Tell me more ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.
up vote 5 down vote favorite
1

The light on my garage door opener keeps getting loose in the light socket, causing it to not work. Giving it a slight turn to tighten it fixes it temporarily, but it comes loose again within a week or so. I'm assuming it's the vibration of the opener that's causing the problem.

How can I prevent the lightbulb from coming loose in the socket?

share|improve this question

2 Answers

up vote 5 down vote

First unplug the opener. Now look in the light socket. See if the small metal tab at the bottom is nearly flat. Carefully pull it up a little bit so it applys more spring tension to the bulb. Also, they used to sell "rough service" Incandescent bulbs for openers, but I have had OK luck with compact fluorescents.

share|improve this answer
3  
Turn the power off before you do this, at the breaker. The switch is not enough - depending on how it's wired part of the socket may still be hot. The few seconds spent turning off the breaker is worth it to not be electrocuted. – gregmac Jan 5 '11 at 3:47
Don't worry about shutting off the breaker, if you unplug the Opener. I've never known an electrical charge to cross to the "unplugged" opener, unless it's in a cartoon or on Ghost Hunters! – David G. Dec 2 '12 at 21:27
Most openers are connected by a standard receptacle/plug, where David's comment is accurate. If yours is hardwired, then turn off the breaker, like gregmac says. – BMitch♦ Dec 2 '12 at 22:35
up vote 2 down vote

Try a different brand of light bulbs. Another brand might have a slightly larger base or have a little bit more friction to prevent the bulb from loosening due to the friction.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.