Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

We've just completed our first drywall project and the outcome wasn't so great in places. There are a couple spots in particular that have 1/2-1/4" gaps.

I was wondering, is there a nifty way to close these gaps or do we have to pull the panel down and try again if it is too bad? I don't think they just slathering mud in it will work?

share|improve this question

4 Answers 4

up vote 9 down vote accepted

Setting-type compound (the bagged kind you mix vs. the drying-type you buy premixed in a bucket) will easily fill a 1/2" gap without cracking. Make sure you load up the gap well before applying your tape, then finish it as you would any other joint.

Sadly I have a lot of experience filling this type of gap from my own basement project a few years ago...

share|improve this answer
There's a reason drywall tape is so wide. :) –  Niall C. Dec 10 '10 at 3:23
Thanks! I'll give it a try. –  javamonkey79 Dec 10 '10 at 6:59

I would probably take the panel down and try again.

Even if you used fiberglass mesh tape when you tape the joints, it'll be hard to finish the surface, and you're probably going to experience premature cracking, etc.

You could try filling in the gap with one of several materials:

  • foam backing rod (usually used for caulking large gaps)
  • expanding foam insulation
  • thin cut wood/plywood

But I'm not sure how the mud would dry over material like that. I'd imagine that it'll still be more prone to cracks than a tight gap. If you are going to try to fill the gap, a harder material would probably work better than a softer material like foam, simply because it would provide more support against bumps and scrapes.

share|improve this answer

I'd probably cut a small sliver of drywall and put it in the crack. Have to cut because it would be hard to snap a piece that small.

share|improve this answer
Have you done this before and had it work successfully? –  javamonkey79 Dec 11 '10 at 16:02
For small areas I have. Thinkinga bout it some more, if its the length of a whole sheet, I might think about taking down the panel and trying again. –  BrianK Dec 13 '10 at 0:35
I've done this for 1/2" gaps. Might take a few tries to cut it without it breaking up. –  sal Dec 17 '10 at 5:41

I've used Great-Stuff gap filler on dryway in a garage. These were 1/2" to 1 1/4" gaps, irregular in spacing and 2' to 5' long. Let it dry and you can cut down the excess. Expensive but quick and easy to use.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.