Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

We had a leak in our upstairs bathroom, about 2 weeks after we had a new ceiling put up and painted in the room below. It wasn't a major leak, but it caused quite a wide line to show up on the ceiling.

I've painted over the line 3 times now, but it just keeps reappearing, is there anything I can do to stop the water mark from showing up?

share|improve this question
add comment

5 Answers 5

up vote 9 down vote accepted

Stains will usually come right through a new coat of paint.

Did you prime it first? In my experience I've found that a good oil (or even better, shellac) based primer works best for keeping stains from bleeding through the paint.

share|improve this answer
    
I haven't tried a primer yet, I'll give that a go, see how it works out. Thanks. –  Jaymz Jul 21 '10 at 19:43
add comment

Leave it to dry thoroughly. This might take several weeks, I'm afraid.

Once dry, try an exterior-grade primer before two or three more coats of paint.

share|improve this answer
    
It's been a couple of months now since that happened, so it's definitely dry. I didn't use a primer though, so I'll give that a shot, thanks. –  Jaymz Jul 21 '10 at 19:42
    
+1 - using primer is the key to deal with moisture transmission - diy.stackexchange.com/questions/2797/… –  sharptooth Dec 21 '10 at 6:23
add comment

Use the expensive kilz primer then repaint. The oilbase spraypaint primer is also a good idea but don't over spray.

share|improve this answer
add comment

I have had good luck with the Kilz brand of primer, but I'm sure any quality stain hiding primer would work well.

share|improve this answer
add comment

We had massive leaks through our ceiling during a renovation. The ceiling had to be sealed first. Our painter mixed in 4 litres of sealant with the undercoat (again, massive leaks). Even this did not totally help - some stains still came through.

As the new stains came through, we sprayed them with a can version of the sealant (White King Stain Stop Sealer) then repainted the stains. That seems to have done it.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.