom rail than to have the whole thing too short and have a gap at the bottom. –  Niall C. Jan 5 '11 at 17:08
3  
Save your extra slats as well. Metal/vinyl blinds can get bends crimped in them that you can't remove. Wood/vinyl blinds can become brittle from the sun's UV rays and break. Much cheaper to replace one or two slats from spares than to replace the whole unit. A replacement slat will probably not quite match color-wise at first with the others since they'd have faded, but if it's put as the top or bottom slat, it'll likely be hard to notice. –  BQ. Jan 5 '11 at 18:17
    
I used these instructions but Mike's instructions were general enough to warrant answer acceptance. levolor.com/support/install/files/… –  staticx Jan 6 '11 at 14:02
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.