Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

After a downright frightening heating bill, I am thinking of switching to electric heat. I want this to be as little impact to the house as possible. I currently live in a 1100 sq ft manufactured home (mobile home... its a trailer) with a bedroom on each of the polls and a massive kitchen and living room area. My plan is:

  • A small space heater per bedroom

  • A baseboard heater for the kitchen livingroom area

My home has 100A line coming in with a 60A main breaker. The electrical is already heavily separated and my panel has enough room for two more 15A breakers. I do not have ready access to a 230V line. (I know enough not to do any work here myself)

Is there anything that I need to know before committing to this? Does anyone have any similar stories that can help me with this?

P.S. It may be worth noting that I currently pay $5.10/gal (!!) for propane and $0.08/kwh for electric. The current system is forced hot air.

UPDATE: I have equipped the main rooms with electric, oil-filled heaters. During the day they keep the house warm enough and at night our bedrooms are fine (the living room and kitchen suffer but I'm the only one who wakes up early enough to notice so moot point).

share|improve this question
Do the research and make sure you will be saving money. No sense spending money to change systems, only to find out you actually spend more. –  Tester101 Dec 30 '10 at 17:01

5 Answers 5

up vote 9 down vote accepted

You should consider a few conditions when deciding what is the most efficient (often cheapest) method for heating your home.

The Department of Energy site has some good resources about regional heating fuel costs.

Their heating fuel comparison calculator is a useful example: http://www.eia.doe.gov/ask/conversionequivalents_faqs.asp#compare_heating_fuels

Consider installation costs as well as operating costs. There are obviously some pretty efficient heating techniques (geothermal and solar) that unfortunately, still have extremely high installation costs. This often makes their installation untenable.

share|improve this answer
The energy calculator was wonderful. With it I roughed out about $20 per million btu for electric, $70 per million btu for propane. Geothermal is out because I don't own the land under me and I don't plan on being there long enough to recoup solar (solar electric) nor do I want to put holes in my roof/wall for additional duct work (solar heat). –  Bob Roberts Dec 30 '10 at 17:01

Consider putting your money in to conservation instead of new equipment. For example:

  • Turn down the thermostat. Dropping it a few degrees takes about 10% off your fuel usage.

  • Get a digital thermostat. It lets you set the temperature exactly where you want it, instead of guessing and over- or under-heating.

  • Get a programmable thermostat. You can let the house be cooler while you're sleeping under heavy covers, or while you're out during the day.

  • Insulate yourself. A wool underlayer doesn't affect your appearance or mobility, but makes your body warmer. I wear these pretty much all winter long:

http://www.rivbike.com/products/show/wool-semi-tights/22-271 Semi tights

  • Move around when you get cold, instead of turning up the heat.

  • Insulate the structure. Make sure the walls, floor, and ceiling all have insulation. There are limits (thickness of the walls, for example), but do what you can.

  • Reduce air infiltration. Air exchanges carry a lot of heat out of a house. Look for crevices that let air in/out. Maybe some weather stripping around the doors. Of course, you want to keep enough air moving to keep it healthy.

  • Insulate windows. A single pane of glass is only R-1. That's almost nothing. Even 3 panes of glass is only R-3 - a huge improvement, but still much lower than your walls probably are. Some options:

    • Replace with better windows. This is pretty expensive.

    • Put a layer of plastic on the inside or outside (or both sides!) of your windows. Even though they don't insulate much, they slow down convection over the surface of the glass.

    • Put up blinds and/or drapes and close them when the sun goes down.

    • Cut styrofoam insulation panels to the size and shape of your window frames. Insert them when the sun goes down. To make them look nice, cover in fabric.

share|improve this answer
Great ideas! It's also cheaper too. =) –  Mike B Dec 31 '10 at 6:04

Two 110-volt 15 A circuits would give you 15 A × 110 V = 3.3 kW of power. I think that's too little.

Here's my back-of-the-envelope calculation: I live in a house that's a little bigger than yours, but presumably better insulated, so let's assume they're equivalent. I use ~100 gallons of heating oil per month in the winter. A gallon of heating oil has 41 kWh of energy, so I use ~4100 kWh of energy per month. That's for heat and hot water. A month is 720 h long, so the average power is 5.7 kW. In reality I need more power than that, for more heat is needed at night and on particularly cold days.

How large is your propane tank, and what is the fastest you go through it in the winter?

share|improve this answer
We have 200gal, and between the most recent bill and the previous bill, used 130 gal in 90 days. There is only one heating zone. My house was built in 2004 and is reasonably well insulated –  Bob Roberts Dec 30 '10 at 19:51

Look at using a heat pump, as the give about 4 unit of heat for each unit of electric used, however they are not cheap.

ALso spending a bit on inproving your insulation may give a much better payback then spending the money on the heating side.

share|improve this answer
I don't believe I will go with the heat pump. I like the idea but I don't believe the payoff will come before before I move. I will be looking into my insulation though. –  Bob Roberts Dec 30 '10 at 19:58
That link is dead. Can you update it? –  Henry Jackson Nov 5 '12 at 0:00

I know of a person who uses two electrical oil-filled radiators with total output of 2,5 kW to heat a room in a 440 sq ft log house in a region where -10 Celsius is typical in winter. However, he only does so from late fall till early winter and from early spring till summer since it's a summer house and he lives in an apartment most of the time. He does so for three reasons - it's very clean, it doesn't need any manual labor to run and it can be left unattended for the workdays when he is in the city. He never brought up what he thinks of the prices but I guess he doesn't suffer much or he would complain otherwise.

My two cents are the following: First, electricity is safer when done right - gas equipment can leak gas and cause a devastating explosion. Second, try to keep at least part of the already installed equipment so that in case of a power outage you have a backup way to heat your house. With electricity you depend on the supplier heavily and once in a while even major cities experience days long blackouts.

share|improve this answer
Thank you for your answer. I will keep the current system only out of the fact that it has my AC built in and I need the propane for my stove/oven. If the power goes off though, my goose is cooked (or frozen perhaps) as the forced hot air requires a blower. –  Bob Roberts Dec 30 '10 at 16:29

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.